6832 –7.00 Proper use of tools

Handle Files should have a ______ to prevent hand injuries.

Forward Pressure should be applied on the ______ stroke when filing or cutting.

3 teeth At least ______ teeth should be in contact with the metal when using a hacksaw.

Combination A ____________ wrench can turn both square and hex headed nuts.

Thickness gauge Checks clearances between parts such as valve gaps.

Wire gauge Used to check the gap of a spark plug.

Micrometer Used to measure the depth, the inside diameter or the outside of metal objects.

Depth Micrometer Used to measure to bottom of holes or slots.

Inside micrometers Used to measure brake drums, cylinder bore and bushings

Outside micrometer Measures the outside of rods

Thimble and barrel Major two parts of the micrometer

Drill press Most accurate type of drill ( more accurate than a hand drill)

Chuck Drill size is determined by the opening of the __________

1/8‘’ The space between the grinding wheel and the guard should be no more ______ inches

Edge When using a square to mark a 90 line hold the square firmly against the _________.

Awl (Scratch) A _________ is used to make a permanent mark on metal or wood

Soapstone _____________ is used to make a temporary mark on metal.

Cutting Oil ___________ is used to lubricate tools to keep from overheating and becoming dull.

Disconnect the power Before making any repairs on electric equipment ________ the ______.

Decreased Pressure should be _________ just before a bit breaks through metal.

Waste When cutting a board to correct length cut on the _______ side of the marked line.

Short Cutting out the mark will may the board too _______.

Supported w/a stand Once a piece of equipment is jacked to the desired height it should be _______ with a __________.

Extension cords ______________ _______ should be heavy duty and not as permanent wiring.