Connect UAT Console and Start the program

If no Com port is available for selection, the port is not configured correctly

Go to the start menu and select “control panel.”

Select “Device Manager”

Select Com Ports

Right Click “your” com port and select “Properties”

From the “properties box” select the “Port Settings” tab

Set this up as listed below per the NavWorx Installation Manual

Go back to the UAT console and select your Com port

You must program the aircraft Tail Number (otherwise the UAT will see it’s host aircraft) the ICAO Code should populate on it’s own.

On the “Display” tab you will want to set: Display port 1 to “Avidyne” Baud Rate Arinc429 Port to “Traffic Advisory” Data Rate to “High” Ensure Arinc429 Installed is “checked” and “message display”= 4

On the “Inputs” tab, the altitude encoder for the type and baud rate installed. Set GPS source for “MLB-100 Aviation”

Select the “status” tab to ensure there are no failures listed

From any tab you can activate the “traffic simulation.” Please note: The connected IFD must be receiving GPS in order for the test traffic to display