SIP GW Loopback Step By Step Programming Guide Rev0.1 6 Aug., 2013

Overview 2

Overview SIP GW Loopback This SIP GW Loopback is used for demonstration purpose if there is no actual Trunk. The AK for IP Trunk is required. DID table: 4770101 -> 101 4770102 -> 102 4770103 -> 103 4770104 -> 104 4775801 -> 5801 (DISA) Virtual CO V-SIPGW Loopback NS1000 MPR(192.168.0.101) DSP(192.168.0.102-105) Extension No.101 CLIP : 4770101 Extension No.102 CLIP : 4770102 Extension No.103 CLIP : 4770103 Extension No.104 CLIP : 4770104

Step by Step Programming 4

Set up of SIP GW Loopback 1-a. Install V-SIPGW16 1-b. Change card status to “Ous” 1-c. Select “Port Property” 1-a 1-b 1-c

Set up of SIP GW Loopback 2. Set Channel Attribute, SIP Server IP Address and SIP Server Port Number 2-a. Select “Main” 2-b. Select “Basic channel” for Port1 2-c. Select “Additional channel for Slot 31 Ch1” for Port 2-8 2-a 2-b 2-c

Set up of SIP GW Loopback 2. Set Channel Attribute, SIP Server IP Address and SIP Server Port Number 2-d. Set “192.168.0.101”(PBX IP Address) to SIP Server IP Address 2-e. Set “35060” to SIP Server Port Number 2-d 2-e

Set up of SIP GW Loopback 3. Set Account Information 3-a. Select “Account” 3-b. Set “12345” to User Name 3-c. Set “12345” to Authentication ID 3-d. Set “12345” to Authentication Password 3-a 3-b 3-c 3-d

Set up of SIP GW Loopback 4. Change Register Ability 4-a. Select “Register” 4-b. Change Register Ability to “Disable” 4-a 4-b

Set up of SIP GW Loopback 5. Change From Header 5-a. Select “Calling Party” 5-b. Change From Header - User Part to “PBX - CLIP” 5-c. Click “OK” 5-a 5-b 5-c

Set up of SIP GW Loopback 6-a. Change card status to “Ins” 6-a

Set up of DDI / DID Table and CLIP ID 1. Set DDI / DID Table 1-a. Select “DDI / DID Table” 1-b. Assign DDI / DID Number and Destination Ex.) Number : 4770101, Destination : 101 1-c. Click “OK” 1-b 1-a 1-c

Set up of DDI / DID Table and CLIP ID 2. Set CLIP ID 2-a. Select “Extension Settings” 2-b. Select “CLIP” 2-c. Assign CLIP ID for each Extensions Ex.) 4770101 for Extension 101 2-d. Click “OK” 2-b 2-c 2-a 2-d

END

Modification 20130806-00 SIP GW loopback for Demo SetUp_SBSGuide_6Aug2013 Odaguchi.pptx Initial Draft 15