DATABASE ARCHITECTURE PROPOSAL Fabien Jeanneau – 19 jan 2015

Common database centralized at Cern Based on the PBS Elements of the database: – Identifier – Position in the tree – Documentation file – Quick access parameters (visible at the upper level) – Flag if accepted while out of specs – …

Architecture # MODULE # D/PCB # RO/PANEL# D/PANEL # RO/PCB #WASHER #RO/PCB #IC #FRAMES #INSERT #PIN #COOLING #THERMAL/INS #TAPE #GLUE #D/PCB #IC #FRAMES #MESH #GAS/T #TAPE #GLUE #RO/PANEL #D/PANEL #DGAP/FRAME #IC/ENDCAP #PIN #ORING #SCREW

PCB #RO/PCB – Manufacturer and QC files: Relative position of strips wrt rasmasks/targets Rectitude and parallelism of strips Pillar height Thermal cycles Resistivity Other defect (bubbles, …) – Parameters: PCB thickness Cuts, shorts Precision holes (position, circularity, …) – Dependencies: #WASHER (for PCB positioning) #D/PCB – Manufacturer and QC files – Parameters: PCB thickness #WASHER -Manufacturer and QC files -Parameters: -Position / strips

Panels #RO/PANEL – Manufacturer and QC files – Parameters: Planarity Parallelism Thickness Strip alignment side/side – Dependencies: #RO/PCB, #IC, #FRAMES, #INSERTS, #PIN, #COOLING, (…) #D/PANEL (with mesh) – Manufacturer and QC files – Parameters: Planarity, Parallelism, Thickness Drift distance Mesh frame thickness – Dependencies: #D/PCB, #IC, #FRAMES, #MESH, #GAS/T, (…)

Quadruplet #MODULE – Manufacturer and QC files – Parameters: R/O strips alignment Gain homogeneity / plan Cosmic rays test Assembly scheme (panels order) Thickness and parallelism (?) – Dependencies: #DGAP, #ORING, #SCREW, #IC/ENDCAP, …

Components (parameters) #IC – Thickness #IC/ENDCAP #FRAMES – File: position in the panel – Parameters: Thickness, Twist #MESH – Tension (on transfer frame) #COOLING/TUBES (like #FRAMES) #TAPE – Lot number #GLUE – lot number – Expiration date #GAS/T – Lot number #WASHER #INSERT (and #PIN) – Position, perpendicularity, diameter, … #THERMAL/INS – Lot number #ZEBRA/POS #COOLING/PLATE #DGAP – Lot number – Thickness – Corners ID #ORING #SCREW

Files Assembly check list and notes Version of drawings List of operations (procedures and controls) Problems, defects and decision process Quick access parameters Specifications Delivery receipt (if available) Logistics information (time dependent)

Include in DB the integration phase: – Elx – Alignment platforms – Mounting on wheel – … Module localization and on-going activities Definition of ID: – Size of the piece – Bar code? – Batch of pieces (screws, glue, oring, …