Roof Insulation Adhesives: Garland’s Insul-Lock® II, Insul-Lock HR & Insul-Lock E HR Systems

Features & Benefits Ease of Installation No Deck Penetration Insul-Lock II is a Single-Component, is Pourable and Requires No Equipment Insul-Lock HR and Insul-Lock E HR are Self-Contained Two-Component and Mixed Through a Static Mixing Tip No Deck Penetration Reducing Structural Damage Moisture Entry Thermal Bridging FM Approvals* Approved with Garland Hot Asphalt, Weatherking®, Green-Lock® and Torch Systems, as an Insulation Adhesive Low Odor Insul-Lock II 50 g/l VOC Content Insul-Lock HR 0 g/l VOC Content Insul-Lock E HR 0 g/l VOC Content *Approvals are specific to construction design and products contained in the assembly. Please contact your local Garland representative for project specific approvals.

Surface Preparation The Surface Must be Clean, Sound, Dry, and Free of Any Materials That Would Inhibit Proper Adhesion of the Adhesive The Use of Scraping, Power Brooming, Vacuuming or Other Means May Be Required To Achieve a Suitable Surface For the Application of the Adhesive Cleaning Should Always Be Performed Observing Responsible Trade Practices

Application Rates Traditional Insul-Lock II Insul-Lock HR Four 1/2” to 3/4” (1.27 – 1.91 cm) 12” o.c. Beads Must be Installed with 4’ x 4’ Boards 3 Gallon Bucket Totaling 450 sq. ft. (41.8 m2) Insul-Lock HR Four 1/4” to 1/2” (0.64 – 1.27 cm) 12” o.c. Beads Must be Installed with 4’ x 4’ Boards 4 Cartridges Per Case Totaling 600 sq.ft. (55.74m2) See Application Guide for Perimeter and Corner Coverage Rates Insul-Lock E HR Application Note: Due to anticipated surface irregularities of a gravel surface roof, the application will require more adhesive than our standard rates. The standard rate is 600 sq.ft. case. Anticipated coverage rates will be in the range of 300 to 400 sq.ft. per case.

Insul-Lock II Benefits of Insul-Lock II Contractor Friendly Cures Fast Can be Applied Directly From the Container Easy to Pour Application Cures Fast Sets Up in 30-60 Minutes Versatile Decks Insulation Base Sheets

Insul-Lock HR High Rise Foam Solvent-Free Ready to Use Benefits of Insul-Lock HR High Rise Foam Accommodates Minor Surface Irregularities Solvent-Free VOC-Free and No Odor Ready to Use No Mixing Required Applied Through Static Mixing Tip

Insul-Lock E HR Solvent-Free Ready to Use Benefits of Insul-Lock E HR 45% Rapidly Renewable Material Content USGBC Credits Solvent-Free VOC-Free and No Odor Ready to Use No Mixing Required Applied Through Static Mixing Tip

Application Equipment

Summary Insul-Lock II, Insul-Lock HR and Insul-Lock E HR are Either One Or Two-Component Urethane Foamable Insulation Adhesives These Systems Provide a FM Approved Insulation Adhesive with Most Garland Roofing Systems These Systems Can Eliminate Odor Concerns on the Jobsites