How To Install a Centrifugal Water Pump

Installation Process First of all, consult the manual book to determine the right process of installation

Make Base Plate Inspection

Check the Pump Impeller, it can be turned by hand

If it cannot be turned, open the pump casing to look for obstructions

Turn the shaft clockwise by using a deep socket wrench on the Impeller nut

Open all the body parts of centrifugal pumps and clean them properly

Clean out any corrosion build up on the impeller Clean out any corrosion build up on the impeller

If necessary, coat the underside of the base plate to prevent the rust

Pump Installation Place Locate the pump near to the water source

Adequate Space For Operation, Inspection And Maintenance

Base Plate Pumps Foundation Grouted on a concrete foundation, which has been poured on a solid footing

Ensure Solid Foundation So that it will be able to absorb any vibration Able to provide a rigid and permanent support for the pumping Unit Use good quality suction hose that will not be collapsed by suction So that it will be able to absorb any vibration Able to provide a rigid and permanent support for the pumping Unit Use good quality suction hose that will not be collapsed by suction

Check all fittings and connections in the suction line for tightness

Tools Required For Installation Hammer Worm gear saw with diamond blade Rebar cutters Concrete mixer Concrete vibrator Lifting device Hand tools Chipping hammer Pressure washer Epoxy adhesive Rebar tie wire

Correct Installation and Maintenance of a Centrifugal Pump Ensure Trouble Free Service

Visit to buy Pumps online and take guidance on their installation and Maintenancewww.pumpkart.com