8.5 SATELLITE COMMUNICATIONS

Slides:



Advertisements
Similar presentations
CH. 4 Transmission Media.
Advertisements

Air traffic increases steadily over the years that lead to the increase of flights through the Poles, oceans and regions with reduced radar coverage.
Part2 course Network Planning and Link Budget Analysis 1.
Lab 2 COMMUNICATION TECHNOLOGY II. Capacity of a System The bit rate of a system increases with an increase in the number of signal levels we use to denote.
© 2003, Cisco Systems, Inc. All rights reserved. FWL 1.0— © 2003, Cisco Systems, Inc. All rights reserved.
Communications - Access Schemes 1 Introduction to Space Systems and Spacecraft Design Space Systems Design.
08/16/01. Link Budgets for Cellular Networks Presented by Eric Johnson.
Copyright : Hi Tech Criminal Justice, Raymond E. Foster Police Technology Police Technology Chapter Three Police Technology Wireless Communications.
Summary of Path Loss in Propagation
6-1 Elements of a wireless network network infrastructure wireless hosts r laptop, PDA, IP phone r run applications r may be stationary (non-mobile) or.
08/16/01.
© 2003, Cisco Systems, Inc. All rights reserved. FWL 1.0—3-1 Wireless Radio Technology Olga Torstensson Halmstad University.
Communications - Access Schemes 1 Introduction to Space Systems and Spacecraft Design Space Systems Design.
Copyright © 2003, Dr. Dharma P. Agrawal and Dr. Qing-An Zeng. All rights reserved. 1 Chapter 7 Multiple Division Techniques.
ESTeem Training Class Radio Technology Overview. Radio Basics Terminology – Familiarization with radio expressions Basic Components – Transmitter – Receiver.
SATELLITE LINK DESIGN By S.Sadhish Prabhu.
ECE 5233 Satellite Communications
2.4-GHZ RF TRANSCEIVER FOR IEEE B WIRELESS LAN UF# UF#
Communication and Ground Station 12 October 2008.
ECE 5233 Satellite Communications
Link Budget Calculation
Ron Milione Ph.D. W2TAP W2TAP InformationModulatorAmplifier Ant Feedline Transmitter InformationDemodulatorPre-Amplifier Ant Feedline Receiver Filter.
3/ EN/LZU Rev A WCDMA Air Interface Part 3: 1 of 22 WCDMA Air Interface Training Part 3 CDMA Capacity Considerations.
Submission doc.: IEEE 11-11/1455r0 Nov 2011 Fei Tong,Les Smith, CSRSlide ah network outdoor deployment issues Date: 2011-Nov-03 Authors:
VSOP-2 Ground Link Station - Tracking Station Requirements - National Astronomical Observatory of Japan Y. Kono.
Satellite Microwave MMG Rashed Sr. Lecturer, Dept. of ETE Daffodil International University.
SJD/TAB1 EVLA Fiber Selection Critical Design Review December 5, 2001.
Wireless Communications. Outline Introduction History System Overview Signals and Propagation Noise and Fading Modulation Multiple Access Design of Cellular.
System parameters and performance CDMA-2000, W-CDMA (UMTS), GSM 900, WLAN a, WLAN b, Bluetooth. By Øystein Taskjelle.
1 EE 499 Wireless Communications Project by Team 4: Arati NagarkarHemant Samtani Supriya HerwadkarChinmay Shete Shivani KaushalSalil Sawhney.
Physical Layer Fundamentals Physical MAC Physical LLC Data Link Network Transport Session Presentation Application OSI Ref ModelWireless Network Network.
ECE 4710: Lecture #36 1 Chapter 8  Chapter 8 : Wired and Wireless Communication Systems  Telephone  Fiber Optic  DSL  Satellite  Digital & Analog.
Dept. of EE, NDHU 1 Chapter Five Communication Link Analysis.
Satellite Communications
Lunar Surface EVA Radio Study Adam Schlesinger NASA – Johnson Space Center October 13, 2008.
SWE-DISH SATELLITE SYSTEMS
ECE 4710: Lecture #2 1 Frequency  Communication systems often use atmosphere for transmission  “Wireless”  Time-varying Electro-Magnetic (EM) Wave 
RF Propagation No. 1  Seattle Pacific University Basic RF Transmission Concepts.
Mobile Computing and Wireless Networking Lec 02
Radio wave Propagation
Ασύρματες και Κινητές Επικοινωνίες
Ασύρματα Δίκτυα και Κινητές Επικοινωνίες Ενότητα # 3: Ασύρματο Κανάλι και Διάδοση Σημάτων Διδάσκων: Βασίλειος Σύρης Τμήμα: Πληροφορικής.
From you host … Dr. H. Introduction Communications design requires us to think about the following issues: Communications design requires us to think.
Wireless Communications Outline Introduction History System Overview Signals and Propagation Noise and Fading Modulation Multiple Access Design of Cellular.
Design WLAN Politeknik Telkom Design WLAN Step to design WLAN : 1. Location Survey 2. Topology 3. Distance calculating 4. Antenna design 5. Towering.
Low - Rate Information Transmission (LRIT) Downlink and Reception Satellite Direct Readout Conference for the Americas Frank Eng, Computer Sciences Corp.
Doc.: IEEE Submission Nov 2014 Link Budget Analysis for 40-50GHz Indoor Usage Date: Authors: Slide 1Jianhan Liu, Mediatek Inc.
From you host … Dr. H. Introduction In the present project, communications design forces us to think about the overall arrangement of the system and its.
1) A binary transmission system uses a 8-bit word encoding system. Find the Bandwidth and the SNR dB of the system if the channel capacity is bps.
Communication Link Analysis Pranesh Sthapit Chapter 5.
Ramesh Kumar lama  System noise temperature  Radio maps of sky  Sample link analysis  Link Budget details  Receiver figure of merit  Received.
The University of Iowa. Copyright© 2005 A. Kruger 1 Introduction to Wireless Sensor Networks Wireless Terms, FAQ & Glossary 27 January 2005.
Transmission Techniques Traffic channels: different users are assigned unique code and transmitted over the same frequency band, for example, WCDMA and.
EEE 441 Wireless And Mobile Communications
Numericals.
Dr. Yeffry Handoko Putra, M.T
EARTH SEGMENT & SPACE LINK
Wireless Radio Technology
8. ADVANCED DATA COMMUNICATIONS
CT-474: Satellite Communications
Tropo-Scatter Link Budget
Satellite uplink and downlink Analysis and Design
Noise Figure, Noise Factor and Sensitivity
Communication Systems.
Satellite Communications
6-10GHz Rate-Range and Link Budget
UWB Receiver Algorithm
Noise Figure, Noise Factor and Sensitivity
CT-474: Satellite Communications
Presentation transcript:

8.5 SATELLITE COMMUNICATIONS Antenna Coverage

Figure 8-29. (a) Satellite repeater link Figure 8-29. (a) Satellite repeater link. (b) Frequency-translation satellite communications relay. (c) Demod/remod satellite communications relay.

Figure 8-30 Polar representation of a general antenna gain function.

Example 8.4

Earth Station and Transmission Methods Figure 8-31 Satellite ground station receiver/transmitter configuration. The command transmitter and telemetry receivers are not shown.

Figure 8-32 Illustration of multiple-access techniques. (a) FDMA Figure 8-32 Illustration of multiple-access techniques. (a) FDMA. (b) TDMA. (c) CDMA using frequency-hop modulation (numbers denote hopping sequences for channels 1, 2, and 3.

Figure 8-33 Details of a TDMA frame format.

Figure 8-34 Signal and noise powers in the uplink and downlink portions of a bent-pipe satellite relay system.

Link Analysis: Bent-Pipe Relay

Example 8.5

Figure 8-35 Transition probability diagram for uplink and downlink errors on a demod/remod satellite relay. Figure 8-35 Transition probability diagram for uplink and downlink errors on a demod/remod satellite relay.

Link Analysis:OBP Digital Transponder

Example 8.6

Figure 8-36 Comparison of bent-pipe and OBP relay characteristics.

Figure 8-37 Hexagonal grid system representing cells in a cellular radio system; a reuse pattern of seven is illustrated.

Link Budget Analysis

From performance analysis to physical transceiver specs Link budget analysis connects performance analysis to physical transceiver specs Transmit power Antenna directivities at Tx and Rx Quality of receiver circuitry (how much noise do we incur) Desired link range

Taking stock of what we know Given bit rate and signal constellation (including any error correction code that is used), we know the required modulation degrees of freedom per unit time (the symbol rate) This gives minimum Nyquist bandwidth Now factor in excess bandwidth Given the constellation and desired BER, can find Eb/N0 required, and hence the required SNR SNR=(energy/bit * bits/sec)/(noise PSD*bandwidth) Given receiver noise figure and bandwidth, can find noise power We can now specify the receiver sensitivity (min required received power): Receiver sensitivity (typically quoted in dBm)

Friis’ Formula (free space propagation) Carrier wavelength Range Transmit power antenna directivity Receive Antenna directivity (gain with respect to isotropic antenna) is often expressed in dB scale Friis’ Formula in dB scale

Link Budget Equations More generally, the received power is given by for free space propagation Add on a link margin (to compensate for unforseen or unmodeled performance losses) to get the link budget:

Example: link budget for a WLAN WLAN link at 5 GHz 20 MHz bandwidth, QPSK, excess bandwidth 33%, receiver noise figure 6 dB BIT RATE Symbol rate Bit rate REQUIRED SNR 10-6 BER for QPSK requires Eb/N0 of 10.2 dB (use BER formula ) ) In dB,

Link budget for WLAN (contd.) Receiver sensitivity (transmit power of 100 mW, or 20 dBm, and antenna directivities of 2 dBi at Tx and Rx) Find the max allowable path loss for the desired receiver sensitivity: Invert path loss formula for free space propagation Range is 107 meters Of the order of advertised WiFi ranges Max. allowable path loss Noise power Try variants: redo for other constellations; carrier frequency of 60 GHz with antenna directivities of 20 dBi.