AIR-CONDITIONING DUCT NETWORK Balázs BOTH D008 (Ventilation Laboratory) Budapest University of Technology and Economics.

Slides:

Advertisements

Similar presentations

::Manual of Construction::. MENU OF THE MANUAL 03 Cutting the panels 07 Straight duct 08 Elbow 10 End cap 01 Bases of the system 04 Type of strips 05.

Advertisements

Power Plant Construction and QA/QC Section 5.2 – Combustion Control and Burner Management Engineering Technology Division.

Heating and Air Conditioning I

System Effects Presented by: Joe Brooks, AMCA International, Inc. AMCA International Technical Seminar 2009.

Introduction of SzIE YMMFK Prof. Dr. Telekes Gábor principal director Prof. Dr. Telekes Gábor principal director.

ME 150 Engineering Drawing 1 Lab 3: 2D Sketch (2) 1 Umm Al-Qura University College of Engineering & Islamic Architecture Mechanical Engineering Department.

Aircraft Faculty Cheremnykh Alexander S-52NSTU. Plan 1. Specialities 2. History 3. Advantages of training 4. Particulars of Faculty.

Part F Practical Applications. 29. Flow over a Heat Sink Physical System Pressure drop and heat transfer characteristics of heat sinks are determined.

Saving Ventilation Dollars A Look at Economics of Ventilation.

© American Standard Inc Fan Pressure Optimization The Trane Company.

TEAM UP! FOR FAN AND PUMP SAVINGS It can be as easy as replacing an old drive belt.

The International Authority on Air System Components Fan Performance Mark Stevens Director of Laboratory Services AMCA International.

Recent FETS Ion Source Measurements UK Neutrino Factory Plenary Meeting 8-9 June 2010 Rutherford Appleton Laboratory Dan Faircloth Faircloth.

Robust Reinforcement Learning Control Chuck Anderson, Matt Kretchmar, Department of Computer Science, Peter Young, Department of Electrical and Computer.

CHEMICAL ENGINEER Prepared by: Paula Janicka

The Islamic University of Gaza Faculty of Engineering Civil Engineering Department Hydraulics - ECIV 3322 Chapter 6 Open Channel.

November Top Ten Approaches to Lowering Fan Energy in Cleanrooms.

Faculty of Applied Engineering and Urban Planning

KOCAELI UNIVERSITY FACULTY OF TECHNOLOGY Prof.Dr Engin OZDEMIR Department of Energy Systens Engineering Faculty of Technology, Kocaeli University Kocaeli-TURKEY.

Cross Sections. Warm Up On a separate piece of paper, try to draw a triangle with side lengths of 3 centimeters and 6 centimeters, and an included angle.

1 Manufacturing process II. Manufacturing process II. Sándor Pálinkás Ph.D. assistant lecturer University of Debrecen, Faculty of Engineering, Department.

6th Summer School on “ADC & DAC Metrology” Balázs Fodor (Student) Zsolt Kollár (Student) Attila Sárhegyi (PhD Student) Budapest University of Technology.

2 First academic year students 600 first-year students in the last academic year 200 graduated in the last year 1600 graduated since 1996.

3.4 Equal friction method This method of sizing is used for supply, exhaust and return air duct system and employs the same friction lose per foot of length.

Research Activities of KTI (Institute for Transport Sciences Non-Profit Ltd.) Budapest - Hungary József PÁLFALVI dr. research director

1 Manufacturing process II. Manufacturing process II. Sándor Pálinkás Ph.D. assistant lecturer University of Debrecen, Faculty of Engineering, Department.

Flow Measurements Pitot Versus Tracer - A Utility Perspective Phil Gernenz Exelon – Braidwood Station Based upon Control Room Envelope Tracer Gas testing.

Duct Design Basics.

10-1 人生与责任淮安工业园区实验学校连芳芳 “ 自我介绍 ” “ 自我介绍 ” 儿童时期的我.

Renson and Dampers. Natural Ventilation Dampers Dampers are used to control airflow from one space to the other. Often referred to as ventilators. Used.

Mike Bailey, OSU Curriculum Council November 8, 2012 Category I Proposals for the November 2012 Faculty Senate Meeting November 8, 2012 Proposal #83185:

Title: Prevention methods development against aerosol terrorism for ventilation of Tbilisi subway Grant N Report - Numerical modeling of aerosol.

Sample Report 1 Address Date of Service: Ref Number:

ABRASIVE JET MACHINING Prepared by B.BALAMURALI AP/MECH

SMART VENTILATION BEST PRACTICES

Paper Presentation: 25 min

Duct casings for particulate filters DCA

Yahoo Mail Customer Support Number

Most Effective Techniques to Park your Manual Transmission Car

How do Power Car Windows Ensure Occupants Safety

Figure 18.1 Typical port fuel-injection system, indicating the location of various components. Notice that the fuel pressure regulator is located on.

Voyager II and III – Energy Recovery Modules

MECH 8250 – Building Systems Winter 2015

VENTILATION NOISE.

مراقبت خانواده محور در NICU

تهيئة الطالب مهنيا وتعميق معارفه . تنمية مهارات الطالب و قدراته .

VENTILATION ASPECTS OF INDOOR AIR QUALITY

دانشگاه شهیدرجایی تهران

DEPARTMENT OF MECHANICAL AND MANUFACTURING ENGINEERING

تعهدات مشتری در کنوانسیون بیع بین المللی

Communication and Electronic Engineering Department

Graphing Linear Equations

Sample Report 3 Address Date of Service: Ref Number:

بسمه تعالی کارگاه ارزشیابی پیشرفت تحصیلی

دومین کمیته مترجمین حاکمیت بالینی دانشگاه

Math 265 Sections 13.1 – 13.5 Created by Educational Technology Network

Topic of the final thesis

Topic of the diploma thesis

Pre & Post Clean Photographs

West Irondequoit Post-High School Planning Night

University of Warith AL-Anbiya’a

UNIT – I FLEXIBILITY MATRIX METHOD

LABORATORY OF PROCESS ENGINEERING

North Carolina Department of Insurance Office of State Fire Marshal

Chapter 30 Examples 4,8.

Presentation transcript:

AIR-CONDITIONING DUCT NETWORK Balázs BOTH D008 (Ventilation Laboratory) Budapest University of Technology and Economics Faculty of Mechanical Engineering Department of Building Service and Process Engineering 11 th November 2015

Straight duct Circular cross section Rectangular cross section Flexible air duct

Elbows

T-piece

Reducer piece

Controllers and measure pieces Airflow controller Airflow controllers with motor Rectangular airflow controller (damper) Iris airflow controller and orifice plate

Silencers

Heat-insulated duct elements

Thank you for the attention!