PRESENTED BY L.PAVAN KUMAR REDDY (08R01A0441) UNDER GUIDENCE OF Mrs. G.SWATHI

MOBILE HARDWARE Mobile hardware deals with following modules:  Mobile architecture(sectional wise)  Types of ICs used in mobiles  Mobile Flashing Technique  Mobile repairing tools

BLOCK DIAGRAM OF MOBILE ARCHITECTURE

Mobile architecture contains four sections 1)Power supply section 2)Logic section 3)User interface section 4)Signal processing section

Power supply section This section contains  Battery 1. Ni-MH battery (5.2 volts) 2. Li Ion battery (4.8 volts)  Power supply controller  Charging IC  SIM module

LOGIC SECTION This section contains  CPU  Flash ROM

USER INTERFACE SECTION This section contains:  Display(LCD)  Keypad and keypad LEDS

 Buzzer(Ringer)  Vibrator

SIGNAL PROCESSING SECTION This section contains:  Antenna  Speaker  Microphone

TYPES OF IC’S USED IN MOBILES  Ringer IC  Power IC  RF IC  Power amplifier  USB controller IC

MOBILE FLASHING  Flashing is performed using Flasher.  Flasher is a professional device that flash-upgrade & removes SIM/phone/user lock working with a wide range of mobile phone models.  Flashing can be performed using these devices.

MOBILE REPAIRING TOOLS Following tools are used for mobile repair:  Hot air work station  Solder station

 Tool set(screw drivers)  Microscope  Lens  Multi-meter

LCD TESTER  LCD TESTER can be used to inspect the quality serial LCD which are both original & OEM, single screen & with board.  Features:  Inspect color and definition of display.  Operating is fast and easy.

FLEX CABLES  Flex cables serves as internal buses within the mobile unit.  Features:  Allows to performs multi-functions.  Video calling can be achieved.  Advantages:  Avoids use of large set of wires.

JUMPER SECTION OF NOKIA 6300  Jumper is used for connecting different parts of mobile whenever faults occurs.  Jumper can used to solve following problems:  Network  Keypad LEDs  Microphone  Headset pin

TOUCH SCREEN  New technology in mobiles is used to replace keypad with touch screen.  Advantages: 1.Hardware requirement is reduced. 2.Accessing is fast and easy.

IMPROVEMENT IN TECHNOLOGY