Labradar Quick Start Guide English

Slide open the battery cover and insert 6 AA alkaline batteries Slide open the battery cover and insert 6 AA alkaline batteries. An alternate USB power source may be used if it does not exceed 5v 1 amp

Turn LabRadar on Set Parameters: Select Velocity Range (Rifle, Handgun, Archery)

Set Trigger Source- Trigger Set Trigger Level- 1 Set Projectile Offset- 30cm

Mount on a solid tripod or suitable mount

Align the radar with your target, use a small diameter tube for more precise alignment Using V notch for sighting Using Tube for sighting

Press the ARM button. The light will change from blue to orange Press the ARM button again to disarm the radar.

Position your muzzle in the proper location NO MUZZLE BRAKE - Even with side of radar *always position your muzzle so the muzzle blast will not directly impact the Labradar

90 DEGREE MUZZLE BRAKE - In front of radar (Approx. 25cm) *always position your muzzle so the muzzle blast will not directly impact the Labradar

ANGLED MUZZLE BRAKE - Even with or slightly behind side of radar *always position your muzzle so the muzzle blast will not directly impact the Labradar

SUPPRESSED - Even with or slightly behind side of radar *always position your muzzle so the muzzle blast will not directly impact the Labradar

Large Caliber Weapons with heavy muzzle blast (338, 375, 50, etc) Additional protection may be required to prevent damage to Labradar and to acquire accurate readings. A solid barrier should be used.

RIMFIRE muzzle location Place LabRadar approximately 10 cm in front and 10 cm to the side of the muzzle

Air Gun - muzzle location when using the Air Gun Adapter Position the microphone in front and to the side of the muzzle so it can detect some of the muzzle blast

To change from the Armed mode to the Review mode press and hold the Arm button 3 seconds You must be in the Review mode To start a new series, Access the Parameters menu, Review previous shots

Indoor Ranges - Make sure your indoor range is greater than 15m long and 10m wide. LabRadar may not work on smaller ranges Targets - Do not use metal targets. They may reflect the radar and provide poor results.

Troubleshooting Unable to acquire projectile message: Cause Solution LabRadar shaking from muzzle blast Stabilize radar, move farther from muzzle blast Improper alignment Re-align, use small sighting tube Excessive muzzle gases in front of radar Move radar farther away from barrel Select Velocity Range set incorrectly Change to proper velocity setting Does not trigger: Trigger Level too high Set to Trigger Level 1 Muzzle too far from LabRadar Move muzzle closer to radar Blue light flashes: SD card incompatible Perform a full format of the card SD card lock engaged Slide lock to unlocked position LabRadar turns off or restarts Excessive radar reflection from downrange Remove reflective objects from downrange Excessive muzzle blast causing brief power loss Move LabRadar away from direct muzzle blast For additional assistance contact your local dealer or LabRadar at info@mylabradar.com

See our other product available at www. mylabradar See our other product available at www.mylabradar.com or at your local dealer Air Gun Adapter Archery Adapter Tripod Bench Mount Carry Case

Distributed by TCK, LLC Wichita, KS USA www.buymylabradar.com info@mylabradar.com 316-855-2525 Produced by Infinition Inc. Trois-Rivieres, Quebec Canada www.infinition.com