L 13 Fluids - 2 Fluid Statics: fluids at rest

Slides:



Advertisements
Similar presentations
L 13 Fluids [2]: Statics  fluids at rest
Advertisements

Chapter 12 Forces & Fluids.
The pressure is on Which is the best design for a dam? Explain your answer. Which dam is more likely to break? Explain your answer.
Chapter 3: Forces & Fluids Review. How can you change the pressure on the ground when you are standing?  Stand on one foot (decrease area)  Change into.
Liquids.
L-14 Fluids [3] Fluids at rest  Fluid Statics Fluids at rest  Fluid Statics Why things float  Archimedes’ Principle Fluids in Motion  Fluid Dynamics.
Static Fluids Fluids are substances, such as liquids and gases, that have no rigidity. A fluid lacks a fixed shape and assumes the shape of its container.
L12 - FLUIDS-1 liquids gases sand, snow, or grain (granular materials) FLUIDS  STUFF THAT FLOWS FLUIDS 1.
Fluids Physics 202 Professor Vogel (Professor Carkner’s notes, ed) Lecture 19.
Liquids.
Hydrostatics Fluids at Rest.
Floating and Sinking.
Floating and Sinking Think about this…
Static Fluids Fluids are substances, such as liquids and gases, that have no rigidity. A fluid lacks a fixed shape and assumes the shape of its container.
L12- FLUIDS [1]  liquids  gases  sand Matter  Comes in three states – solid, liquid, gas  So far we have only dealt with solid objects  blocks,
L-14 Fluids - 3 Fluids at rest  Fluid Statics
Density and Buoyancy.
Fluids Fluids flow – conform to shape of container –liquids OR gas.
L-14 Fluids [3] Fluids at rest Why things float  Archimedes’ Principle Fluids in Motion  Fluid Dynamics –Hydrodynamics –Aerodynamics.
Fluid Mechanics Ellen Akers. Fluids A fluid is a substance that has the ability to flow and change its shape. Gases and liquids are both fluids. Liquids.
L-14 Fluids [3]  Why things float  Fluids in Motion  Fluid Dynamics –Hydrodynamics –Aerodynamics.
Physical Science Unit: Forces in Fluids.
Any substance that can change shape or flow easily.
L-14 Fluids [3] Fluids in Motion  Fluid Dynamics HydrodynamicsAerodynamics.
Static Fluids.
Forces and Fluids.
A fluid is a state of matter in which the particles are free to move around one another. No definite shape exists. The term “fluid” encompasses liquids.
L 13 Fluids [2]: Statics  fluids at rest  More on fluids.  How can a steel boat float.  A ship can float in a cup of water!  Today’s weather Today’s.
L 13 Fluids [2]: Statics  fluids at rest  More on fluids at rest  How is atmospheric pressure measured?  Buoyancy: How can a steel boat float?
Fluids Unlike a solid, a fluid can flow. Fluids conform to the shape of the container in which it is put. Liquids are fluids the volume of which does not.
L 13 Fluids [2]: Statics  fluids at rest  More on fluids.  How can a steel boat float.  A ship can float in a cup of water!  Today’s weather Today’s.
Fluids 101 Chapter 10. Fluids Any material that flows and offers little resistance to changing its shape. –Liquids –Gases –Plasma?
Liquids -They always take the shape of their container -They flow or you can pour them.
Stuff that Flows L12- FLUIDS-1 liquids gases
Chapter 4: Forces and Fluids
CONCEPTUAL PHYSICS Liquids.
Floating and Sinking Think about this… How is possible for a huge ocean liner like the Titanic to float? How is possible in a few hours for it to become.
Chapter 7 Forces in Fluids.
L 13 Fluids [2]: Statics  fluids at rest  More on fluids.  How can a steel boat float.  A ship can float in a cup of water!  Today’s weather Today’s.
L-14 Fluids - 3 Fluids at rest  Fluid Statics
L 13 Fluids [2]: Fluid Statics  fluids at rest  More on fluids at rest  How is atmospheric pressure measured?  Buoyancy: How can a steel boat float?
L 13 Fluids [2]: Statics  fluids at rest  More on fluids at rest  How is atmospheric pressure measured?  Today’s weather Today’s weather Today’s weather.
S.N. P ATEL I NSTITUTE O F T ECHNOLOGY & R ESEARCH C ENTRE, U MRAKH Fluid Static and it’s application Guided by : Prof. Nirav Raykundaliya( Assistant.
Forces in Fluids PressureBouyancy Pascal’s Principle Bernoulli’s Principle.
Chapter 11 – Forces in Fluids. Pressure The amount of pressure you exert depends on the area over which you exert force. Pressure is equal to the force.
Lecture 16Purdue University, Physics 2201 Lecture 16 Fluids PHYSICS 220.
Fluids are substances that can flow. That means liquids and gases can flow so they are fluids.
Chapter 12: Forces and Fluids
L12- FLUIDS [1] Stuff that flows. liquids gases sand.
L 13 Fluids [2]: Statics  fluids at rest
L-14 Fluids [3] Fluids at rest Fluids in Motion  Fluid Dynamics
L12- FLUIDS [1] Stuff that flows liquids gases sand.
L 13 Fluids [2]: Fluid Statics: fluids at rest
L12- FLUIDS [1] Stuff that flows liquids gases sand.
L 13 Fluids [2]: Statics  fluids at rest
Static Fluids Fluid – any substance that takes the form of the container in which it is held. (gases and liquids)
Fluid Mechanics Presentation on FLUID STATICS BY Group:
L-14 Fluids - 3 Fluids at rest  Fluid Statics
L12- FLUIDS-1 Stuff that flows liquids gases sand.
Force In Fluids Chapter 11
Section 2 – pg 424 Floating and Sinking
L12- FLUIDS [1] Stuff that flows. liquids gases sand.
L-14 Fluids [3] Why things float Fluids in Motion  Fluid Dynamics
L-14 Fluids [3] Why things float Fluids in Motion  Fluid Dynamics
Physical Science Forces in Fluids.
L 13 Fluids [2]: Statics  fluids at rest
L 13 Fluids [2]: Statics  fluids at rest
L12- FLUIDS [1] Stuff that flows liquids gases sand.
L-14 Fluids [3] Why things float Fluids in Motion  Fluid Dynamics
Whatever floats your boat!
Presentation transcript:

L 13 Fluids - 2 Fluid Statics: fluids at rest More on fluids at rest How is atmospheric pressure measured? Buoyancy: How can a steel boat float?

Review: Pressure = force per unit area Example: A large rectangular box of mass 4.8 kg has dimensions of 2 m x 3 m x 4 m. What pressure would the box exert on the floor depending on which side it is set on? 3 m P = F/A  The force exerted by the box on the floor is equal to its weight w = m g = 4.8 kg x 10 m/s2 = 48 N. There are 3 possible values of the area A depending on which side rests on the floor: A1 = 2 m x 3 m = 6 m2 A2 = 2 m x 4 m = 8 m2 A3 = 3 m x 4 m = 12 m2. 2 m 4 m w = mg P1 = w/A1 = 48 N / 6 m2 = 8 N/m2 = 8 Pa P2 = w/A2 = 48 N / 8 m2 = 6 N/m2 = 6 Pa P3 = w/A3 = 48 N / 12 m2 = 4 N/m2 = 4 Pa

Pressure in a fluid increases with depth h The pressure at the surface is P0 = atmospheric pressure (1 atm)  105 N / m2 = 105 Pa Po = Patm Pressure at depth h: P(h) = Po + r g where r = density (kg/m3)  1000 kg/m3 for water r g h  1000 x 10 x h = 104 h The pressure increases with depth because the fluid is at rest and a given fluid layer must be supported by the fluid below it. h P(h)

DEMONSTRATION Since the pressure increases with depth, the speed of the water leaking from the bottom hole is larger than that from the higher ones. P1 P2 > P1 P3 > P2

Pressure depends only on depth P = Po = 1 atm  105 Pa 10 m P = Po + Po= 2 atm  2 x105 Pa 20 m 10 m P = Po + 2Po= 3 atm  3 x105 Pa All 3 objects experience same pressure

Pressure is always perpendicular to the surface of an object Pressure has the same value in all directions

Pascal’s Vases The fluid levels are the same in all each tube irrespective of their shape

Barometer measures atmospheric pressure Inverted closed tube filled with liquid The column of liquid is held up by the pressure of the liquid in the tank. Pliquid  PATM at surface,  the atmosphere holds the liquid up. PATM Pliquid

Barometric pressure Today’s Weather Atmospheric pressure can support a column of water 10.3 m high, or a column of mercury (which is 13.6 times as dense as water) 30 inches high  the mercury barometer

Pascal’s Principle If you apply pressure to an enclosed fluid, that pressure is transmitted equally to all parts of the fluid If I exert extra pressure on the fluid with a piston, the pressure in the fluid increases everywhere by that amount Cartesian diver W

Pascal’s Principle A change in pressure in an enclosed Fluid at rest is transmitted undiminished to all points in the fluid 1kg area 1 m2 area 5 m2 h W = 10 N W = 50 N 5 kg

A hydraulic car lift Pressure is F / A At the same depth the pressures are the same so F1 /A1 = F2 /A2, or with a little force you can lift a heavy object! the jack

Water pumps and drinking straws A ground level pump can only be used to cause water to rise to a certain maximum height since it uses atmospheric pressure to lift the water for deeper wells the pump must be located at the bottom When you use a straw, you create a vacuum in your mouth and atmospheric pressure pushes the liquid up

Pressure depends only on depth Dam The pressure at the bottom of the lake is higher than at the top The dam must be thicker at its base The pressure does not depend on how far back the lake extends

Blood Pressure Sphygmomanometer The blood pressure in your feet can be greater than the blood pressure in your head depending on whether a person is standing or reclining

Buoyancy – why things float TITANIC The trick is to keep the water on the outside, and avoid hitting icebergs (which also float), and are not easily seen, since 90% of it is submerged The hole in the Titanic hull was only about 1 m2

Buoyant Force submerged object that has a mass density ρO The density of the water is r PTopA F = P  A h PBottomA W

Buoyant force The water pushes down on the top of the object, and pushes up on the bottom of the object The difference between the upward force and the downward force is the buoyant force FB since the pressure is larger on the bottom the buoyant force is UPWARD There is a buoyant force even if the object does not float

Archimedes’ principle  The buoyant force on an object in a fluid equals the weight of the fluid which it displaces.  Any solid object less dense than water will float in water  water weighs 10 N/liter  each liter of displaced water provides 10 N of buoyant force this works for objects in water helium balloons (density of He = 0.18 kg/m3) hot air balloons  the density of hot air is lower than the density of cool air so the weight of the cool air that is displaced is larger than the weight of the balloon

Will it float? The object will float if the buoyant force is enough to support the object’s weight The object will displace just enough water so that the buoyant force = its weight If it displaces as much water as possible and this does not match its weight, it will sink. Objects that have a density less than water will always float in water, e.g., oil A steel bolt will float in mercury (r = 13.6 g/cm3)

Floating objects lighter object heavier object

Oil Tankers empty tanker full tanker

example problem An object having a volume of 6 liters and weighing W = 30 N is placed in a tank of water. What will happen? Will it sink? Will it float? What fraction of its volume will be submerged if it floats? If the object were completely submerged, the buoyant force would be FB, max = 10N/liter x 6 liters = 60 N thus, the object will float with half of its volume submerged, so that FB = W = 30 N W FB

Floating in a cup of water Only a thin layer of water around the hull is needed for the ship to float!