CCNA1 v3 Module 9 v3 A+ Type 1 JEOPARDY K. Martin.

Slides:



Advertisements
Similar presentations
Refrigeration Systems
Advertisements

Coach Air Conditioning
Chapter 4 Air-Conditioning Components
CCNA1 v3 Module 9 v3 A+ CORE JEOPARDY K. Martin CCNA1 v3 Module 9 RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands.
ADX 150 – Engine Repair ADX 170 – Climate Controls
Cooling System Get the engine up to optimum operating Temperature as quickly as possible and maintains it at that temperature. Controls the heat produced.
General System Maintenance BUS 4 COMPONENT FLOW.PPT
Perform Control Test. Check for Consistent Liquid Temperatures Entering and Leaving Liquid Temperatures should be close when the water pumps are on but.
SECTION 4 ELECTRIC MOTORS UNIT 9
3.7.6 Student Book © 2004 Propane Education & Research CouncilPage Identifying Procedures for Conducting Container Vapor Flaring Operations Before.
3.4.6 Student Book © 2004 Propane Education & Research CouncilPage Maintaining Bulk Plant Compressors Knowledge of the processes involved in maintaining.
SAFETY, TOOLS & EQUIPMENT, SHOP PRACTICES
Always Learning.
Section 608 Certification Pre-Test
Dennis Sabre Fire Appliances
Air Conditioning EPA Type II.
The Cooling System.
SYSTEM COMPONENTS CHAPTER 5page 91C & 93 L. OBJECTIVES l IDENTIFY AND COMPARE THE STATE OF REFRIGERANT IN EACH SECTION OF A/C SYSTEM. l EXPLAIN PURPOSE.
CHAPTER 6 Moving Heat: Heating and Air Conditioning Principles
Section 608 Certification Pre-Test
1 Air Conditioning EPA Type 1. 2 Type One Certification.
Heating and Air Conditioning Systems 27 Introduction to Automotive Service James Halderman Darrell Deeter © 2013 Pearson Higher Education, Inc. Pearson.
Left side compressor behind Left control box Right side compressor behind Right control box.
NFPA 31 Standard for the installation of Oil- Burning Equipment
SAFETY, TOOLS & EQUIPMENT, SHOP PRACTICES
1 A/C Pressure Test and Evacuation. 2 Leak Detection Leak detection must be done after every repair job. It must also be done anytime the appliance can.
CCNA1 v3 Module 9 v3 A+ Type 1 JEOPARDY K. Martin.
1 HVACR318 – Refrigeration II Diagrams. 2 Hooking up Gauges on Suction and Discharge Lines.
CCNA1 v3 Module 9 v3 A+ Type 2 JEOPARDY K. Martin.
Student Book © 2004 Propane Education & Research CouncilPage Reducing Cargo Tank Vapor Pressure Using a Plant Compressor In order to use.
3.4.3 Student Book © 2004 Propane Education & Research CouncilPage Bulk Plant Emergency Shutdown Equipment and Periodic Examination Methods One.
Air Conditioning Charging.
CCNA1 v3 Module 9 v3 A+ CORE JEOPARDY K. Martin CCNA1 v3 Module 9 RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands.
A/C SYSTEM SERVICE 1  A/C manifold gauge set  Manifold valves  Hose end valves  Performance test  Pressure diagnosis  Manifold purging and disconnect.
3.1.8 Student Book © 2004 Propane Education & Research CouncilPage Identifying Procedures for Conducting Container Vapor Flaring Operations Before.
Automotive Engines: Theory and Servicing, 7/e By James D. Halderman Copyright © 2011, 2009, 2005, 2001, 1997 Pearson Education, Inc., Upper Saddle River,
AIR CONDITIONING (COOLING)
Vacuum, Charging and Recovery Sugiyanto, S.T., M.Eng.
3. Climate Control Systems Service Automotive – Heating & Air Conditioning Topics covered in this presentation: Gauge set and refrigerant Service ports.
James McIntyre VRF Training Manager V5 Key Components.
Section 2: Safety, Tools and Equipment, and Shop Practices
Automotive Heating And Air Conditioning
Climate Control Systems Service
R1 Fundamentals of Refrigeration
ARAC/H/F Air-cooled water chillers, free-cooling chillers and heat pumps Range: kW.
14 Refrigerant Recovery, Recycling, and Recharging.
R1 Fundamentals of Refrigeration
Climate Control Systems Service Air Conditioning System Service
Pneumatic and Hydraulic
Cooling System Get the engine up to optimum operating Temperature as quickly as possible and maintains it at that temperature. Controls the heat produced.
R1 Fundamentals of Refrigeration
High Pressure Appliance Leak Detection
R1 Fundamentals of Refrigeration
Small Appliance Recovery Requirements
SAFETY, TOOLS & EQUIPMENT, SHOP PRACTICES
Instructions: Adding refrigerant fluid to system
Leaky Appliance Trigger Rate
EPA Dates.
Cooling System Get the engine up to optimum operating Temperature as quickly as possible and maintains it at that temperature. Controls the heat produced.
Automotive Technology Principles, Diagnosis, and Service
Presentation transcript:

CCNA1 v3 Module 9 v3 A+ Type 1 JEOPARDY K. Martin

CCNA1 v3 Module 9 RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands Type 1 Type 1 a Type 1 b Type 1 Type 1 c Type 1 Type 1 d Type 1 e Type 1 Type 1 f ► ► ► F i n a l J e o p a r d y ◄ ◄ ◄

CCNA1 v3 Module 9 Question If EPA regulations change after a technician become certified, he must: Type 1 a 100 A: What is comply with any future changes in the law? CCNA1 v3 Module 9

Question A: What is When the compressor does not run? Using the system-dependent (passive) recovery process, when should you access both high and low sides of the system for recovery? CCNA1 v3 Module 9 Type 1 a

CCNA1 v3 Module 9 Question A: What is Nov. 15, 1993? Small appliance recovery equipment manufactured after _____________ must be EPA certified. CCNA1 v3 Module 9 Type 1 a 300

CCNA1 v3 Module 9 Question A: What is the pressure/temp chart only works if the pressure and temp are known and stable? When checking for non-condensables in a recovery cylinder, you should allow temp of cylinder to stabilize to room temp because: CCNA1 v3 Module 9 Type 1 a 400

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is non-pressurized container? A standard vacuum pump designed for evacuation and dehydration can be used as a recovery device only on a: Type 1 a 500

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is the type of refrigerant in the system? Before beginning refrigerant recovery, it is always necessary to know: Type 1 b

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is a non pressurized container? The system-dependent (passive) recovery process for small appliance captures refrigerant into a: Type 1 b 200

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is a pressurized recovery tank? The self-contained (active) recovery process for small appliance captures refrigerant into a: Type 1 b 300

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is 80% on both? Small appliance recovery equipment made BEFORE Nov must recover _____% of refrigerant on operating and _____% on non-operating compressors. Type 1 b 400

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is 80% on non-operating and 90% on operating compressors? Small appliance recovery equipment made AFTER Nov must recover _____% of refrigerant on operating and ______ % on non-operating compressors. Type 1 b 500

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is heat the compressor and strike it with a rubber mallet? When recovering refrigerant into a non- pressurized container and compressor is not working, you need to: Type 1 c 100

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is recovered if it’s a regulated refrigerant? When filling a graduated charging cylinder, refrigerant vented off top of cylinder must be: Type 1 c 200

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is for refrigerant leaks and oil level? What recovery equipment recovery practices should be performed on a regular basis? Type 1 c 300

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is service valve? All appliances must have a __________ __________ valve for recovering and charging refrigerants. Type 1 c 400

CCNA1 v3 Module 9 4 Question CCNA1 v3 Module 9 A: What is check vacuum pump for leaks, check recovery device for leaks, check amperage draw of recovery device Recovery equipment fittings must be equipped with ____ ______ fittings, which can be manually or automatically closed. Type 1 c 500

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is pressure / temp chart ? One way to identify refrigerant is by using the : Type 1 d 100

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is self-contained or system-dependent? For small appliances, you may use either a _____-__________ or a ______-_________ recovery system. Type 1 d 200

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is tank inlet valve? Before opening a self-contained recovery device, make sure the _________is open. Type 1 d 300

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is excessive air or noncondensables? Before opening a self-contained recovery device, make sure the tank does not contain _________ or ___________. Type 1 d 400

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is a checking pressure inside the tank? Checking for air and noncondensables can be done by: Type 1 d 500

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is high side of the system? When using a system-dependant recovery process with an operating compressor, run the compressor and recover from the: Type 1 e 100

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is access both high and low sides of the system? When using a system-dependant recovery process with an non-operating compressor, you may need to: Type 1 e 200

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 What is defrost heater? Operating the _____________ will help to vaporize any trapped liquid refrigerant and will speed the recovery process. Type 1 e 300

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is ammonia, hydrogen, water, methyl formate, methyl chloride, and sulfur dioxide? Which refrigerants are not covered by EPA? Type 1 e 400

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is a straight piece of tubing with a piercing valve? What does a service aperture on a small appliance typically look like? Type 1 e 500

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What are not opening the tank inlet valve or having excess air? What are 2 things that can cause high discharge pressure: Type 1 f 100

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is room temp? What temp must a cylinder be at to check for excess air? Type 1 f 200

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is can be manually or automatically closed when disconnecting hoses to prevent refrigeration loss? Low loss fittings are required on recovery equipment. What do they do? Type 1 f 300

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What is self-contained or system dependant? These 2 types of recovery devices can be used on small appliances: Type 1 f 400

CCNA1 v3 Module 9 Question CCNA1 v3 Module 9 A: What are Those used in campers, recreational vehicles, or in systems built before 1950? Which refrigerants are not covered in EPA 608? Type 1 f 500

CCNA1 v3 Module 9 Question A: What is 132 Mb using a 32 bit bus and 264 Mb using a 64 bit bus? Data transfer performance using a PCI bus. Final Jeopardy CCNA1 v3 Module