Introduction Thank you for taking the time to view this slideshow, it will walk you through the re- assembly and pieces of your watch. Thank you for taking the time to view this slideshow, it will walk you through the re- assembly and pieces of your watch. To skip a slide simply press the right arrow key or to go back to a previous slide, press the left arrow key. To skip a slide simply press the right arrow key or to go back to a previous slide, press the left arrow key. Thank you again and enjoy the show. Thank you again and enjoy the show.
As Found minus bezel
As found red paint seal
As found bezel
As found back of bezel
As found without the crystal
As found dial close up
As found empty case front
As found case back
As found virgin lock ring and foggy crystal
Decomposed Crown Gasket
Decomposed Gasket
As Found Gooey old Gasket
As found locking bolt with decomposed gasket
Locking bolt cleaned
As found auto side movement
As found train side movement
As found Micro Regulator
As found plastic hack
As found stripped calendar side
Caliber number and decomposition stains
As found balance with cock
As found inside caseback
As found after Ultraviolet exposure
As found dial in low light
Under Blacklight
New and old dials
Finished wind set calendar
Ratchet wheel before and after
Serial Number
Finished, clean, and ready to assemble
No more stains
Finished train sans bridges
Finished train sans auto
Finished wind set calendar partial
Finished train side
Finished movement
Finished movement 2
Final dial side
Case parts
Finished back profile
Finished back with bracelet
Finished Profile
Finished from front
Finished profile
Finished on bracelet
Finished profile
Registered Watchmaker’s casemark on watch
Finished in all it’s glory!