Scintillating Fiber BLM with PMTs

Slides:



Advertisements
Similar presentations
R&M Fiberliner LAN / WAN applications R&Measynet.
Advertisements

Amphenol Outdoor Connectors
1 Cable Assembly for CanSat. 2 Heat Shrink Tubing Battery Pack Connection Pin Connectors Radio Cables Mic & Speaker Plugs See close up connection page.
NEWLINK FO Termination Cabling Systems NEWLINK Copyrights 2003 h2.
LAN & WAN Products Fiber Optic Cable Military Navy Shipboard Fiber Optic Cable Low Smoke Zero Halogen MIL-TAC Cables Military Tactical Fiber Optic Cables.
Comparison of Scintillating Fiber and Diamond Detector Data T. Tsang BNL (Nov. 9, 2009)
HEATING AND PLUMBING FEF
Compression Fittings Internal nut type. Compression fittings Rugged and durable. Firm joint using all brass construction For use with plastic and metal.
LEarNeR© Kit 1- Core LENR Reactor Description of hardware, fittings and raw metal that can be purchased. Prices, part numbers & vendors, high pricing for.
Plasfit - plastic push-in fittings For the drinks dispense and brewing industries.
SPLICING AND ITS APPLICATIONS -SPLICES JOIN TOGETHER THE ENDS OF TWO OPTICAL FIBERS IN A CONNECTION THAT IS INTENDED TO STAY CONNECTED CONNECTORSSPLICES.
Fiber Optic Construction & Termination Jeff Hite University of Oregon/NSRC This document is a result of work by the Network Startup Resource.
Start here >> Network IQ Training Manual Chapter 4 - Fibre Optic Hardware.
Wrapping Anodes Back To Basics. If you’ve been using a cotton jacket material, you’ll want to use the cotton sleeving. If you’ve been using a polyester.
Electronics. Solid snap together electronic connectors.
You will be making a few new parts and re- drilling a few holes to size. READ ON,,,,, 3/8” bolt Brass bushingNylon bushing 2 reinforcement plates 2 Delrin.
Test Chamber Assembly, 1.5M Long (59.00”) Vacuum Tube, 4.00 OD x 3.50 ID Vacuum Tube, 3.75 OD x 3.51 ID 3.375” CFF, Non-Rotatable Feedthrough, Ceramtec.
R&Mfoxs Venus-FXXL-SCM Patrick Schilter, PM Central Office & Wall boxes August 2013.
Applied Control Systems
External nut type series 43
Cellular telecom networks. Coaxial Antenna Line 2 Introduction Waterproofing kits HYPERCELL ® Products offer all passive components between BTS and antennas.
Nov. 7 report (2 nd Nov. 7 of today) Hawaii/Marc.
Soldering Jumper Wires SPIRIT Strip about ¼” of insulation Apply solder until wire appears soli d “Tin” the wire.
CPR2 Optical Cables Joey Huston Michigan State University …taking optical signals from edge of CPR/crack detectors to PMT boxes mounted on back of wedges.
Clear Fiber and Wave Guide Fab. Makoto YOSHIDA (Osaka Univ.) July MICE FT
Content :  Indoor fiber optic cables  The benefits of indoor Fiber Optic Cable  The features of indoor Fiber Optic Cable  Tight-Buffered Cable  Consists.
1 Nexans Cabling Solutions Fibre solutions for fast deployment Joost Grillaert.
Fiber Optics FIBER CONNECTOR TYPES.
Rotating Base Model Assembly Instructions copyright Mechanical Kits Ltd
1 SATRA Electronics PWS 10/07/09. 2 Antenna (Downhole) Cables Cables shipped cut-to-length, terminated and wound (not on spools) Downhole cables: ~14”
Terminal Learning Objective
Fiber Optic splicing process Technology Partners.
1 Coordinate Detector: prototype design The Coordinate Detector (CDET): Three independent vertical planes with 15 cm plastic shield in front, all planes.
Reaction Plane Detector Safety Review Abigail Bickley, for the RxnP Group University of Colorado June 22, 2006 All data sheets can be found at:
Waveguide for Station 5 M. Yoshida (Osaka Univ.).
© DIAMOND SA / / 1 ALBERINO Solution. © DIAMOND SA / / 2 E-2000™ ALBERINO Solutions Product description A single and robust component for.
N 2 Laser 300  QQ 150m HF  HF + 9 PMT Boxes  QP Calib Box 1  4 Counting Room HF Calibration Optical Fiber Path 9 PMT Boxes / Quad 24 PMT Tubes.
Fiber update Zhiwen Zhao/Mehdi Meziane 2012/02/12.
Reaction Plane Detector Safety Review Abigail Bickley, for the RxnP Group University of Colorado June 22, 2006.
Daya Bay Muon Subsystem Review, 7/28-29/2007, IHEP, Beijing Muon System PMT Cable Routing Kirk McDonald Princeton University (July 28, 2007)
WeldFit Push-in Fittings
1 HVACR316 - Piping Copper Tubing and Fittings. 2 Tubing & Fittings No matter what piping material is used in the installation of an air conditioning.
APS April Meeting Detector Construction of the Forward Proton Detector at D0 Michael Strang University of Texas at Arlington Diffractive Events FPD.
Long Bo for LAPD Hans Jostlein10/20/2011 December 15, 2015 Long Bo for LAPD 1.
Operating procedure for POF cables Comoss Electronic Co., Ltd. Date : May-05, 2008.
A 128 fiber Slit-Plate assembly, Kinematic mount
Coordinate Detector: prototype design General idea about the Coordinate Detector (CDET) so far: Three independent vertical planes with 15 cm plastic shield.
ECE 4006B Fall, 2002, Group 1, Mei Chan Progress Report Period (November 22-December 5, 2002) Receive and complete assemble 2 nd PCB board Complete the.
STATUS ON Optical fiber: Preliminary tests on Optical Fiber and Fiber Optic Feedthrough Massimo Rossella, Marco Prata, Tommaso Cervi INFN, Sezione di Pavia.
Outside Plant Fiber Optics
H. Katajisto RE EDR 10/10/02 Enclosures for the RPC Link Boards Outline Introduction Periphery General Services Components, materials Manufacture, Assembly.
Optical Termination Box VSOF-OTB-E OPTICAL TERMINATION BOX [OTB-E-48c]
MICE RF Coupler Modifications Update 4/30/2015 Allan DeMello.
KM2A MD prototypes xiao gang introduction simulation Prototypes conclusion.
24VDC Adaptor Pigtail This adaptor pigtail is used to connect +24VDC to IO Extenders. When used in conjunction with the IO Extender On/Off Switch, strain.
Plumbing Systems.
FIBER OPTIC Jumper Cord SERIES
Part List of “Swift” LC Connector
33KV PLUG-IN TERMINATION AT GAYATHI D6624 PROJECT
Step-by-step assembly instructions
SCINTILLATOR HARDWARE
Step-by-step assembly instructions
(Preliminary) WIYN 0.9 Meter Collimation Procedure
( BDA 3033 ) Chapter 5: Thick Cylinder **Compound Cylinders**
Harness, Pigtails, Coil Cords, Nose Box
Piping Flow Maintenance
Компания Reichle & De-Massari (R&M)
Graphite Design CGThermal TEMA design overview Design Features
Presentation transcript:

Scintillating Fiber BLM with PMTs Brookhaven National Lab Toby Miller 3/27/17

PMT and Fiber Scintillator Assembly End Plug Scintillating Fiber in PVC protective tube 1mm POF ST patch cord PMT Holder Head On Type shown open Fiber Inter-connect Box

e Components 1 Scintillating Fiber 2 ¼” Tubing connector 3 ¼” PVC tubing 4 5 ST Fiber feedthrough 6 ST fiber connector for 1mm POF 7 1mm POF patch cord, ST connectors 8 Plastic box with cover 9 Heat shrink tubing 5 6 9 1 2 7 8 3

Saint Gobain Fibers Two types will be tested Single-clad Multi-clad

ST connector for 1mm POF (plastic optical fiber) Saint Gobain scintillating fiber has not outer jacket. Needs heat shrink tubing to take the place of the outer jacket Epoxy required to cement fiber into connector (see connector assembly instructions) Fiber end is finally cut and polished. Polishing kit for POF is required (see material list) Fiber without jacket Connector shown assembled before epoxy, cut and polishing. Heat shrink tube only partially shrunk for illustration purposes only.

1mm POF ST connector assembly

Side-On Type PMT assembly with Scintillating Fiber PMT Holder Side On Type shown open

Material List No. Description Supplier Part Number 1 Scintillating fiber, 1.0mm diameter, single clad, no outer jacket St. Gobain BCF60S- D1.00N 2 Black UV-Resistant Polypropylene Tube Fitting, Straight Adapter for 1/4" Tube OD x 1/8 NPTF Male McMaster 5562K111 3 Polyethylene Tubing , Black, 0.17" ID, 1/4" OD, 25 ft. Length 5384K535 4 Durable Nylon Tight-Seal Barbed Tube Fitting Plug for 5/32" Tube ID, Black, Packs of 10 5463K76 5 ST fiber feedthrough connector L-com FOA-011A 6 ST fiber connector, for 1.0mm plastic optical fiber Ind. Fiber Optics 51 00067 7 Fiber optic patch cord, 1mm plastic optical fiber, ST connectors, 2.0m long IF 121O-2-0 8 Plastic enclosure, black, 2" x 3" x 1.5", mounting tabs Digikey CU-790-MB 9 Heat Shrink Tubing, Black,1/8" dia x 1.50" L, pkg 50 pcs, 1.0mm dia x 0.55mm thick recovered SFTW2018K-1R5-ND 10 Epoxy for PMMA plastic optical fiber FB194-ND 11 Plastic Optical Fiber (POF) Termination Kit IF TK4