1 DCS MANUFACTURERS MEETING NOVEMBER 9, 2006 Peter Woolner Mitretek Systems 703-610-1724 100/300 Auto Detect.

Slides:



Advertisements
Similar presentations
1 Chelmsford Amateur Radio Society Advanced Licence Course Anthony Martin M1FDE Slide Set 9: v1.0, 24-Aug-2004 (4) Receivers-1 - Parameters Chelmsford.
Advertisements

Florida Institute of technologies ECE 5221 Personal Communication Systems Prepared by: Dr. Ivica Kostanic Lecture 15: Capacity of CDMA systems Spring 2011.
4/11/20151 Mobile Computing COE 446 Wireless Multiple Access Tarek Sheltami KFUPM CCSE COE Principles.
Dynamic Sensitivity Control V2
Multiple Access Techniques for wireless communication
DCPR FREQUENCY PLANS DCS MANUFACTURERS MEETING NOVEMBER 10, 2004 Peter Woolner Mitretek Systems
Collocation Interference 1 WRAP 0859G. Collocation Interference WRAP calculates all potentially dangerous frequencies due to: –Intermodulation –IF breakthrough.
ECE 5233 Satellite Communications
NTIA TRANSMIT SPECTRUM REQUIREMENTS FOR THE REVISED DCPRS CERTIFICATION STANDARDS DCS MANUFACTURERS MEETING NOVEMBER 10, 2004 Peter Woolner Mitretek Systems.
Digital Power Measurements Demystified Presented by Sunrise Telecom Broadband … a step ahead.
TD-SCDMA.
EE360: Lecture 15 Outline Cellular System Capacity
Reliability and Channel Coding
Cellular System Capacity Maximum number of users a cellular system can support in any cell. Can be defined for any system. Typically assumes symmetric.
Co-Channel Interference
Superheterodyne Receiver RF Front End (Amps, Filters) Local Oscillator Mixer IF Strip (Amps, Filters) Channel SelectivityService Band Detector (Demodulation)
Ron Milione Ph.D. W2TAP W2TAP InformationModulatorAmplifier Ant Feedline Transmitter InformationDemodulatorPre-Amplifier Ant Feedline Receiver Filter.
Receiver Sensitivity Sensitivity describes the weakest signal power level that the receiver is able to detect and decode Sensitivity is dependent on the.
TRANSMIT SPECTRUM ISSUES MANUFACTURERS MEETING AUGUST 2004 Peter Woolner Mitretek Systems
Satellite Microwave MMG Rashed Sr. Lecturer, Dept. of ETE Daffodil International University.
4/11/40 page 1 Department of Computer Engineering, Kasetsart University Introduction to Computer Communications and Networks CONSYL Transmission.
Tuning the Carrier Sensing Range of IEEE MAC Jing Deng,Ben Liang and Pramod K. Varshney Univ. of New Orleans Globecom 2004.
Analysis of Phase Noise in a fiber-optic link
1 Responses to Vendor Comments DCS MANUFACTURERS MEETING NOVEMBER 9, 2006 Peter Woolner Mitretek Systems
Conclusions Goal is to determine: –if Bessel or RRC filters better for DCS? –can -25 dBC sidelobe requirement be met? Still a work in progress, found it.
1 DCPR Power Ranges Proposed for CS v.2.0 DCS Manufacturers Meeting June 13, 2007 Peter Woolner Noblis
1 PETER WOOLNER MITRETEK SYSTEMS KAY METCALF NOAA GOES DCS PROGRAM MANAGER NOAA DECISION BRIEFING STIWG AND TWG NOVEMBER 7-8, 2006 ASHEVILLE, NC.
Multimedia Support for Wireless W-CDMA with Dynamic Spreading By Ju Wang Mehmet Ali Elicin And Jonathan C.L. Liu Lecture by Seth Caplan.
Spread Spectrum Interference 1 WRAP 0975C. Spread Spectrum Interference in WRAP DS: Direct Sequence systems. Resulting S/I after de- spreading: S/I despread.
1 EE 499 Wireless Communications Project by Team 4: Arati NagarkarHemant Samtani Supriya HerwadkarChinmay Shete Shivani KaushalSalil Sawhney.
KFPA LO Modifications (from single pixel results) Critical Design Review January 30, 2009 G. Anderson.
Amplitude Modulation 2.2 AM RECEIVERS
1 Analog/Digital Modulation Analog Modulation The input is continuous signal Used in first generation mobile radio systems such as AMPS in USA. Digital.
Project: IEEE P Working Group for Wireless Personal Area Networks(WPANs) Submission Title: Link Budget for m Date Submitted: 5 March 2012.
1 DCPRS CERTIFICATION STANDARD STATUS DCS MANUFACTURERS MEETING MAY 18, 2006 Peter Woolner Mitretek Systems
CHAPTER 2 Amplitude Modulation 2-3 AM RECEIVERS. Introduction AM demodulation – reverse process of AM modulation. Demodulator: converts a received modulated-
1 © 2006 Nokia pullola_ ppt / Extending Base Station Active Radio Link Set for Improved Uplink Scheduling Esa-Pekka Pullola Supervisor:
1 DCS MANUFACTURERS MEETING NOVEMBER 9, 2006 Peter Woolner Mitretek Systems Link Budgets.
Dept. of EE, NDHU 1 Chapter Five Communication Link Analysis.
Doc.: IEEE /0530r1 Submission November 2007 Gerald Chouinard, CRCSlide 1 Wireless Microphone Sensing IEEE P Wireless RANs Date:
SWE-DISH SATELLITE SYSTEMS
RF Propagation No. 1  Seattle Pacific University Basic RF Transmission Concepts.
1 THE GOES N GENERATION SATELLTES April 27, 2004 Peter Woolner, Mitretek Systems.
Options for Data Distribution in the GOES-R Series GOES User Conference SESSION 5 Peter Woolner / Mitretek.
CHAPTER 2 Amplitude Modulation 2-3 AM RECEIVERS. Introduction AM demodulation – reverse process of AM modulation. Demodulator: converts a received modulated-
DCPR TRANSITION FROM GOES I/M TO GOES N/P: A UNIQUE OPPORTUNITY FOR POWER REDUCTION DCS MANUFACTURERS MEETING NOVEMBER 9, 2006 Peter Woolner Mitretek Systems.
Coexistence in heterogeneous networks Discuss the interference issue
Chapter 1 : Part 3 Noise. Noise, interference and distortion  Noise  unwanted signals that coincide with the desired signals.  Two type of noise: internal.
Basic Satellite Communication (3) Components of Communications Satellite Dr. Joseph N. Pelton.
Doc.: IEEE /0018r0 Submission March 2006 Steve Berger, TEM ConsultingSlide 1 Exploration of Structure for IEEE P Recommended Practice for.
Chapter 4_ part 1b Baseband Data Transmission EKT 357 Digital Communications.
Certification Standards V.2 Peter Woolner Noblis May 20,
Communication Link Analysis Pranesh Sthapit Chapter 5.
Ramesh Kumar lama  System noise temperature  Radio maps of sky  Sample link analysis  Link Budget details  Receiver figure of merit  Received.
Summary of DCS Manufacturers Meeting March 22/23, 2004 Peter Woolner Mitretek Systems
Fundamentals of Communications. Communication System Transmitter: originates the signal Receiver: receives transmitted signal after it travels over the.
ECE 5233 Satellite Communications
EARTH SEGMENT & SPACE LINK
TIA-1083-A and C63.19 Magnetic Interference Requirements Compared
Satellite uplink and downlink Analysis and Design
Impact of reciprocal mixing on WUR performance
Amplitude Modulation 2-3 AM RECEIVERS
Everything You Ever Wanted to Know About Spacecraft Link Budgets . . .
5G Micro Cell Deployment in Coexistence with Fixed Service
Rishi Mohindra MAXIM Integrated Products
CHARACTERISTICS OF RADIO RECEIVERS
EVM vs PER Plot Not Promising for PSNI
Amateur Extra Q & A Study Pool
doc.: n Jeff Gilbert Atheros Communications
A. The output power might be too high
Presentation transcript:

1 DCS MANUFACTURERS MEETING NOVEMBER 9, 2006 Peter Woolner Mitretek Systems /300 Auto Detect

2 Satellite load of 100 channels at ~48 dBmi Desired channel at its minimum EIRP of 47 dBmi Two adjacent channels at the average uplink EIRP of 48 dBmi, one at the minimum allowed frequency separation Both adjacent channels have worst case sideband power distribution Interference Assessment

3 Calculation Steps Calculate worst case frequency separation Integrate sideband power in the desired signal’s noise bandwidth Add this interference to the thermal noise Calculate C/N0 reduction (< 1 dB) Calculate remaining margin (~0.3 dB)

4 Results 300 bps links cannot harm 100 bps links 100 bps links might exceed the parameter levels that could harm a 300 bps link but I believe this is very unlikely If needed, adjacent channels can now be checked for their relative performance Wallops reception would still have ~6 dB margin

5 Conclusions There is no RF reason to prevent any DCPR channel being used at 100 bps and 300 bps signals intermixed in any ratio The demodulators must be able to identify each signal correctly Is a change needed to the DAPS?