BATTFIX.COM

iPhone 6 Battery Replacement Kit and Repair Guide If your iPhone 6S battery won’t last for a full day and you tried all the tricks to fix your battery problems and still get no result? this is the right time for you to replace your iPhone 6 battery with new one There is our simple DIY guide for you to do the iPhone 6 battery replacement

Some Steps You Should Apply 1) Buy Your iPhone 6 Battery replacement Kit This kit is packed with essential tools needed for the replacement of battery like : Phillips PH00 screwdriverPhillips PH00 screwdriver Pentalobe screwdriverPentalobe screwdriver Suction cupSuction cup Plastic opening toolPlastic opening tool Battery adhesiveBattery adhesive New iPhone 6 batteryNew iPhone 6 battery 2 ) Turn off your iPhone 6 To Protect Other phone parts,Make sure that it is not on when you remove the battery.To Protect Other phone parts,Make sure that it is not on when you remove the battery.

Step 3: Unscrew the Pentalobe Screws Both sides of the Lightning port, the Pentalobe screws are placed. Unscrew them using the Pentalobe screwdriver included in the kit and put it in a safe place. You should Take care that the screws will not be misplaced or mixed with other screws.

Step 4:Use the Suction Cup to Lift the Panel Just place Suction Cup on top of the panel above the home button, and press it to suction the panel and lift. Hold the other end of the phone, specifically the upper part, with one hand and let the other Hand lift the cup. The panel will lift up little by little because it is tightly glued to the case, thus require careful but strong lifting up or pulling up of the panel through the cup.

Step 5: Use plastic tool Pry open the panel from the case by using the plastic tool. Take care prying on the inner part to detach the panel from the case so that avoid touching the other parts.

Remove the following 5 Phillips screws securing the metal cover to the motherboard. Now use the fine tip curved tweezers to disconnect the LCD, digitizer and front camera and proximity sensor cables. Remove the following 5 Phillips screws securing the metal cover to the motherboard. Now use the fine tip curved tweezers to disconnect the LCD, digitizer and front camera and proximity sensor cables.

Disconnect and remove the front panel Disconnect and remove the front panel from the unit from the unit Peel off the adhesive tab from the battery Peel off the adhesive tab from the battery Pull off the adhesive strip Pull off the adhesive strip Flip up the battery from the unit Flip up the battery from the unit Remove the old battery and replace with a Remove the old battery and replace with a new one new one Reassemble the unit Reassemble the unit Now Some Easy Steps Are :

Battery replacement can be difficult to do for some who are not familiar with the procedure. There are many authorized repair centers where the replacement is done. Contact Us For Any Help: Website URL : Social Media