Pipe Clips

Single Pipe Clip These are single plastic stand-off pipe clips. This clip is used to hold single pipes. When installing pipework set out your lines secure the clips, this holds your pipework in place.

Clip Lock These as similar to the standard clips; they have the addition of a clip to hold the pipe in place.

Double Pipe Clip These hold two pipes at a standard distance apart. They can give the work a uniform look.

Interlocking Clip Lock These clips can be clipped together to form banks of as many as needed. These can come as standard and locking clips.

Nail-on Pipe Clip Typically used on smaller bore pipe. Care should be taken when using these clips as the expansion and contraction of the copper pipe can loosen the clip.

Copper Saddle Clip These clips are good for clipping pipes to skirting boards and under floor boards due to there low profile. These clips should not be used to hold copper pipe against masonry or plaster walls; as this can cause corrosion.

School Board Pipe Clip These are used in light commercial and industrial installations. These brackets give the pipe more rigidity minimizing any damage that might be cause.

Hospital Board Pipe Clip

Munsen Ring These clips are mainly used in industrial installations. The bracket is screwed to the base plate. This clip gives the strongest fixing of the clips.

Munsen Ring Back Plate These are the back plates that the munsen ring screws onto. These back plates can be screwed to the walls or ceilings.

Copper Pipe clip Spacing Tube Size Horizontal Distance Between Clips Vertical Distance Between Clips 10mm 0.8m 1.2m 15mm 1.8m 22mm 2.4m 28mm 35mm 3.0m 42mm 54mm 2.7m

Iron School Board Clip These clips are used to secure low-carbon steel pipe work. The clip can be fixed to the wall and the pipe rested on it until it is clamped with the top bracket.

Iron Munsen Ring These munsen rings have a threaded hole in both the bracket and back plate, this allows threaded bar be cut to length to adjust the distance of the pipe from the ceiling. The clips come in plain finish or galvanized.

Low Carbon Steel Pipe Clip Spacing Tube Size Horizontal Distance Between Clips Vertical Distance Between Clips ½” 1.8m 2.4m ¾” 3.0m 1” 1¼” 2.7m 1½” 3.6m

Waste Pipe Clip

Soil Pipe Bracket

Maximum Support Distance Maximum distance between expansion joint PVCu Pipe Clip Spacing Maximum Support Distance Maximum distance between expansion joint Vertical Horizontal Soil pipe size 82mm 2m 0.9m 4m 110mm 1m 160mm Waste pipe size 32mm 0.5m 40mm 50mm

Polypropylene Pipe Clip Spacing Maximum Support Distance Maximum distance between expansion joint Vertical Horizontal Waste pipe size 32mm 0.5m 2m 40mm 50mm 0.9m

Polybutylene Pipe Clip Spacing Pipe diameter Horizontal Distance Between Clips Vertical Distance Between Clips 10mm 0.3m 0.5m 15mm 22mm 0.8m 28mm 1.0m