Introduction to Engineering, E10. Spline Hull design Ken Youssefi Introduction to Engineering, E10.

SolidWorks Sketch Commands Offset Mirror Rectangular and Polar (circular) array Drawing tools Modifying tools Trim and Extend Spline Constraints Project entities Dimensioning tool Checks sketch for problems Ken Youssefi Introduction to Engineering, E10.

Introduction to Engineering, E10. Spline A smooth curve is fitted through selected points Ken Youssefi Introduction to Engineering, E10.

Spline on a curved surface Select the surface to draw Select the 3D Sketch option Select the Spline on Surface option Ken Youssefi Introduction to Engineering, E10.

Introduction to Engineering, E10. Draw the curve Exit the sketch Select Extrude Cut option , choose the spline curve and the direction for extrusion Direction Ken Youssefi Introduction to Engineering, E10.

Introduction to Engineering, E10. Select body to keep Ken Youssefi Introduction to Engineering, E10.

SolidWorks Sketch Commands Use Spline to trace the curve Importing an image into the sketch environment Ken Youssefi Introduction to Engineering, E10.

Projecting Entities onto a Sketch plane Projected entities Ken Youssefi Introduction to Engineering, E10.

SolidWorks Sketch Commands Allows you to extract a curve for other applications, not active in sketch mode. 3D curve Locates the intersection of two planes and turns it into a sketch curve Plane 1 Plane 2 Ken Youssefi Introduction to Engineering, E10.

Introduction to Engineering, E10. Constraints Select Add Relations Select line Select Vertical Ken Youssefi Introduction to Engineering, E10.

Introduction to Engineering, E10. Constraints Select two entities (lines) Tangent constraint Select Collinear Ken Youssefi Introduction to Engineering, E10.

Introduction to Engineering, E10. Constraints Two curved entities Two straight entities Curved & straight entities Ken Youssefi Introduction to Engineering, E10.

Introduction to Engineering, E10. Repair Sketch Option Ken Youssefi Introduction to Engineering, E10.