REPAIRING MOULDING PROTECTOR, TRANSFER/DECORATION, STICKER AND SPOILER REPAIR MOULDING PROTECTOR, TRANSFER/DECORATION AND DECAL BODY OTOMOTIF (F-022) SK – KD 07

TARGET OF LEARNING ACTIVITY Student can know way release moulding, transfer and decal Student can know way installing moulding, transfer and decal Teknologi dan Rekayasa

WAY OF INSTALLING PART INSTALLING SIDE PROTECTION MOULDING SETTING UP TRANSFER SETTING UP DECAL OR LIS Teknologi dan Rekayasa

INSTALLING SIDE PROTECTION MOULDING Clean the surface or moulding by cleaner. Teknologi dan Rekayasa

INSTALLING SIDE PROTECTION OF MOULDING Heat body surface 40-60oC (when installing moulding, surface temperature must 20oC or more). Teknologi dan Rekayasa

INSTALLING SIDE PROTECTION OF MOULDING Heat moulding will be installed at 20-30oC (don’t use high temperature, maximal 80oC). Teknologi dan Rekayasa

INSTALLING SIDE PROTECTION OF MOULDING Smear up adhesive to outside part of moulding, the shiny part and set it up 30 minutes after smearing up adhesive Teknologi dan Rekayasa

INSTALLING SIDE PROTECTION OF MOULDING Release moulding release sheet from moulding surface Teknologi dan Rekayasa

INSTALLING SIDE PROTECTION OF MOULDING Attach moulding by setting the cover on the hole on to the bodY and press the moulding evenly. Teknologi dan Rekayasa

INSTALLING SIDE PROTECTION OF MOULDING Clean up rest of adhesive by using plastic spatula and clean up the surface with dry cloth After installing, don’t the vehicle in 24 hours BACK Teknologi dan Rekayasa

SETTING UP TRANSFER Allocate the material of transfer on panel surface. Sign up the transfer size with pencil. Make sure that material is given more than ½ inchies Drag the back part of paper from transfer material Teknologi dan Rekayasa

SETTING UP TRANSFER Use sponge, wet up the back part of transfer dan panel surface Apply the transfer on the panel quickly Teknologi dan Rekayasa

SETTING UP TRANSFER Clean up transfer surface with rubber cleaner to release the bubble Heat up if the transfer is difficult to be formatted wil the hollow on the car surface Teknologi dan Rekayasa

SETTING UP TRANSFER Use knife to cut up the rest of transfer size Set back the whole component of car being released BACK Teknologi dan Rekayasa

SETTING UP DECAL OR LIS Allocate decal on the panel surface and sign it up with pencil Teknologi dan Rekayasa

SETTING UP DECAL OR LIS Take up the decal with the hanging position of masking tape Teknologi dan Rekayasa

SETTING UP DECAL OR LIS Release the back part of the paper from decal Teknologi dan Rekayasa

SETTING UP DECAL OR LIS Roll up the decal in straight position Teknologi dan Rekayasa

SETTING UP DECAL OR LIS Twist up point of decal till the point part or end part of panel, don’t let the air inside BACK Teknologi dan Rekayasa

END SEASION BYE -BYE Teknologi dan Rekayasa