Fashions Review

Notions Tape Measure Seam Gauge Rotary Cutter Shears Scissors Pin cushion Seam ripper Iron Needle Handle Spool pin Stitch width control Stitch selector Backstitch Bobbin winder Thread Upper thread tension dial Thread take up Needle stitch plate Presser foot Presser foot lever Foot pedal Power & light switch Stitch length control Hand wheel Sewing machine Bobbin Bobbin case

Cover Different Stitches Bobbin winder Needle stitch plate HandleSpool pin Presser foot Hand wheel Backstitch Needle Thread take-up Upper thread tension ScreenStitch width Stitch length Presser foot lever Rear thread guide

Identification Bobbin Case Rotary cutter Shears Iron Tape measure Pin cushion Seam gauge Seam ripper Bobbin

Fill in the blanks-Threading the Machine The sewing machine should be turned_ OFF______. Your ____presser foot____ and ___needle___ should be in the up position. The _foam___ pad should be in place on the spool ___pin______. Place the spool of thread so that it turns __towards you__. Attach the _____spool___ disk. Take the thread through the ___rear thread__ guide. Then into the slit of the __upper_ thread ___tension________. Pull thread down to the right of the ___take up____ cover. Take thread up to the left of the cover in the direction of the arrow, placing it in the __take up__ lever. Take thread down the guide where you __push__the front of the machine to get it back into the guide. Thread the eye of the needle from ___front_to ___back____. Guide thread through the ____slit____of the ____presser_foot. Thread should now be going towards the __back__ of the machine.

Threading the bobbin Short essay You will explain the step-by-step process on how to wind a bobbin. You will need to use proper terms Refer to page 13 in your bernina book

Winding the bobbin Turn power on Place empty bobbin on spindle Take thread through rear thread guide Pull thread around the right side and wrap it around the left of the pre-tension stud Keep pulling the thread over to the bobbin going from right to left-front to back. Wrap it around 2-3 times then pull through the thread cutter Press the thread cutter to the left towards the bobbin Press the foot control The machine will automatically stop when the bobbin is full.

Matching/ Putting in order Bobbin case- Removal (put the steps in order) 1.Turn power switch off 2.Raise the needle 3.Open the bobbin cover 4.Grasp the latch of the bobbin case 5.Remove case Insert 1.The finger on the case should point upward 2.Hold the bobbin case latch 3.Insert so that it clicks in place

Needle stitch plate

How to backstitch video You will backstitch every time you start to sew. This will prevent the seam (what you have sewn together) from coming apart. It reinforces your stitching Only backstitch 3-5 stitches video.yahoo.com/watch/ / Watch minutes 2-3