Start up: 1. Power off and insert a GSM card, power on and check the GSM signal on the LCD. 2. Use the LCD and keys on the module to check and set the IP, whenever the IP is changed, it is needed to reset this module – by pressing the four keys at the same time. 3. Use PC to ping this module, see if it is successful (set IP of PC on the same segment as the one of SMS module) NOTE: Ethernet port of it can be used for configuration and controlling, but HDL-BUS port of it can only be used for controlling. SB-DN-SMS/IP Insert SIM card GSM signal

SB-DN-SMS/IP 2. Set the national code number, such as China: 86, you can find in the internet 1. Fill in service no. – contact your telecom provider if you don’t know it. Warning: the service no. is very import, it is a key configuration before the SMS module can send out any message.

SB-DN-SMS/IP Setup the targets, e.g., light on, AC on, curtain closed… Edit message If the SMS module received a correct message, it will trigger the corresponding targets Note : case sensitive, uppercase and lowercase are different.

SB-DN-SMS/IP If checked, you can get a feedback after controlling. If checked, only authorized numbers have the right to control HDL system. Save

SB-DN-SMS/IP Another way to control SMS module: message with fixed format Example of Message format Authorize some phone numbers

SB-DN-SMS/IP When receiving different universal switch numbers, the SMS module can send out different messages to the preset cell phones. Universal switch numbers Authorize some phone numbers save messages

SB-DN-SMS/IP Message format: Add number e.g., Add Delete number e.g., Del Delete number via index e.g., Sub1 Clear all temporary numbers Empty Temporary number management In the “Temporary Management” tab, you can also set a master number, which has the authority to send messages to SMS module to add or delete temporary phone numbers.