Status of MobiDICK 4 Vinícius Barbosa Schettino 1.

Slides:

Advertisements

Similar presentations

L. Greiner 1HFT PXL LBNL F2F – March 14, 2012 STAR HFT The STAR-PXL sensor and electronics Progress report for F2F.

Advertisements

Presents The Silver Family An Integrated Approach to Processors, Data Communication and Head End Integration.

LSV2 Autonomous Chargers Design Team: (from the left) Branden Carpenter Wayne Romine Jon Stoker Dr. Hess (Advisor) Maggie Richardson.

D EVELOPMENT & T ESTING : ADC BOARD FOR THE P ROMETEO T EST - BENCH MATTHEW SPOOR University of the Witwatersrand HEPP 2015.

Status of the Optical Multiplexer Board 9U Prototype This poster presents the architecture and the status of the Optical Multiplexer Board (OMB) 9U for.

Students:Gilad Goldman Lior Kamran Supervisor:Mony Orbach Part A Presentation Network Sniffer.

Using FPGAs with Embedded Processors for Complete Hardware and Software Systems Jonah Weber May 2, 2006.

Natasha Benko, Kevin Jacobsen, Marcus LaRose, Scott Timme October 14, 2009 Our design will automatically calibrate your speedometer according to tire size.

Introduction to Prototyping a LED Driver Part I: Driver Design and Component Selection September 24-28, 2012 Carol Lenk.

R&D Design Center. Main activities 1. Alpha-Resources R&D Design Center provides: Embedded software development. Drivers development. Low-level programming.

3D RGB LED Cube Group 15 Luke Ausley BSEE Joshua Moyerman BSPE Andrew Smith BSPE Sponsored by Stellascapes 1.

RGB LED Cube Team 15: C an’t U ndo B ad E lectrons Luke Ausley BSEE Joshua Moyerman BSPE Andrew Smith BSPE Sponsored by Stellascapes.

TE/MPE/EE J. Mourao T/MPE/EE 1 November 2012 LHC Machine Local protection Redundant Power supply (DQLPUR) - Review.

31st July 2008AIDA FEE Report1 AIDA Front end electronics Report July 2008 Progress Virtex5 FPGA choice Milestones for prototype delivery.

Wir schaffen Wissen – heute für morgen 24 August 2015PSI,24 August 2015PSI, Paul Scherrer Institut Status WP 8.2 RF Low Level Electronic Manuel Brönnimann.

Group Members: Brad Cox Kevin Burkett Tera Cline Arthur Perkins CS10 Battery Management System.

Status Report of CN Board Design Zhen’An LIU Representing Trigger Group, IHEP, Beijing Panda DAQ Meeting, Munich Dec

PowerPC System Design Final Report Group 8 Kyle Brady Rebecca Hansen Ray Harlan Ian Remmler.

ATCA based LLRF system design review DESY Control servers for ATCA based LLRF system Piotr Pucyk - DESY, Warsaw University of Technology Jaroslaw.

TE/MPE/EE J. Mourao T/MPE/EE 1 November 2012 LHC Machine Local protection Redundant Power supply (DQLPUR) & interface Module (DQLIM) progress status.

Status and planning of the CMX Wojtek Fedorko for the MSU group TDAQ Week, CERN April , 2012.

Mobile DAQ Testbench ‘Mobi DAQ’ Paulo Vitor da Silva, Gerolf Schlager.

Status report on the development of a readout system based on the SALTRO-16 chip Leif Jönsson Lund University LCTPC Collaboration Meeting

FEE Electronics progress PCB layout progress VHDL progress in TBU Prototype fixtures FEE64 commissioning A few of the remaining tasks 16th July 2009.

An Architecture and Prototype Implementation for TCP/IP Hardware Support Mirko Benz Dresden University of Technology, Germany TERENA 2001.

BWS electronics design status J.Emery & Luca, Pierre-Jean, Emiliano, Jose, Alexander and all past contributors!

A Hardware Based Cluster Control and Management System Ralf Panse Kirchhoff Institute of Physics.

PSD upgrade: concept and plans - Why the PSD upgrade is necessary? - Concept and status of the PSD temperature control - Concept of the PSD analog part.

Status Report #4 LYRA The Remote Accessible Automated Camera Stand Developed by: Juan Cuellar, Nathan Dye, Timothy Hawley, & Matthew Hect October 8, 2012.

Abstract A small portable test system for the TileCal Digitizer system Attila Hidvégi (1), Daniel Eriksson (1) and Christian Bohm (1) (1) Fysikum, Stockholm.

FEE Electronics progress Mezzanine layout progress FEE64 progress FEE64 initial testing Test mezzanine. A few of the remaining tasks 2nd October 2009.

© 2015 Wind River. All Rights Reserved. Integrating FACE™ Aligned Componentry Larry Kinnan Principal Technologist, Wind River.

9/12/2003Ivan Hruska1 First box prototype –Box design in July ‘03 –Box produced during August ’03 Tested last week in few fingers Small changes necessary.

PSD upgrade: concept and plans - Why the PSD upgrade is necessary? - Concept of the PSD temperature stabilization and control - Upgrade of HV control system.

FSAE Engine Management System Adolfo Pereira Donald Zucaro Lee McDade Jeremy Belge Sun-Jet Liu Marcin Trelinski Advisor: Dr. Alan Nye Sponsor: FSAE Formula.

TRANSMISSION LINE MULTIPLE FAULT DETECTION AND INDICATION TO EB

MobiDick4 progress report Carlos Solans. Introduction MobiDICK is a complete test bench for super-drawers Will be used during the maintenance in the long.

Status of MobiDICK 4 Vinícius Barbosa Schettino on behalf of the MobiDICK 4 group.

Status of the Mother Board MobiDICK 4 Fernando Carrió Argos.

Status of the Mother Board MobiDICK 4 Fernando Carrió Argos.

Status of the Mother Board MobiDICK 4 Fernando Carrió Argos.

E. Hazen1 AMC13 Status E. Hazen - Boston University for the CMS Collaboration.

T. Gorski, et al., U. Wisconsin, April 28, 2010 SHLC RCT MicroTCA Development - 1 SLHC Cal Trigger Upgrade SLHC Regional Calorimeter Trigger MicroTCA Development.

2007/11/16 Dinh Trong Thuy RTLab

DAQ / Trigger Card for HCAL SLHC Readout E. Hazen - Boston University

Status of the DSP/ASPOC EM

New active filter for COSY dipole power converter

Upgrade activities at Clermont-Ferrand

Current DCC Design LED Board

INSIDE – Update meeting

Radius disco Radius agujero Motor Controller Sensor Motor soporte.

TileCal upgrade EVO meeting Demonstrator tesks

THE PROCESS OF EMBEDDED SYSTEM DEVELOPMENT

Status of the Front-End Electronics and DCS for PHOS and TPC

OPNFV: Support for HA Guest APIs: Introduction

Hall A Compton Electron detector overview

TPC Large Prototype Toward 7 Micromegas modules

Blanco 4M F8sec Upgrade.

Table 1: The specification of the PSICM and the ePSICM Prototypes

AN ENVIRONMENT FOR REMOTE CONTROL

Combiner functionalities

University of California Los Angeles

Chapter 2: The Linux System Part 1

Jason Gilmore Vadim Khotilovich Alexei Safonov Indara Suarez

FEE Electronics progress

Operating System Introduction.

Status Report #5 LYRA The Remote Accessible Automated Camera Stand

LED Board for the Tile Calorimeter of the ATLAS Detector at the LHC

Command and Data Handling

SP Main FPGA & DT transition card design status

Presentation transcript:

Status of MobiDICK 4 Vinícius Barbosa Schettino 1

Introduction MobiDick is a testbench used to provide full certification of the super-drawers during maintenance periods The system is currently in it’s third version, and the goal is to have a fourth one ready to use for the long shutdown, in 2013 The motivation to this new version is that it should be smaller and lighter, while using new technologies. It will provide better movability and make the system more reliable 2

System Overview 3

High Voltage and LED Driver boards Schematics done (Michel Crouau) Layout done (Michel Crouau) PCB being produced at Clermont Ferrand 4 HV boardLED Driver board

ADC Trigger board Schematics done (Vinícius Schettino) Layout done (Vinícius Schettino) PCB being produced at IFIC 5

CAN Bus Schematics done (Fernando) Layout done (Fernando) Already produced at IFIC Mounting components 6

Power Supply Board Schematics done (Fernando) Layout done (Alberto) Already produced at IFIC Mounting components 7

Main Board Working on Linux embedding (Fernando) Decision for real PowerPC 440 inside the Virtex5 Adopted implementation: Xilkernel 5.00 – Task scheduler – POSIX API – Xilinx support – Simple/robust – C /C++ – Easy maintenance Extended with: lwIP – TCP/IP stack – Open source – Socket API 8

Glue software Daemon running in motherboard to communicate with Willy (Ali, Gang, Vinicius) Documentation of existing version of the code ongoing 9

People Involved High Voltage board Led Driver Trigger ADC board Xilinx ML507 – Firmware – Embedded Linux Power Supply Board Glue Software – Interface with Willy Software Mechanics (box) 10 Michel Crouau (CF) David Calvet (CF) Vinícius Schettino (UFJF) Fernando Carrió (IFIC-UV) Stockholm University LIP (Portugal) Gang Qin (IFIC-UV) Ali Abdallah (IFIC-UV) Vinícius Schettino (UFJF) Alberto Valero (IFIC-UV) Fernando Carrió (IFIC-UV) Carlos Solans (IFIC-UV) Irakli Minashvili (Dubna)