San Juan Islands Submarine Cable Inspection Plan November 30, 2015.

Slides:



Advertisements
Similar presentations
ESTeem RF Design Tools SECTION 4 - RF System Design.
Advertisements

Cisco CCNA Sem 1 Chapter 4 Cable Testing, Cabling LAN’s and WAN’s
CCNA 1 v3.1 Module 4 Cable Testing. Purpose of This PowerPoint This PowerPoint primarily consists of the Target Indicators (TIs) of this module in CCNA.
Qualifications Experience Upper management has 25+ years combined experience in fiber optic communications.
111 © 2002, Cisco Systems, Inc. All rights reserved. Finish Phase Overview Testing Troubleshooting Certification Documentation.
1 PIANO+ OTONES WP3 SIGNAL PROCESSING ALGORITHMS.
Physical Transmission Media 8 5/9/ Modified by: Brierley.
Optical communications & networking - an Overview
Optical Interfaces Lab Last Update Copyright 2014 Kenneth M. Chipps Ph.D. 1.
Optical Fiber Testing Paul Minko EE 566 Oct. 22, 2003.
Fiber-Optic Communications James N. Downing. Chapter 10 Fiber-Optic Test and Measurement.
Department of Electronic Engineering City University of Hong Kong EE3900 Computer Networks Data Transmission Slide 1 Continuous & Discrete Signals.
Fiber-Optic Communications
Microwave Radio Communication Electromagnetic waves with Frequency range from approximately 300 MHz to 300 GHz. High frequency > Short wavelengths > “Microwave”
1 Fiber Optic Measurement Technique Piotr Turowicz Poznan Supercomputing and Networking Center Training Session Kiev 9-10 October.
To produce the highest quality, cost effective microwave products to meet our customers’ needs with either Dorado standard catalog devices or custom products.
Communications Design Alternatives SystemOperation Capability ControlCost $Complexity Radio Control Line of Sight < 3 m depth for Commercial RC Submarines.
OPTICAL TIME DOMAIN REFLECTOMETER (OTDR)
Copyright CCNA 1 Chapter 4, Part 1 Cable Testing By Your Name.
A PROJECT REPORT ON DIGITAL LOOP CARRIER (DLC) Under the Guidance of MR. A.B. SINGH SUBMITTED BY: PALASH GUPTA NIDHI VERMA A.N. RAMANI P. ANUPAMA LUKESHWARI.
Installation and testing
Technique for assuring that a transmitting entity does not overwhelm a receiving entity with data Necessary when data is being sent faster than it.
Poznan Supercomputing and Networking Center
Fiber Optics LINK LOSS BUDGET.
1 Optical Time Domain Reflectometer Piotr Turowicz Poznan Supercomputing and Networking Center 9-10 October 2006.
Home Certification Webinar
1 §5 Multiplexed and distributed sensors 1.Basic sensor array topologies 2.Time division multiplexing (TDM) 3.Wavelength division multiplexing (WDM) 4.Optical.
Data Communication & Computer Networks
1 CISCO NETWORKING ACADEMY PROGRAM (CNAP) SEMESTER 1/ MODULE 4 Cable Testing.
Physical Transmission Media Chapter 8. Objectives In this chapter, you will learn to: Identify the characteristics of wireline transmission Describe the.
Streaming Consciousness on Fiber Testing Quilt Meeting June 22, 2004 Jerry Sobieski Mid-Atlantic Crossroads.
CE 4228 Data Communications and Networking
Dense Wavelength Division Multiplexing (DWDM) Technology
Physical Transmission

Washington Laboratories (301) web: Lindbergh Dr. Gaithersburg, MD How to List a Test Site.
A Company Selling Technology and not just a Product.
Reconfigurable OADMs Reconfigurable OADM (ROADM)
Submission doc.: IEEE /0416r1 Slide 1 Broadband Indoor TVWS Channel Measurement and Characterization at 670 MHz Date: Mar 2012 Ming-Tuo.
EMC Evaluation at Green Bank: Emissions and Shield Effectiveness National Radio Astronomy Observatory Carla Beaudet Green Bank RFI Group Leader.
Optical Loss Budget (Example 2)
The Office Procedures and Technology Chapter 12 Telephone Systems and Procedures Copyright© 2007 Thomson/South-Western.
CCNA 1 v3.0 Module 4 Cable Testing. Objectives Waves.
Graphics courtesy of Prof. D. Dodds, Univ. of Saskatchewan 1 EE489 – Telecommunication Systems Engineering –University of Alberta, Dept. of Electrical.
Extension to the Link Management Protocol (LMP/DWDM - rfc4209) for Dense Wavelength Division Multiplexing (DWDM) Optical Line Systems draft-dharinigert-ccamp-g lmp-02.txt.
Modulation What is modulation?
Activating The Modern Return Plant Presented By Michael E. McCracken Eastern Show ‘96 Presented By Michael E. McCracken Eastern Show ‘96.
Ahmed Musa, John Medrano, Virgillio Gonzalez, Cecil Thomas University of Texas at El Paso Circuit Establishment in a Hybrid Optical-CDMA and WDM All- Optical.
ECE 4710: Lecture #37 1 Link Budget Analysis  BER baseband performance determined by signal to noise ratio ( S / N ) at input to detector (product, envelope,
1 Fiber Optics: An Introduction Carey Williamson University of Calgary.
Supervisor services. Project manager Technological group Chief supervisor Supervisors facilities HSE Quality engineer HSE engineer Administrative support.
Network Media. Copper, Optical, Fibre (Physical Layer Technologies) Introduction to Computer Networking.
ABC Trucking Case Study Applying an audit plan from the source documentation.
Application Note Fiber Connectivity Riedel solutions for broadcast applications 1 Application Note - Fiber Connectivity.
Network Administration and Systems Services. Dark fiber ring.
Physical Transmission Media Chapter 8. Objectives In this chapter, you will learn to: Identify the characteristics of wireline transmission Describe the.
FCC DIGITAL 1ch VIDEO&1ch AUDIO LINK PRODUCT SPECIFICATION
Fundamentals of Information Systems, Sixth Edition
Michael Rahaim, PhD Candidate Multimedia Communications Lab
Methods of transfer of ultra-stable frequencies to radio telescope
Module 4 Cable Testing.
DWDM TECHNOLOGY PALTEL TOPLOGY FOR PALESTINE
INTRODUCTION TO DWDM 19-Nov-18 ALTTC/TX-I/DWDM.
The University of Adelaide, School of Computer Science
Wired and Wireless Troubleshooting
Problem We need more bandwidth
Optical communications & networking - an Overview
MCS Multicast Switch for Next Generation ROADM. Multicast optical switch ( MCS ) is based on PLC technology and MEMS technology , which can route any.
4-Port Reconfigurable Optical Add-Drop Multiplexer (ROADM) (patents pending) Product Description Agiltron 4-port Reconfigurable Optical Add-Drop Multiplexer.
Context and scope In a disaggregated environment when two different entities are in charge of managing optical terminals (OT) and open line systems (OLS)
Presentation transcript:

San Juan Islands Submarine Cable Inspection Plan November 30, 2015

Inspection Plan “ By November 30 of each year, CenturyLink will submit annual inspection plans to the Commission for the subsequent calendar year for the San Juan Submarine Facilities. The plans should, at a minimum, specify the location of the facility to be inspected and the frequency and manner in which inspections will be conducted.” 1. Annually, a qualified technician will run a fiber characterization script that tests the integrity of the submarine cables utilizing an Optical Time Domain Reflectometer (OTDR). The script will measure insertion loss, optical return loss, chromatic dispersion and attenuation profile. The test results will compared to engineered specifications. 2

Inspection Plan (continued) 2.Annually, a qualified central office technician will retrieve the overall optical loss results from the Coriant 7100 nodes located on Lopez Island and La Conner. The results will be captured and compared to the equipment manufacturer’s optical specifications. 3.Annually, a qualified central office technician will retrieve the overall optical loss results from the Fujitsu 7420 nodes located on Friday Harbor, Lopez Island, and Orcas Island. Results will be compared to the equipment manufacturer’s optical specifications. 3

Inspection Plan (continued) 4.Annually, field operations will conduct a site survey at the first location where submarine cable appears on land and is accessible. The survey will involve visual examination of the fiber optic cable, condition of the vault or pedestal, and changes in the surrounding environment. 4

5 Lopez to La Conner This document describes signal loss measurement between the Coriant 7100 optical electronics located in Lopez Island and in La Conner Washington Loss is the difference between the Transmitted (Tx) signal level and the Received (Rx) signal level. Levels will be measured on the optical service channels (OSC) of the 7100N Reconfigurable Optical Add Drop Multiplexer (ROADM) High-speed cards.

6 Coriant 7100 Optical Specifications The Lopez 7100N is equipped with OADM-LR High-speed cards The OADM88-LR supports span loss of 14 dB to 26 dB The La Conner 7100N’s are equipped with LRAM-88 cards in both Optical Line Amplifier (OLA) shelves The LRAM-88 supports span loss of 14 dB to 26 dB LRAM = Long Range Amplifier Module

7 Lopez to Friday Harbor We will conduct signal loss measurement between the Fujitsu FW7420 optical electronics located at Lopez Island and at Friday Harbor Loss is calculated as the difference between the Transmitted (Tx) signal level and the Received (Rx) signal level. Levels will be observed on the working channels of the FW7420 High-speed cards.

San Juan Island Fiber Customer: CENTURYLINK Location: LOPEZ, WA Product: Customer: CENTURYLINK Location: LOPEZ, WA Product: Date: Requestor: Originator: SCOTT DALLASTA B A D C E F G H MICROWAVE RADIO ROUTE FIBER ROUTE FIBER SEGMENT DETAIL A TO BLHMWA01