MPI/ATLAS 15.7.02H.-G. Moser MPI, Munich Detector Status Delivered: 86% IV measured: 58% + Visual insp.: 39% fail : ~5%

Slides:

Advertisements

Similar presentations

Preparation for ATLAS SCT/ID Endcap Completion at CERN Jo Pater Manchester, 4 January 2006.

Advertisements

Technical Board, 12 July 2005Børge Svane Nielsen, NBI1 Status of the FMD Børge Svane Nielsen Niels Bohr Institute.

ATLAS SCT Endcap Detector Modules Lutz Feld University of Freiburg for the ATLAS SCT Collaboration Vertex m.

ATLAS SCT Barrel PARM. Tyndel 114-May-2003 ATLAS SCT Barrel PAR - Introduction uOver-view of the Barrel SCT Õ Modules Õ LM tapes & optical harnesses Õ.

H.-G. Moser, Max-Planck-Institut für Physik, Munich1 Beauty03, October 2003 The Status of the ATLAS Inner Detector Hans-Günther Moser for the ATLAS Collaboration.

Spine team meeting 23/01/2001H.-G. Moser MPI, Munich Agenda/Topics 1) IHEP pre-series 2) Bias Contact 3) Straight Split. 4) Design variations and improvements.

LHC SPS PS. 46 m 22 m A Toroidal LHC ApparatuS - ATLAS As large as the CERN main bulding.

Didier Ferrère, Geneva University Como, October The Construction Status of the ATLAS Silicon Microstrip Tracker D. Ferrère on behalf of the SCT.

Opto Harness FDR 19/10/01 T. Weidberg1 Opto Harness FDR Scope and aims of review, system overview Available documentation Status of Project & Schedule.

LHCC referees meeting, 10 October 2005Børge Svane Nielsen, NBI1 Status of the FMD LHCC referees meeting, 10 October 2005 Børge Svane Nielsen Niels Bohr.

Module Production for The ATLAS Silicon Tracker (SCT) The SCT requirements: Hermetic lightweight tracker. 4 space-points detection up to pseudo rapidity.

S Temple CLRC1 End-cap Mechanics FDR Cooling Structures Steve Temple, RAL 1 November 2001.

Prepared by M. Tyndel, ATLAS Plenary Jun ATLAS ID - SCT Status Report Highlights from SCT week Valencia June uProcurement of sensors & FE ASICs.

Experimental Beampipes: Status and Outlook Ray Veness / AT-VAC For the beampipe team With many thanks to the experiment’s installation and coordination.

Silicon Inner Layer Sensor PRR, 8 August G. Ginther Update on the D0 Run IIb Silicon Upgrade for the Inner Layer Sensor PRR 8 August 03 George Ginther.

Evaporative Heater Design, qualification and planning M.Olcese PRR SCT off-detector cooling PRR SCT off-detector cooling March March 2005.

SCT Week -CERN- September 23, Defective ASIC’s A. Ciocio - LBNL.

S. Zelepoukine CMS Electronics Status Report: ECAL Detector Control System S. Zelepoukine IHEP Protvino/ETHZ

Concluding Summary WBS1.1.2 SCT Subsystem A. Seiden BNL March 2001.

The ATLAS SemiConductor Tracker Abstract The ATLAS SemiConductor Tracker (SCT) is presented. About silicon micro-strip sensors with a total active.

Silicon Meeting July 10, 2003 Module and Stave Production Status James Fast Fermilab.

1 US Pixel Mechanics Role Global support structureIntermediate support structureLocal support structure Stave SectorDisk Barrel x (9-11) x5 x (22,40,56)

1st Nov 2001 Nigel Hessey SCT Endcap Structures FDR1 Endcap Requirements Brief overview of SCT Endcap Requirements layout, X0, thermal, positioning, stability.

Abe Seiden December 2003 SCT Week S USA SCT Barrel Module Assembly SCT Week CERN December 2003 Presented by Abe Seiden U.C. Santa Cruz.

SCT Week 2 Oct 2002N.P. Hessey NIKHEF1 Status ATLAS SCT 2002 NIKHEF Contributions to ATLAS: Magnets – discussed by Frank Trigger DCS Muon MDT and alignment.

M. Gilchriese - April 2001 Disk Sector Status. M. Gilchriese - April Technical Status Three prototypes to current dimensions(8-sector disks) except.

8 July 1999A. Peisert, N. Zamiatin1 Silicon Detectors Status Anna Peisert, Cern Nikolai Zamiatin, JINR Plan Design R&D results Specifications Status of.

The RPC Closed loop Gas System Slides from Bianco and Guida.

Endcap Module Status Agreed Responsibilities Overall Production UK Situation Global Schedule Issues General Production Issues.

ATLAS PIXEL SYSTEM OVERVIEW M. Gilchriese Lawrence Berkeley National Laboratory March 11, 1999.

Mechatronics Task Force, 26-nov-02 Olivier Teller, CERN EP-CMA1 Cooling Mechatronics Schedule.

Status of Glasgow module production Richard Bates The University of Glasgow K.Smith, R. Bates, A. Cheplakov, V. O’Shea W. Bell, J. Melone, F. Doherty,

Neil JacksonUK-V RAL 8th September Module to Disc Assembly Infrastructure –Services and test box –Evaporative cooling system –Disc Handling Tests.

Ronald Lipton Layer 0 Status PMG Sep Status of the Layer 0 Project – emphasis on hardware status, preproduction, and preparations for shutdown work.

Anatoli Romaniouk TRT Introduction TRT in ATLAS p. 2-4TRT in ATLAS p. 2-4 TRT design p. 5-7TRT design p. 5-7 TRT operation principles p. 8-9TRT operation.

UK ATLAS SCT Module Quality Assurance Joe Foster, Manchester University 04 Jan 2005 All results compiled in time for Christmas…

Hybrid Mechanical/Thermal Design Ray Thompson / Manchester FP420 meeting Torino 11/12 July 06.

Peter Kodyš, SCT Week Valencia, Juni 13, Charles University.

Neil Jackson University of Liverpool Hiroshima Symposium June THE ATLAS SEMICONDUCTOR TRACKER (SCT) A PRESENTATION ON BEHALF OF THE ATLAS.

Meeting with TUM 1/5/2016P. Petagna – LHC Detector Upgrades: Cooling Visit of the President of the Munich Technical University LHC DETECTOR UPGRADES: COOLING.

D. Greenfield CLRC1 End-cap Engineering Status Report Debbie Greenfield, RAL UK-V 30 October 2002.

1 The ATLAS SemiConductor Tracker commissioning at SR1 APS and JPS joint conference October 30, 2006 Ryuichi Takashima （ Kyoto Univ. of Education ） For.

D. Greenfield CLRC1 UK-V End-cap Engineering 15 July 2003 Debbie Greenfield, RAL.

1 HBD: Update and Schedule Itzhak Tserruya DC Meeting, BNL, April 13, 2005 Outline:  Full scale prototype status  Light source test  Construction Schedule.

M. TYNDEL 1 LHCC Interactions May 2003 ATLAS SCT SCT Production Status ‘Snap-shot’ of the status of the SCT production (May 2003) 1. Barrel Modules 2.

Status of the ATLAS ID Evaporative cooling system JCOV 25 Nov P. Bonneau TS/CV/Detector Cooling CONTENTS Overall statusOverall status Cooling plant.

A.Cheremukhin (JINR, Dubna) CMS Preshower PRR, July 5-6, 2001, CERN1 Micro-module assembly -  -module elements - alignment of the silicon sensors to the.

Valencia Report 5 Pre-qualification (2 mechanical + 3 electrical) All inside mechanical specification in XY after assembled. However, Pre3-Pre5 bad planarity.

Upgrade PO M. Tyndel, MIWG Review plans p1 Nov 1 st, CERN Module integration Review – Decision process  Information will be gathered for each concept.

August 04 Jason Tarrant CCLRC1 SCE EC Design & Manufacture l Progress of SCT EC »Support Structure (Required for Disc Assembly 2004) »Services (Required.

RD program on hybrids & Interconnects Background & motivation At sLHC the luminosity will increase by a factor 10 The physics requirement on the tracker.

Eric Vigeolas, July the 3 rd Status The IBL detector construction already started and the components assembly (flex, modules, stave loagin) will.

Mathias Reinecke CALICE week - Manchester Electronics Integration - Status Mathias Reinecke for the AHCAL developers.

Steinar Stapnes, LHCC June The ATLAS inner detector TRT endcap A+B TRT endcap C TRT barrel SCT barrel SCT endcap Pixels uWhole ID sits inside bore.

PXD ASIC review, October 2014 ASIC Review 1 H-.G. Moser, 18 th B2GM, June 2014 Date and Location MPP, October 27, 10:00 – October 28, 16:00, Room 313 Reviewers:

SVD Status Markus Friedl (HEPHY Vienna) SVD-PXD Göttingen, 25 September 2012.

QCG Report Francesco Forti University and INFN, Pisa.

NSW SG 10 Dec Nov 2014 S. Zimmermann, NSW SG 1.

1 End-cap Module Electrical Specs. And Performance C. Lacasta + J. Pater, R. Bates, J. Bernabeu, P. Dervan, A. Greenall, C. Ketterer, J.E. Garcia, G. Moorhead,

Schedule 24 September 2012 Christian Irmler (HEPHY Vienna) Joint PXD and SVD Meeting Göttingen.

Atlas SemiConductor Tracker final integration and commissioning Andrée Robichaud-Véronneau Université de Genève on behalf of the Atlas SCT collaboration.

Performance and operation of the ATLAS Semi Conductor Tracker (SCT) Paul Dervan The University of Liverpool, UK on behalf of the ATLAS SCT Collaboration.

Testsystems PXD6 - testing plans overview - by Jelena NINKOVIC Hybrid Boards for PXD6 - by Christian KOFFMANE Source measurements on DEPFET matrices using.

Module Loading Task Force Meeting October 21, 2004

MODULE QUALIFICATION STATUS AT LIVERPOOL

End-cap Mechanics FDR Overview of the Project

CALICE: Thermal, Mechanical and Assembly issues

PXD Summary Tests PXD9 Pilot Production ASICs Components Plans:

SCT On-detector VCSELs

Tests of Endcap capillary & Heat exchangers at CERN

Presentation transcript:

MPI/ATLAS H.-G. Moser MPI, Munich Detector Status Delivered: 86% IV measured: 58% + Visual insp.: 39% fail : ~5%

MPI/ATLAS H.-G. Moser MPI, Munich Assembly Status at MPI 6 mechanical dummy modules made 1 midxf: mm (tolerance 0.01 mm) 2Ok 3Midxf: mm (tolerance 0.01 mm) 4Midxf: mm (tolerance 0.01 mm) 5Ok 6Midxf: mm (tolerance mm) Problem identified, improved fixation mechanism needed

MPI/ATLAS H.-G. Moser MPI, Munich Module Assembly

MPI/ATLAS H.-G. Moser MPI, Munich Endcap Module Status K5 works: stable, no oscillations Original plan: FDR in July 2002, PRR: October, Production start in 2003 (21 months) However, two new problems showed up: - high noise after irradiation - poor performance of cooling system

MPI/ATLAS H.-G. Moser MPI, Munich K5 Status –All modules are stable –New K5 hybrid 7 measured in testbeam 6 measured in system test 2 irradiated –K5 modules were built rapidly & reliably inside mechanical specs. –Electrical performance is within specification pre-irradiation –Measure the same performance in the lab and in system test ( without noise injection zProblems with the stability of the EC module have been fixed. z16 modules (outer, middle, inner) have been built & measured in 5 sites

MPI/ATLAS H.-G. Moser MPI, Munich Unirradiated Modules

MPI/ATLAS H.-G. Moser MPI, Munich Irradiated Modules 2 outer modules irradiated in May, annealed for 6days at RT and then measured in the testbeam First results do not meet specification: –Post irradiation gain is low ~30mV/fC –Median charge collected is low ~ 2.7fC –Noise is high ENC~2300e –Specification: < 1900e Results are preliminary & will be checked before FDR; 2 more modules will be irradiated Perhaps problem with pre-series ASICs (from corner run)

MPI/ATLAS H.-G. Moser MPI, Munich Thermal Performance 3 modules thermally cycled: no significant change in mechanical or electrical properties Reproducibility of grease contact checked on 4 modules First thermal measurements on 1 middle and 1 inner module (non- irradiated.) agree with simulation at 10% level First measurement of CC blocks on CuNi pipe and evaporative cooling show that this requires coolant at –24°C Specification: coolant at –21°C Work needed to improve CC blocks

MPI/ATLAS H.-G. Moser MPI, Munich Plans for FDR/PRR Valencia SCT week: FDR should be delayed, combined FDR/PRR in October when open issues are resolved However, in the IB this was discussed: - very negative message to ATLAS (milestone missed) - further delays probable Endcap community was encouraged to keep to original schedule FDR will be August 6 (exclude post irradiation and thermal issues) Open issues should be resolved till PRR in October Continue prototyping, tests, qualification (material for 100 moduels ordered Start tender procedures