CHAPTER 6. 6.1 INTRODUCTION 6.2 QUASI-STATIC OPERATION.

Slides:



Advertisements
Similar presentations
R. van Langevelde, A.J. Scholten Philips Research, The Netherlands
Advertisements

Introduction to CMOS VLSI Design Lecture 3: CMOS Transistor Theory David Harris Harvey Mudd College Spring 2004.
VLSI Design CMOS Transistor Theory. EE 447 VLSI Design 3: CMOS Transistor Theory2 Outline Introduction MOS Capacitor nMOS I-V Characteristics pMOS I-V.
© Digital Integrated Circuits 2nd Devices Digital Integrated Circuits A Design Perspective The Devices Jan M. Rabaey Anantha Chandrakasan Borivoje Nikolic.
Introduction to CMOS VLSI Design Lecture 3: CMOS Transistor Theory
Phy 213: General Physics III Chapter 27: Electric Circuits Lecture Notes.
CSCE 612: VLSI System Design Instructor: Jason D. Bakos.
半導體量測技術 Semiconductor Materials and Device Characterization Topic 5: oxide trapped charge and poly-depletion effect in MOSFET Instructor: Dr. Yi-Mu Lee.
Introduction to CMOS VLSI Design Lecture 3: CMOS Transistor Theory David Harris Harvey Mudd College Spring 2004 from CMOS VLSI Design A Circuits and Systems.
Digital Integrated Circuits A Design Perspective
Week 9a OUTLINE MOSFET ID vs. VGS characteristic
Spring 2007EE130 Lecture 32, Slide 1 Lecture #32 OUTLINE The MOS Capacitor: Capacitance-voltage (C-V) characteristics Reading: Chapter 16.4.
Chapter Five The Field-Effect Transistor. Figure 6—2 A three-terminal nonlinear device that can be controlled by the voltage at the third terminal v.
VLSI design Lecture 1: MOS Transistor Theory. CMOS VLSI Design3: CMOS Transistor TheorySlide 2 Outline  Introduction  MOS Capacitor  nMOS I-V Characteristics.
© Digital Integrated Circuits 2nd Devices VLSI Devices  Intuitive understanding of device operation  Fundamental analytic models  Manual Models  Spice.
EE415 VLSI Design The Devices: Diode [Adapted from Rabaey’s Digital Integrated Circuits, ©2002, J. Rabaey et al.]
Extension for High-Voltage Lateral DMOS Transistors
Mextram 504 BJT model F. Yuan Advisor : Prof. C. W. Liu Graduate Institute of Electronics Engineering and Department of Electrical Engineering, National.
EE130/230M Review Session 1.Small Signal Models for MOSFET/BJT 2.MOS Electrostatics.
CMOS Analog Design Using All-Region MOSFET Modeling 1 Chapter 1 Introduction to analog CMOS design.
© Digital Integrated Circuits 2nd Devices Digital Integrated Circuits A Design Perspective The Devices Jan M. Rabaey Anantha Chandrakasan Borivoje Nikolic.
The Devices Digital Integrated Circuit Design Andrea Bonfanti DEIB
LOGS EQUAL THE The inverse of an exponential function is a logarithmic function. Logarithmic Function x = log a y read: “x equals log base a of y”
OXIDE AND INTERFACE TRAPPED CHARGES, OXIDE THICKNESS
CMOS Analog Design Using All-Region MOSFET Modeling 1 CMOS Analog Design Using All-region MOSFET Modeling Chapter 3 CMOS technology, components, and layout.
CMOS Analog Design Using All-Region MOSFET Modeling 1 Chapter 2 Advanced MOS transistor modeling.
ECE340 ELECTRONICS I MOSFET TRANSISTORS AND AMPLIFIERS.
CMOS Analog Design Using All-Region MOSFET Modeling 1 Chapter 11 MOSFET parameter extraction for design.
Section 9.3 Logarithmic Functions  Graphs of Logarithmic Functions Log 2 x  Equivalent Equations  Solving Certain Logarithmic Equations 9.31.
Electron and Hole Concentrations in Extrinsic Semiconductor
Hirophysics.com RC Circuits and its Physical Simulation Richard Robbins.
CMOS VLSI Design CMOS Transistor Theory
Introduction to CMOS VLSI Design Lecture 4: CMOS Transistor Theory David Harris Harvey Mudd College Spring 2007.
Penn ESE370 Fall DeHon 1 ESE370: Circuit-Level Modeling, Design, and Optimization for Digital Systems Day 10: September 19, 2014 MOS Transistor.
POD 1. 2x = 46 2.M – 5 = j = 58. Chapter 3.1 Solving two step equations Using subtraction and division to solve:Using addition and multiplication.
Do Now: 7.4 Review Evaluate the logarithm. Evaluate the logarithm. Simplify the expression. Simplify the expression. Find the inverse of the function.
The MOS Transistor Polysilicon Aluminum. The NMOS Transistor Cross Section n areas have been doped with donor ions (arsenic) of concentration N D - electrons.
EE141 © Digital Integrated Circuits 2nd Devices 1 Digital Integrated Circuits A Design Perspective The Devices Jan M. Rabaey Anantha Chandrakasan Borivoje.
MOS Capacitor Picture.
Spencer/Ghausi, Introduction to Electronic Circuit Design, 1e, ©2003, Pearson Education, Inc. Chapter 2, slide 1 Introduction to Electronic Circuit Design.
Solving Multi-Step Equations Using Inverse Operations.
Introduction to CMOS VLSI Design CMOS Transistor Theory
Penn ESE370 Fall DeHon 1 ESE370: Circuit-Level Modeling, Design, and Optimization for Digital Systems Day 10: September 20, 2013 MOS Transistor.
Lecture #25: Electric Circuits Continued AP Physics B.
Damu, 2008EGE535 Fall 08, Lecture 21 EGE535 Low Power VLSI Design Lecture #2 MOSFET Basics.
1-8 Number Lines Real #’s. We have numbers to represent quantities The cavemen needed a way to count. Whole Numbers: {0, 1, 2, 3, …} shorthand (W) Then.
CHAPTER ~ STRONG INVERSION 4.7 Strong Inversion Complete Strong-Inversion Model a 4.7.2b
MOS Capacitor Lecture #5. Transistor Voltage controlled switch or amplifier : control the output by the input to achieve switch or amplifier Two types.
ECE 333 Linear Electronics
EE141 Chapter 3 VLSI Design The Devices March 28, 2003.
Scatter Plots and Equations of Lines
Changing Device Parameters in PSpice
Notes on Diodes 1. Diode saturation current:  
Week 9a OUTLINE MOSFET ID vs. VGS characteristic
Logarithms and Logarithmic Functions
ECE 333 Linear Electronics
Chapter 1 and 2 review CMOS Devices and models Fabrication process
Chapter 1: Introduction
Chapter 1 and 2 review CMOS Devices and models Fabrication process
Equation Review Given in class 10/4/13.
Week 9a OUTLINE MOSFET ID vs. VGS characteristic
Lecture #17 (cont’d from #16)
CHAPTER 8.
Notes Over 7.4 Finding an Inverse Relation
Smith chart Nonideal effects.
Equation Review.
Electric Current Chapter 34.
Ohm’s Law and Resistivity
Logarithmic Functions
Lecture #16 OUTLINE MOSFET ID vs. VGS characteristic
Presentation transcript:

CHAPTER 6

6.1 INTRODUCTION 6.2 QUASI-STATIC OPERATION

6.1 Introduction

6.2 Quasi-Static Operation

6.2 Quasi-Static Operation 6.2.5

6.2 Quasi-Static Operation

6.3 TERMINAL CURRENTS IN QUASI-STATIC OPERATION

6.3 Terminal Currents in Quasi-Static Operation

6.3 Terminal Currents in Quasi-Static Operation

6.3 Terminal Currents in Quasi-Static Operation

6.3 Terminal Currents in Quasi-Static Operation

6.4 EVALUATION OF INTRINSIC CHARGES IN QUASI-STATIC OPERATION

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Strong Inversion a 6.4.2b 6.4.2c 6.4.3a 6.4.3b

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Strong Inversion

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Strong Inversion

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Strong Inversion

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Strong Inversion

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Weak Inversion

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation All-Region Model a b

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Depletion and Accumulation

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Plots of Charges vs. V GS

6.4.7

6.4 Evaluation of Intrinsic Charges in Quasi-Static Operation Use of Intrinsic Charges in Evaluating the Terminal Currents

6.5 TRANSIT TIME UNDER DC CONDITIONS 6.6 LIMITATIONS OF THE QUASI-STATIC MODEL

6.5 Transit Time under DC Conditions

6.6 Limitations of the Quasi-Static Model

6.6 Limitations of the Quasi-Static Model

6.7 NON-QUASI-STATIC MODELING

6.7 Non-Quasi-Static Modeling Introduction The Continuity Equation

6.7 Non-Quasi-Static Modeling Non-Quasi-Static Analysis

6.7.3

6.8 EXTRINSIC PARASITICS

6.8 Extrinsic Parasitics Extrinsic Capacitances

6.8 Extrinsic Parasitics Extrinsic Resistances 6.8.4

6.8 Extrinsic Parasitics Extrinsic Resistances

6.8 Extrinsic Parasitics Temperature Dependence

6.8 Extrinsic Parasitics Simplified Models