Manual Instructions Installation Cleaning Instructions 1 Remove filter and place in a container of water for 15 minutes. 2 Run fresh tap water through the filter for approx 3 min or until water runs clear. 3 Wash the filter bottle with warm water before use. 4 Take filter from water and flush under tap until water runs clear. Assemble filter cartridge placing the silicon O-ring around the filter housing and rolling it up to the shoulder of the filter. Place filter in the top container pressing down firmly to seat the filter, then screw locking cap on top. 7 Assemble the filter bottle and place on top of your cooler. Fill top section of filter bottle and leave to filter down into the lower section of filter bottle. 9 Do not attempt to refill the top section of the bottle again until the level in the lower section is near the bottom of the bowl. The bottle should be cleaned approximately every 2 weeks with warm fresh water only. Detergents may leave an undesirable after taste. Important!!! Not Dishwasher Safe Useful Tips & Precautions * Never Fill or clean the Filter Bottle with hot water. * This unit is NOT dishwasher safe. * Keep in a dry place and out of direct sunlight. * Clean the bottle regularly to avoid dirt and calcium build up. * When going on holidays leave the bottle full and drain and clean the unit when you return. Never let the filter dry out. When To Change Your Filter These filters are certified for 4000Litres,which equates to approximately 6 months use.