REPAIRING PANEL DOOR OR FENDER INSTALLING ADDITIONAL PERIPHERAL BODY OTOMOTIF (F-022) SK – KD 06

TARGET OF ACTIVITY LEARN Educative participant can know additional components Educative participant can know the way of additional peripheral Teknologi dan Rekayasa

INSTALLING ENGINE HOOD 1 Installing hood of cabin with installing right hasp before 2 Installing hood moulding 3 Installing channel of washer to hood 4 Installation of unlock cable pass house strut Teknologi dan Rekayasa

BEHIND FENDER Most of behind fender make one with inner bodi by welded system pengelasan Target of welding is to prevent dirt will enter among external construction and especial bodi Teknologi dan Rekayasa

INSTALLING BUMPER 1 Installing bumper filter 2 Installing bumper side extension sub Assembly 3 Intalling bumper sub assembly Teknologi dan Rekayasa

INSTALLING WINDSHIELD GLASS intall rubber glass to front glass, and by using screwdriver aid enter mine to rubber cavity.. Teknologi dan Rekayasa

INSTALLING WINDSHIELD GLASS Length mine until tip of middle underside less 10 cm ( 3,94 inchi) after around paired by mine Teknologi dan Rekayasa

INSTALLING WINDSHIELD GLASS with helped some one from outside, hold front glass at the same time place to flange bodi and press glass into. Pairing front glass with attractively tip of middle shares mine in middle front glass till glass rubber related to flange fully. Teknologi dan Rekayasa

INSTALLING WINDSHIELD GLASS Teknologi dan Rekayasa

INSTALLING WINDSHIELD GLASS If glass have been attached at its place, knock glass from outside bodi with rubber hammer to become the glass enter into flange bodi about 50-70 mm avoid glass rubber Teknologi dan Rekayasa

INSTALLING WINDSHIELD GLASS Cleaning glue of glass which remain, wait about 3 hour to know result of installation of banding possibility Teknologi dan Rekayasa

INSTALLING SEAT install bolts fastener out track seat and recliner Tide all seat component Install bolts fastener by shifting seat to the front and rear Teknologi dan Rekayasa

INSTALLING INSTRUMENT PANEL 1 Install instrument panel. 2 Install speedometer cable , air hoses 3 Install wiring instrument, ect fuse, radio and the other component 4 Install bolt fasterner of goods place drawer Teknologi dan Rekayasa

INSTALLING INSTRUMENT PANEL 5 Install bolts bracket heater 6 Install wheel steering and heater contol cable 7 Install choke control connector 8 Install negative terminal battery. Teknologi dan Rekayasa

INSTALLING GRILL AND MOULDING Straightening top table of moulding to vehicle bodi Press downwards with use hand. When installation moulding to glass weather strip can use soap water Teknologi dan Rekayasa