ESTeem 195 Narrowband Series SECTION 11 - Wireless Serial Overview ESTeem 195 Narrowband Series

ESTeem Licensed VHF & UHF Longer Range Applications Exclusive Use of FCC Frequency Serial and Ethernet Interfaces 150-174 MHz - VHF (Complies with 2013 FCC Narrowband Mandate) 217-220 MHz – VHF (New Frequency Open for Data Radios) 450–470 MHz - UHF (Complies with 2013 FCC Narrowband Mandate) Licensed Serial and Ethernet

Model 195 Narrowband Series Layout Ethernet/RS-422 Port Reset Switch RS-232 Port RS-232 Remote Power Tri-Color Status/TX/RX LED Aux Power LED 12 VDC Input (Auxiliary Connector ) 4/20mA Sensor/ RS-485 Port Remote Power LED

Model 195M Model 195M Features 150-174 MHz Modes Narrowband - Licensed SECTION 4 - ESTeem Overview Features 150-174 MHz Narrowband - Licensed Ethernet and Serial Communications 12.5 Kbps RF data rate 0.5 - 4 Watt RF Output 10+ miles Line-of-Sight Range Internal Spectrum Analyzer Model 195M Modes Ethernet Networks; Ethernet Bridge, Telnet Console, Repeater Serial Networks; Point–Point, Point-Multipoint, Repeater PLC Protocol Emulation AB DF1/Ethernet, Modbus/TCP, Opto-22

Model 195H Model 195H Features 217 - 220 MHz Modes SECTION 4 - ESTeem Overview Features 217 - 220 MHz Narrowband - Licensed Ethernet and Serial Communications 4.8 - 50 Kbps RF data rate 0.5 - 2 Watt RF Output 10+ miles Line-of-Sight Range Internal Spectrum Analyzer Model 195H Modes Ethernet Networks; Ethernet Bridge, Telnet Console, Repeater Serial Networks; Point–Point, Point-Multipoint, Repeater PLC Protocol Emulation AB DF1/Ethernet, Modbus/TCP, Opto-22

Model 195C Model 195C Features 450-470 MHz Modes Narrowband - Licensed SECTION 4 - ESTeem Overview Features 450-470 MHz Narrowband - Licensed Ethernet and Serial Communications 12.5 Kbps RF data rate 0.5 - 4 Watt RF Output 10+ miles Line-of-Sight Range Internal Spectrum Analyzer Model 195C Modes Ethernet Networks; Ethernet Bridge, Telnet Console, Repeater Serial Networks; Point–Point, Point-Multipoint, Repeater PLC Protocol Emulation AB DF1/Ethernet, Modbus/TCP, Opto-22

Modes of Operation Serial Data Transfer Ethernet Bridge Mode Transparent PLC Emulation Modes Serial Data Transfer Point to Point/Multipoint Repeaters Supported Ethernet Bridge Mode Four 4/20mA Inputs Remote I/O

Configuration Flash Utility for all computer operating systems (Windows/Linux/Mac) Found in Tools folder of new Discovery Utility Narrowband Configuration Utility No serial port on computer required for programming Programmed through Ethernet Interface Select Data Interface (SDI) Select Mode of Operation

Serial Data Transfer RS-232 (Full and Remote 3-Wire) RS-422 RS-485 Serial Data Interface (SDI) Rockwell – DF1 Full-Duplex, DF1 Half-Duplex, DF1 Radio Modem Modbus – RTU and ASCII Modes Opto-22 DNP V3 – Power Utility Protocols PLC Emulation Modes Transparent

Ethernet Data All Ethernet device IP addresses must be listed Remote ESTeem modems and connected devices Ethernet Bridging Used to identify repeater routes Used to create “group” of IP addresses serviced by remote modems Routing and Append Tables Only IP addresses listed in routes/appends will be sent over radio link Easy “router” functionalilty Very Tight IP Address Control

Model 192 Compatibility Model 192 radio modems must be narrowband Best used at remote locations Model 195C/195M Designed for Model 192 Network Slower 9,600 bps RF data rate Runs in “Non-Native” Mode 192 Compatibility in Narrowband Utility Matches deviation level to a specific Model 192 in network Training Required

Troubleshooting Displays transmissions, retries and link down Current Receive Signal Strength (RSSI) Diagnostic Utility Enter through Utility or Telnet to IP address Packet Monitor – Displays all RF activity System Dump – Displays all interface (serial or Ethernet) activity Console Spectrum Analyzer in Utility software Analyzer Firmware version stored in each Utility version Firmware Update

Programming Tips Address, Radio ON, Connect, Disconnect, etc. See User’s Manual for complete command list Many Basic Model 192 Commands Supported in Console TCP/IP address Last Octet used for single address Example IP Address 172.16.8.(209) – Unit address = 209 Modem Address Advanced configuration Read Configuration>Change Power Level>Write Configuration Setting RF Power Level

Programming Tips PROG Command from Console – Model 192 type responses Enter Remote IP address in Utility and select Remote radial Remote Programming Right mouse click anywhere in Advanced Configuration screen Save/Load Configuration