UniBond™ ST Polyester-Faced Adhesive Tape

UniBond ST High-Performance, Fatigue Resistant, 100% Solids Polyester-Faced Adhesive Tape Designed to Seal and Reinforce Seams and Penetrations on a Variety of Metal and Single-Ply Roof Systems Compatible With: CPR™ White Revitalizer™ Metal White-Knight®/Stallion® White-Knight/Stallion Plus Cold-Applied

Benefits Seals and Reinforces Seams Long-Term Movement Compatibility Reduces Labor and Application Time Advanced Micro-Sealant Technology User Friendly Low-Temperature Flexibility

Uses Seals Metal and Single-Ply Roofs Joints Seams Tears Flashings Copings Skylights Gutters

Materials and Equipment Non-Residue, Solvent-Based Cleaner Rags or Cloth Abrasive Cleaning Pad Wire Brush Steel Weighted Roller (Optional) Scissors UniBond ST Roll

Surface Preparation Surface Must be Clean and Dry Use Non-Residue, Solvent-Based Cleaner Power Wash the Surface, Including Flashings Remove Rust and Flaking Paint Scrape, Sand, Wire Brush or Proper Media Blasting Remove All Silicone Materials Score the Surface of Single-Ply Roofs

Application Steps Locate the Area to be Sealed or Repaired Clean the Surface Remove Release Liner Apply UniBond ST Apply Pressure Inspect the Tape Apply Approved Garland Cold Process Roof Coating

1. Locate Area to be Sealed/Repaired

2. Clean the Surface Surface Must Be Clean and Dry Remove Oil, Grease, and Silicone Materials Remove Rust and Flaking Paint

3. Remove Release Liner Grab Edges with Thumb and Forefinger Then Push Fingers Together, Bunching the Tape in the Middle Quickly Snap the Tape Back and Forth 7-10 Times Push Fingers Together Again, Allowing Liner to “Pop” From the Tape Peel Liner From Tape in Short, Workable Sections

4. Apply UniBond ST Apply Tape Uniformly to the Surface to Prevent Wrinkles and Other Discrepancies Do Not Stretch Material

5. Apply Pressure Use Steel Roller or Hands to Apply Pressure Pressure Will Activate the Bonding Process & Removes Minor Discrepancies For Best Results, Use a Steel Weighted Roller

6. Inspect The Tape Ensure that UniBond ST is Uniformly Adhered Use Steel Roller to Remove Remaining Discrepancies

7. Apply Coating System UniBond ST Must Be Coated On the Day of Application Approved Cold Process Coatings Include: CPR™ White Revitalizer™ Metal White-Knight®/ White-Stallion® White-Knight/ White-Stallion Plus