Project group: May1315 Client: Rockwell Collins Advisor: Dr. George Amariucai.

Slides:

Advertisements

Similar presentations

Op-Amps and Saturation. The Inverting Mode Op-Amp + - V1V1 VoVo RfRf R1R1 In theory, the gain of the op-amp is given by R f ÷ R 1. This equation works.

Advertisements

Operational Amplifiers

Operational Amplifiers

The Inverting Mode Op-Amp. What is the Inverting Mode ? The op-amp can be connected up in various ways or modes. What it does depends on how it is connected.

Georgia Tech Digital Back-end µHRG interface Curtis Mayberry School of Electrical and Computer Engineering Georgia Institute of Technology January 13 th,

ECE201 Lect-161 Operational Amplifiers ( ) Dr. Holbert April 3, 2006.

Temperature Variable Assembly LM 324N: Used to amplify voltage using negative feedback Resistor values R i =474 Ω R f =10 kΩ Gain ( ) = With these.

Introduction to the OP AMP

ECE 201 Circuit Theory I1 Introduction to the Operational Amplifier μA 741 OP AMP.

1 More on Op Amps Discussion D Ideal Op Amp 1) The open-loop gain, A v, is infinite. 2) The current into the inputs are zero.

Capstone Fall 2005 GFX-One Guitar Processor Team Carpal Tunnel October 6 th 2005.

Lecture 251 More On Op Amps. Lecture 252 Review The ideal op amp model leads to the following conditions: i + = i - = 0 v + = v - The op amp will set.

Gwynneth Davidoff, Kendall Pletcher, Mary Schmidt, Amy Whitcombe.

Gwynneth Davidoff, Kendall Pletcher, Mary Schmidt, Amy Whitcombe.

12.5 Common Source Amplifiers

Common-Base Amplifier. Response of CB Stage to small Input Change.

MSP 430 Project ECE 300 Spring 2004 William S. McLemore Ruben D. Briano Cheng-Han Tsai.

MSP430 Group Project ECE 300 Spring 2007 Dr. Walter Green Jeffrey Logsdon John Ly Daniel Henderson Nataly Sumarriva.

PCB Presentation Group 6 – String Us Up! Matthew Barton Clifford Risley Patrick Nice Seth “Schematic” George.

ECE 4991 Electrical and Electronic Circuits Chapter 8.

Operational Amplifiers Instructor: Chia-Ming Tsai Electronics Engineering National Chiao Tung University Hsinchu, Taiwan, R.O.C.

St Columba’s High School Electricity and Electronics Op-amps.

ECE 300 Microprocessor Project MSP 430. Group Members Demetric Banahene David Fish Zack Pannell.

ECE 300 Microprocessor Project Nick Jones Bibi Morales Bibi Morales Hadi Choueiry Tyler Griffin Tyler Griffin Group 9.

Audio Systems (continued) ET6. Frequency Dependant Resistors As we have seen previously capacitors and resistors are used together to create RC circuits.

Linear Regulator Fundamentals

MONSOON IR Acquisition Aladdin Front End. Aladdin Front End Test Results 1 k  external load, BW = 7 MHz No filtering/bypassing of OFFSET ADC input adjusted.

Questions on IFPAC_SCHEMATIC. Signal Chain Preamplifier Compensation Capacitor should go to –Vs, not GND Where is resistor For compensation Network? Does.

Lecture 4: Electrical Circuits

Op Amp Nonidealities (1) Section 8.4. Topics DC Offset Input Bias Current Speed Limitations Slew Rate Finite Input and Output Impedance.

Study Guide Exam 2. Closed book/Closed notes Bring a calculator.

Digital to Analog Converters (DAC) 3 ©Paul Godin Created March 2008.

RYAN LIPSKI, CAMERON PUTZ, AND NICK SIKKEMA ADVISOR: DR. JOSEPH DRISCOLL DEPARTMENT OF ELECTRICAL AND COMPUTER ENGINEERING, BRADLEY UNIVERSITY FEBRUARY.

Impedance Matching Units. Maximum Power Transfer Theorem As we have seen previously the output of a power amplifier must transfer as much power as possible.

MSP430 Project ECE 300 Spring 2006 Cortney McKibben Rebekah Wilson Shupeng Zhang.

2/June/2009LHCb Upgrade1 Single ended ADC Differential ADC –Convert single ended signal to differential (use AD8138 amp) –ASIC differential output ADC.

IPhone Noise Cancellation Meeting 10/1 Project group: May1315 Client: Rockwell Collins Advisor: Dr. George Amariucai.

박유진 nRF24Z1 Audio Module. Basic Function Simple Communication ATX(Audio microphone) and ARX(Audio Speaker) Directional Communication Bidirectional Communication.

ECE 300 Brian Austin Paul Obame Michael Vaughn Thomas P. Wills Dr. Green Final Project April 17, 2004.

Low Cost Universal Test Equipment Survey on Power supplies.

Nail Coil Gun ECE 445 Project: 20 Group: Andria Young, Seth Hartman TA: Ryan May.

The Ideal Op-amp (Operational amplifier) v+ VOUT v– +15V VIN VOUT –15V

Operational Amplifier

Digital to analog converter [DAC]

Electronic Devices and Circuit Theory

Introduction Filters are circuits that are capable of passing signals within a band of frequencies while rejecting or blocking signals of frequencies outside.

IMPROVING THE PERFORMANCE OF COMPARATORS

1.6 Op-Amp Basics Basic Op-Amp Practical (Ri = high , Ro = small)

SUMMING AMPLIFIER INTEGRATOR DIFFERENTIATOR COMPARATOR

Digital-to-Analog Analog-to-Digital

EI205 Lecture 13 Dianguang Ma Fall 2008.

Feedback No feedback : Open loop (used in comparators)

The open loop gain of this op-amp is 105 and the bandwidth is 10 Hz

Hugo França-Santos - CERN

IPhone Noise Cancellation Meeting 1/28 Project group: May1315 Client: Rockwell Collins Advisor: Dr. George Amariucai.

Examples of Negative Feedback Applications: A) Inverting Amplifiers

Operational Amplifier

High-Voltage Supply Requirements Review

Introduction to the OP AMP

The operational amplifier

Op Amp Specs and Test Benches

Introduction to the OP AMP

ADS7841 SAR Input Model (6/1/17)

Dong-Han Ryu Yukeun Sim Shiv Biddanda Po-Cheng (Robert) Wang

Preliminary PCB Layout Presented by: Carey Woolet

Digital to Analog Converters (DAC) 3

10k 20k Vin Vout H3 What is the gain?

IPhone Noise Cancellation Meeting 2/18 Project group: May1315 Client: Rockwell Collins Advisor: Dr. George Amariucai.

Radhabai Kale mahila mahavidyalaya,ahmednagar Department of Physics

Verify chip performance

Presentation transcript:

Project group: May1315 Client: Rockwell Collins Advisor: Dr. George Amariucai

 Voltage Regulators and Capacitors.  LM7805 (9V  5V)  LM3940 (9V  3.3V)  LM317 (5V  3.6 V)  ADC, DAC.  JTAG HEADER resized.

 LM3940 outputting 3.65V  LM317 not functioning correctly.  Fixed, Resistance too high. Too much Current wasted.  680 and 330  Bypass made. Adding second Source for 3.3V input needed.

 Solder MCU, New CRYSTAL, JTAG Header, Op Amp  Test Basic code for MCU Functionality  Op Amp Gain tests  ADC Tests.  Layout update

