CELLONICS www.ppttopics.com.

Slides:



Advertisements
Similar presentations
Envelope Detector Conventional DSB-AM signals are easily demodulated by an envelope detector It consists of a diode and an RC circuit, which is a simple.
Advertisements

Chapter Thirteen: Multiplexing and Multiple- Access Techniques.
Chapter : Digital Modulation 4.2 : Digital Transmission
RF Circuit Design Chris Fuller /7/2012.
1 Ultrawideband Contents Introduction Why Ultrawideband UWB Specifications Why is UWB unique Data Rates over range How it works UWB Characteristics Advantages.
System Design for Cognitive Radio Communications
AM/FM Receiver.
Integrated Circuits Design for Applications in Communications Dr. Charles Surya Department of Electronic and Information Engineering DE636  6220
1 Fall 2005 Long Distance Communication Carriers, Modulation, And Modems Qutaibah Malluhi Computer Science and Engineering Qatar University.
IT-101 Section 001 Lecture #15 Introduction to Information Technology.
Data Communication and Networking 332 Hardware Components of Data Communication.
Chapter Two: Radio-Frequency Circuits. Introduction There is a need to modulate a signal using an information signal This signal is referred to as a baseband.
Data Transmission The basics of media, signals, bits, carries, and modems (Part II)
Lecture 1. References In no particular order Modern Digital and Analog Communication Systems, B. P. Lathi, 3 rd edition, 1998 Communication Systems Engineering,
ULTRAWIDEBAND TECHNOLOGY FOR CREATING A WIRELESS WORLD.
Software Defined Radio
Modulation-Why? 1. Low frequency signal has less energy, which means it can travel less distance. 2. Practibility of antenna.
ECE 4710: Lecture #31 1 System Performance  Chapter 7: Performance of Communication Systems Corrupted by Noise  Important Practical Considerations: 
Chapter : Digital Modulation 4.2 : Digital Transmission
Cape Electrical and Electronic Technology Topic: Electromagnetic Waves By: Tahvorn George & Charles,J.
Radio Equipment. Review: On the Transmitter Side The purpose of radio communications is to transfer information from one point to another. The information.
CHAPTER 4. OUTLINES 1. Digital Modulation Introduction Information capacity, Bits, Bit Rate, Baud, M- ary encoding ASK, FSK, PSK, QPSK, QAM 2. Digital.
FUNCTION GENERATOR.
A Technical Seminar Presentation By Hariharan S. Under the guidance of Prof. M. S. Sowmyashree Department of Telecommunication.
CELLONICS. INTRODUCTION Cellonics allow modem speeds 1,000 times faster than our present modems. It is based on the way biological cells communicate with.
Radio Communication SL/HL – Option F.1. Radio communication includes any form of communication that uses radio (EM) waves to transfer information –TV,
IT-101 Section 001 Lecture #15 Introduction to Information Technology.
Software Defined Radio (SDR)
Personal Communication Services & WiFi
William Stallings Data and Computer Communications 7th Edition
Outline Introduction Type of Multiplexing FDMA TDMA CDMA Future Work
Demodulation/ Detection Chapter 4
KOMUNIKASI DATA Materi Pertemuan 10.
CELLONICS Krishnanunni R S3 ECE 42.
Chapter 13 Linear-Digital ICs
Video Transmitting Robot
What is an Op-Amp Low cost integrating circuit consisting of:
Digital Communications
OBJECTIVE AND FEATURES:
CHAPTER 3 Physical Layer.
Ultra-Wideband - John Burnette -.
Introduction to electronic communication systems
Technician License Course Chapter 2
Figure 4–1 Communication system.
CHAPTER 3 Physical Layer.
Ultrawideband Contents
Spread Spectrum L.Tahani Aljehani.
Modulation Techniques
Introduction King Saud University
Lecture 4 Continuation of transmission basics Chapter 3, pages 75-96
MODULATION AND DEMODULATION
Chapter 3: Pulse Code Modulation
General Licensing Class
ANALOG COMMUNICATION SYSTEMS
TRANSMITTERS AND RECEIVERS
Spread Spectrum A signal that occupies a bandwidth of B, is spread out to occupy a bandwidth of Bss All signals are spread to occupy the same bandwidth.
PULSE MODULATION.
Fundamentals of Data & Signals (Part II)
Amplitude Shift Keying (ASK)
Analog and Digital Instruments
Modulation Modulation => Converts from digital to analog signal.
Chapter 2 Transmission Basics.
CH-6 CABLE TV.
Denial-of-Service Jammer Detector Training Course Worldsensing
William Stallings Data and Computer Communications 7th Edition
(Digital Modulation Basics)
Chapter Three: Signals and Data Transmission
William Stallings Data and Computer Communications 7th Edition
Spread Spectrum Analog or digital data Analog signal
Introduction 1st semester King Saud University
Presentation transcript:

CELLONICS www.ppttopics.com

“NECESSITY IS THE MOTHER OF INVENTION” the saying goes.. Lets now see what this current invention of CELLONICS was for. www.ppttopics.com

INTRODUCTION Cellonics allow modem speeds 1,000 times faster than our present modems. It is based on the way biological cells communicate with each other and nonlinear dynamical systems (NDS). Benefits are incredible speed, simplicity, and robustness. www.ppttopics.com

INTRODUCTION The ASCII uses a combination of ones and zeros to display a single letter of the alphabet. The data is then sent over radio frequency cycle to its destination where it is then decoded. Human cells respond to stimuli and generate waveforms that consist of a continuous line of pulses separated by periods of silence. The Cellonics technology uses these pulse signals and apply them to the communications industry. www.ppttopics.com

INTRODUCTION Nonlinear Dynamical Systems (NDS) are the mathematical formulations required to simulate the cell responses. It uses portable devices, and provide these devices with faster, better data for longer periods of time. It consumes very little power. www.ppttopics.com

PRINCIPLE OF CELLONICS TECHNOLOGY Cellonics - Electronic cells. It has the ability to encode, transmit and decode digital information over a variety of physical channels. Wired and wireless communications are possible. www.ppttopics.com

Measured ß-cell Response www.ppttopics.com

Leech & Nociceptor www.ppttopics.com

The Cellonics technology is a fundamental modulation and demodulation technique. The Cellonics receivers generate pulses from the received analog signal and performs demodulation based on pulse counting and related algorithms. The study of biological cell behavior is only an inspiration to the invention of Cellonics circuits. The Cellonics technology is not related to any neural network communications or neurophomic electronics. Slow waveforms: Analogue waveforms that vary slowly with time. These waveforms can be in any arbitrary shape. Fast waveforms/fast pulse trains: Waveform in the shape of pulses that varies rapidly with time. www.ppttopics.com

CELLONICS CIRCUITS www.ppttopics.com

S-curve transfer characteristics www.ppttopics.com

The transfer characteristic consists of three different regions. The two lines at the top and bottom have positive slope ‘1/RF’. They represent the regions in which the Op-Amp is operating in the saturated (nonlinear) mode. The middle segment has a negative slope(Op-Amp operate linearly). www.ppttopics.com

The rate of change of signal voltage ‘Vs’ is equal to ‘V0’ which is dependent upon the slope of the input triangular waveform. When the slope is positive, the Op-Amp is stable and outputs a constant saturation voltage. When slope is negative, the Op-Amp is unstable and the output would be oscillating. By controlling the duration of the negative slope, the number of pulses to be produced at the output of the Op-Amp can be controlled. www.ppttopics.com

N-curve transfer characteristics The transfer function of a Tunnel diode exhibits the “N- curve”. By connecting an inductor and a tunnel diode in series, we can produce pulses that are separated by periods of silence. That would mimic the behavior of cells. www.ppttopics.com

www.ppttopics.com

PERFORMANCE OF CELLONICS RECEIVER : www.ppttopics.com

A) BER Performance in a Narrowband Communication System The performance of the Cellonics modulation is able to match the theoretical optimal BPSK modulation scheme . Cellonics receiver will have less implementation losses www.ppttopics.com

B) BER Performance in an Ultra Wideband UWB is a new radio system that occupies an ultra wide bandwidth and it uses very short impulses of radio energy. It will cause little interference to the existing spectrum users. www.ppttopics.com

PROOF OF CONCEPT - DEMONSTRATION ON SYSTEMS www.ppttopics.com

Narrowband Communication System www.ppttopics.com

Transmitter and receiver comprise of three modules: 1. The PC/DSP module : This module provides a high-speed data transmission interface with the transmit/receive PC . 2. The Base band transceiver module: The transceiver converts these data from the DSP into FSK-like waveforms. 3. The RF transmit/receive module: This part of the circuitry down converts the received signal using an AM envelope detector. www.ppttopics.com

Ultra Wideband Video System www.ppttopics.com

Transmits real-time video images at a data rate of 12Mbps wirelessly to a video monitor. A simple web camera is used as the video capture source. The digital video information is fed into a pulse position modulation processing board (a Field Programmable Gate Array or FPGA board) via a USB connection before being frequency translated to a higher frequency band at a transmitter for sending over the air. The airborne signals are then detected by a UWB receiver and pulse position demodulated back into digital video information for display at a video monitor. In both instances, an ultra simple Cellonics Transmitter and a simple Cellonics receiver are used. The speed of the system is only limited by the Video camera’s USB interface data rate. www.ppttopics.com

CELLONICS ADVANTAGES New Life to Communication Devices. Savings on Chip/ PCB Real Estate. Savings on Power. Savings in Implementation Time. Build or Rejuvenate your Products with Cellonics. www.ppttopics.com

CONCUSION The Cellonics communication method is one inspired by how biological cells signal. It is a fresh and novel look at how digital signals may be conveyed. In this digital day and age, it is timely; current digital communication designs are mostly derived from old analog signal methods. With the Cellonics method, much of the sub-systems in a traditional communication system are not required. Noise-generating and power-consuming systems such as voltage-controlled oscillators, PLLs, mixers, power amplifiers, etc., are eliminated. To a communications engineer, this is unheard off. One just doesn’t build a communication device without an oscillator, mixer, or…. Such is the revolutionary impact of Cellonics. Engineers will have to reform their thinking- that such a simple solution is possible. www.ppttopics.com

BIBLIOGRAPHY www.cellonics.com www.future20hottechnologies.com www.wikipedia.com www.google.com www.britannica.com “Book of Cells” by Koenard Elst. “Art of Electronics” by Legard,2001. www.ppttopics.com

THANK YOU www.ppttopics.com