Comfortmaker Products are Manufactured and Marketed by International Comfort Products LLC. Lewisburg Tennessee USA.

Slides:



Advertisements
Similar presentations
Packaged Terminal Air Conditioners
Advertisements

“Enerpak” Units » Propeller Type Fan » Size 100 – 400 MBH » 80% Thermal Efficiency » Natural or LP Gas » 10 Year Warranty on Heat Exchanger, Burners,
Fan Coil Unit Product Line-up. FCU Home Application Show.
SINGLE SPLIT INVERTER AIR-CONDITIONER
HEAT PUMPS.
Setup/Installation/Operation of an Environmental Control Unit (ECU)
Trane Variable Water Flow System
Basic Refrigeration Cycle
Installation. Indoor Unit Installation Typical Installation.
38GXC(Q)/40GXC(Q) Service Training Sizes 18 and 24K.
Wine Cellar Split System Basics. Definitions Split System – A cooling unit that “splits” the cooling coil and the condenser apart into two remote pieces.
Air-Conditioning Control Systems
23022 Series Evaporator Features:
Engineer Presentation
AIR CONDITIONING (COOLING) UNIT 40 TYPICAL OPERATING CONDITIONS
HVACR416 - Design Humidification. Relative Humidity 1.Air in the home is artificially dried out when it is heated. 2.Because warm air expands, this expansion.
Cooling Only 38MFC/ 40MFC Heat Pump 38MFQ/ 40MFQ
Product Introduction.
Aqualean Product Presentation 1 By Laurent Domenget Product Manager, Rooftop & Packaged Air Units.
AIR CONDITIONING (COOLING)
Air conditioning – Refreshes your life Applied Systems DAIKIN Fan Coil Units Comfort Applications >> FWB
‘YGFC’ FAN COIL UNITS NEW PRODUCTS
Learning, our way Examples of bad installation. CONTENT Installation related examples Installation related examples Application related examples Application.
RESIDENTIAL AIR HANDLERS
Air Conditioning in tropical climates Presented by Ranjeet Kumar Nayak.
2010.
Air Handler Terminology
Keith Clark NSM VRF Commercial VRF. What’s Different About Our Ductless Products? Ductless Mini-Split Technology Not Much.
Air Handler Terminology
Product Presentation 2007 SKY AIR Launch of new Non-Inverter + Duct (R22) series.
Product Section Product Training. 50 Hz R410A R22 R407C Ceiling Convertible CE-E Series.
1  2008 Kaeser Compressors, Inc., USA (V2.2) “Specifications are subject to change without notice” Presenting... Kaeser Omega Blowers.
Oil-free Vacuum Pump / Compressor Today’s Instruments Co., Ltd.
DC Inverter Mini VRF Reference projects Reference Project Mini and Multi Improvements Product line -up.
Air condition installation
 Bilt2Spec™ Custom walk-ins: Practically any size, shape or option available.
Cooling Solutions for Telecom Precision Cooling for Maximum Efficiency
UniTrane™ Terminals High Wall Fan Coil: W-Line Ducted Fan Coil: D-Line
TXV Devices.
Conventional HP Schematic
The New Digital Inverter Light Commercial Range
Section 6: Air-Conditioning (Heating And Humidification)
Specializing in Water-Cooled & Portable-Split Air Conditioner
ARAC/H/F Air-cooled water chillers, free-cooling chillers and heat pumps Range: kW.
GEYSER Heat Pump Water Heater
BUILDING HEATING AND COOLING
AdaptaPAK The sustainable, energy-efficient outdoor refrigeration solution.
COMFAIR HD WALL WATER FAN COIL UNIT
Ceiling Convertible (MCM-E Series)
Top Quality & Cost Effective ECONET Manufactured by Maniks
Maniks High Quality ECONET for Better Performance
DC Inverter Air-cooled Chiller Aqua Tempo Super II Series
New Air Handler Platform
Indoor Pool Design and Dehumidification
‘YGFC’ FAN COIL UNITS NEW PRODUCTS
Product Overview SEIYA 06, Sep. 2018
Engineering Presentation
R3 Controls, Valves, Accessories & Heat Pumps
VITALITY Large Splits Johnson Controls PowerPoint Guidelines | July 21, 2009.
Ceiling Convertible (ACM-E Series)
Ceiling Convertible (ACC75~100D Series)
Dunham Bush Air Cooled Package
Error codes for split systems
Champion RotorChamp HP
Champion RotorChamp HP
Ceiling Convertible (MCC075~100D Series)
Nyle’s orgins date back to 1977 when Donald Lewis patented the XDH Dehumidification system, which became the core of a very successful line of dehumidification.
Nyle’s orgins date back to 1977 when Donald Lewis patented the XDH Dehumidification system, which became the core of a very successful line of dehumidification.
Presentation transcript:

Comfortmaker Products are Manufactured and Marketed by International Comfort Products LLC. Lewisburg Tennessee USA.

International Comfort Products LLC Corporate history can be traced back over 100 years Manufacturing started in Lewisburg Tennessee USA with wood burning stoves in the 1800’s Manufactured our first Air Conditioning unit in 1962 Publicly traded independent company until August of 1999 Purchased by United Technologies / Carrier in 1999 and became wholly owned subsidiary of Carrier.

United Technologies Corporation Sikorsky, Otis, Chubb, Pratt and Whitney, Carrier, Hamilton Sundstrand $31 Billion Corporation (2003) 49th Largest U.S. Corporation (2002) 141th In The World (2002) 155,000 Employees, Including approximately 79,000 Outside The United States $29 Billion in Assets (2002)

Collierville Tennessee NORTH AMERICA Tyler Texas Collierville Tennessee Indianapolis Indiana Monterrey Mexico INTERNATIONAL Bangkok Thailand Ghangzhou China

ICP Product Offering Primary Products Manufactured and Marketed by ICP Duct Free and Universal Mount Split Systems 18mbh to 60mbh Ducted Split Systems 18mbh through 240mbh Package Products 24mbh through 240mbh Forced Air Gas Heat 50mbh to 140mbh 19 Assembly lines covering more than 100,000 square meters of manufacturing space in 5 countries

ICP Distribution Centre Lewisburg Tennessee 40,000 square meter distribution centre Handles 128 truck/container transactions a day Input - Output $45 to $90 Million in stock depending on season

Corporate Profile 400 Distributors in United States and Canada 75 International Distributors Ten Corporate Brands Represented in 50 countries around the world Active in the Gulf Region for 19 years

Split Systems

General Features Refrigerant used is R22 Copper Tubes Aluminum fins Low voltage controls 24V Thermostats and Compressor Contactors 220/24VTransformer Included on all but Wall Mounted High Wall Fan Coils and Cassette Units

Indoor Matches to Vertical Discharge Outdoor Units

High Wall Fan Coils HWS Series Indoor 18k to 36k BTUH 5.3kW to 10.5kW 220V-1-50Hz Wireless Remote Control Auto Swing Auto Restart

Universal Mount Evaporator MK Series 18k to 60k BTUH 5.3kW to 17.6kW 220V-1-50Hz Vertical/Horizontal Standard Remote Control Field installed wired control option – 8m wire length

MK Series Features Control Features 5 Control Modes Cool, Dry, Fan only, Auto and Heat for HP Auto Restart after Power Failure With 3 minute compressor restart delay Resumes normal operation Three Speed Fan Manual or Auto Low Voltage Safety Evaporator Freeze Protection

MK Dimensions Typical 60,000 Btuh Competitive unit: 1900mm+/- x 640mm+/- x 240mm+/- reduced width less intrusive in the space

Ceiling Cassettes SC Series 18k to 48k BTUH 5.3kW to 11.0kW 220V-1-50Hz Electronic Control with hand held Remote Includes Condensate Pump

SC Control Features Control Features 5 Control Modes Fan Only Cool, Dry, Auto and Heat for HP Auto Restart after Power Failure With 3 minute compressor restart delay Resumes normal operation Three Speed Fan Manual or Auto Low Voltage Safety Evaporator Freeze Protection

Split System Ducted Indoor TDKP AWA-1 Series Slim Line 18k to 60k BTUH 5.0kW to 17.6kW 3 speed motor Painted Cabinet Maximum Height 339mm

TDKP AWA-1 Series Features Factory installed Features Orifice Expansion Device Hanging Brackets with Isolators Washable Aluminum Mesh Filter Wired Wall Mounted Control 15m wire length Control Features 5 Control Modes Cool, Dry, Fan only, Auto and Heat for HP Auto Restart after Power Failure 3 minute compressor restart delay Three Speed Fan Manual or Auto Low Voltage Safety 175 volts Evaporator Freeze Protection

TDKP AWA-1 SERIES

Connection Locations Make Job Site Positioning Easy TDKP INLET SIDE Connection Locations Make Job Site Positioning Easy

TDKP AWA-1 Installation

TDKP AWA-1 Motor Access

TDKP AWA-1 Filter Access

Split System Ducted Indoor Sections DK Series 18k to 60k BTUH 5.0kW to 17.6kW Low Static Blow Through Design without plenum Fan Control Relays for 24volt wall mounted thermostat Integral Hanging Brackets

DK Series Without Plenum

Split System Ducted Indoor EBW Series 18k to 60k BTUH 5.3kW to17.6kW 220V-1-50Hz AC and HP Capable Upflow/Horizontal

EBW Series Features High Impact Thermoplastic Drain Pan Primary and Secondary Drain Connections with Brass Inserts Fused 24V Fan Control Board 3 Speed Motors 40VA Control Transformer Washable Filter Factory Supplied

EBW SERIES Height Supply Air Return Air Length 356mm 1.5 and 2.0tons 534mm 3.5 to 5.0 tons Supply Air Return Air All units 559mm wide Length 1067mm 1.5 and 2.0 tons 1194mm 2.5 tons 1245mm 3 and 4 tons 1347mm 3.5 and 5.0 tons

Split System Outdoor Units Air Conditioners

CA20 Series Cooling Only Standard Operating Conditions 18, 24, 30, 36, 48 Mbh 230-1-50Hz 36, 42, 48, 60 Mbh 400V-3-50Hz Standard Operating Conditions 125 deg F/52 deg C 55 deg F /12.8 deg C 0 deg F/ -17.8 deg C with optional control

Crankcase Heater Standard CH20 Series Heat Pumps 18, 24, 36, Mbh 230-1-50Hz 36, 48, 60 Mbh 400V-3-50Hz Standard Cooling Operating Conditions Same as AC units Standard Heating Operating Conditions up to 67 deg F / 19 deg C down to -30 deg F / -34 deg C Crankcase Heater Standard

Superior Design Coated Wire Basket Top Superior Structural Strength Eliminates sharp louvered edges Superior Structural Strength Rigid Formed Top with drawn orifice Epoxy-Phenolic Coated Fins Enhanced Corrosion Protection We’ll talk about all of these features in more detail as we go on. Let’s focus on a few features that are common to all of our new [brand] split system outdoor products – Filter dryers are shipped with every [brand] outdoor split product. Why isn’t it installed in the unit? Because dealers and contractors want the flexibility to install the filter dryer where they can get to it. When the filter dryer is buried in the unit, is usually small, needs to be replaced often, and it never is. [to next slide …]

Superior Design Stronger Fins Epoxy-Phenolic Coated Fins Reduced Slits Black Finish 1000 Hour Salt Spray ASTM B117 Reduced Slits 37% reduction in the number of slits Superior Strength Easier Cleaning

Superior Design Stronger – Tops and Bases Increased Structural Strength Drawn Fan Orifice Surface Embossments for added strength Reduced vibration Reduced stress points

Superior Design Stronger Cabinet – Corners and Base Design More Rigid Design 45-degree valve design Better stacking strength

Superior Design Weather Resistance Top Eliminates Raw Louvered Edges 500Hr ASTM B117 Salt Spray Rating Pre-painted Galvanized Steel Coated Wire Guards

Longer Life by Design Better Standard Refrigerant System Protection High/Low Pressure Switches Standard On All Models

Superior Design Condenser Support Protection Reduced Vibration Reduced Noise Reduced paint damage Superior weather resistance Superior Defrost Action on Heat Pumps

Easier to Install Faster, More Reliable Brazing Free-and-clear access tubing stubs Valve manufacturer certified Easier access for faster brazing No heating damage with clear access New Free-and-Clear Design

Easier to Install Easier to Adapt to building site variations 45-degree angle affords more installation options Accommodates tubes from right, left or center Service friendly

American Engineering Engineered in USA Assembled in North America Engineering Head Quarters Indianapolis IN Assembled in North America World Class UTC facility in Monterrey Mexico

World Class Factory Monterrey Mexico Just 160kM south of the US border Major Manufacturing center for North America Over 15,000 Manufacturers use Monterrey to reach the USA Domestic Market

To Name a Few…. MONTERREY MANUFACTURING ABB General Electric John Deere Navstar-Ford Caterpillar General Motors Mercedes Benz Nissan Daimler-Chrysler To Name a Few….

World Class UTC Facility Comfortmaker export condensers complement the existing manufacturing capabilities Factory annual production exceeds Over 250,000 split system condensers Over 750,000 evaporator coils Solely For The USA Market

Great Product! Superior Design Added Features Stronger Cabinets Less vibration New Top Design eliminates raw edged louvers Added Features Epoxy-Phenolic coated fins Increased corrosion protection High and Low Pressure Switches Increased system protection Crankcase Heaters (heat pumps) Superior winter operation

Why Choose Comfortmaker? Designed for Serviceability and Installation Ease Easy access Gauge Ports Easy access Service Panels Convertible models for flexible installation Field installed and Factory installed options High and Low Pressure controls standard on all units above 5 tons/18kW Optional on split systems below 5 tons/18kW

Why Choose Comfortmaker? Pre-painted Galvanized Steel on outdoor units Most durable paint finish available today Coated fin stock Enhanced corrosion protection 100% Run Test on all Products Eliminates Start Up Issues

Why Choose Comfortmaker? “Over Engineered” Units ICP Engineering tests exceed local requirements Stress tested to 62 deg C/145 deg F 52 deg C/125.6 ambient operation certified by ICP High Efficiency and Low Noise levels

Why Choose Comfortmaker? Backed by one of the largest corporations in the world.. United Technologies Corporation Supported Locally by UTS-Carrier

Thank You

Questions?