Shuttle Loss of Sensors

Slides:



Advertisements
Similar presentations
Levolors New Size-In-Store Blind Cutting Machine.
Advertisements

MD80 N275 CLE MARCH Summary During landing roll at CLE on runway 5R, approx 2106 lcl time, aircraft weather vaned and skidded off the left side.
Malibu/Mirage PA46-310/350 Landing Gear & Brakes
Sportbike A General Overview and look into Motorcycles.
Cessna Citation II Flight Controls
Detaching the Loader from the Tractor 1). Place Bucket Leading edge on the ground and position point ‘A’ 20cm to 30cm from the ground. 2). Lower and adjust.
Motor Vehicle Level 3 Hydraulic Components Resource 3.
Airplane Components and Systems
Landing Gear.
BUrners TRAining CEntre GULLIVER BLU HYDRAULIC SCHEME.
E8, , Wing Damage.
ME 480 Introduction To Aerospace: Chapter 2 Prof. Doug Cairns.
B757 Review Questions.
Good Sensor Hot Sensor Offline Sensor J105 J??? 1 Shuttle Loss of Sensors Timing based on Integ. Time Line Team Data: 2/1/2003; 9:15AM EST.
 Shift lever – used to select a gear  Tachometer – indicates the engine revolutions per minute  Odometer – indicates the total number of the miles.
Indicates primary inverter is inop. Operational secondary and auxiliary inverters will Maintain power to all fixed frequency busses.
Theory of Flight 6.05 Lift and Drag References:
AIRCRAFTS HYDRAULIC SYSTEM
Unit Four Control of Hydraulic Energy Hydraulic energy must be controlled in order to accomplish useful work and be safe. There are three quantities that.
Control of Pneumatic Energy
B757 Review Questions.
Important Features for Utility Tractors Herb Willcutt MSU Ag & Bio Engineering 11/15/06.
With Google Earth ….. ….. we can visit places with the click of a button! ….. we can get directions to anywhere! ….. we can visit other cultures and landmarks.
APPROVED TRAINING MANUAL’S LESSON PLANS AND COURSEWARE STAR MARIANAS AIR, INC. Recurrent – Flight Crew Part III – Aircraft Ground Training Section 2 –
Propellers The engines are equipped with four bladed, full
USING THE DRIVE-ON HOIST. LOADING VEHICLE ON HOIST 01. Ensure that vehicle is centered left to right. 02. Make sure vehicle is in Park, parking brake.
Lesson 12: Aircraft Landing Gear
Plan By Myre Adnan. WHAT I WILL NEED Visual Sensor Pressure Sensor Voice Recorder Cotton sock Levers Wooden Arm Track 2 Wheels Triangle Alarm Clock 2.
Theory of Flight 6.05 Lift and Drag
A ball rolls off of a.68 m tall table and hits the floor with a speed of 6.0 m/s. How fast was the ball moving when it left the table.
E Co 1/214th AVN Regt C-12 Landing Gear.
Automotive Brake Systems, 5/e By James D. Halderman Copyright © 2010, 2008, 2004, 2000, 1995 Pearson Education, Inc., Upper Saddle River, NJ All.
Airplanes By : Hebron Yam,Justin Minucci. How do airplane work? Problem???
GMT 13:52:00 GMT 14:00:00 Good Sensor Hot Sensor Offline Sensor J105 J??? 2/4/2003; 16:19D.J. Kroeger, x Shuttle X-Y Axis Plane Timing based on Integ.
The Parts Of Airplane More information General Aviation planes vary in size and shape but the basic parts remain the same.
Mobility and Navigation AME 470: Senior Design ASME Bulk Material Transporter Matt Bertke, Paul DeMott, Patrick Hertzke, Will Sirokman 23 September 2004.
It is a car launcher. The car goes into the two connect pieces. Then you pull the lever causing the gears to mesh. Then when you let go of the lever.
The Percent Proportion. To solve a proportion, multiply the numbers that are diagonal, divide by the one that’s left.
Interactively change status, schedules, setpoints and strategies
Introduction to Aerospace – Historical Perspective Dr. Doug Cairns.
Provided by Mentors of Team 624
Vehicle Balance, Traction Loss, Roadway and Vehicle Technology Driver Education.
Last updated: 6/28/2016www.alto-shaam.com Rotisserie Training Rotisserie.
Project Document Number GTMP-5076 L-1011oem Wing Upgrades W. M. Langford Advanced Models Systems & Sensors Branch 22 June 2004 (a.k.a. L-1011_mod1) Generic.
When your auto appears the following situations, how to resolve? Producing gear change impact during the running process. Producing gear change impact.
By Joshua Shaw.  We have previously added a While Loop  We are now going to use it for programming the robot  We have also added two motor programs.
AEROFIX STRUCTURAL SERVICES
6.01 Aircraft Design and Construction References: FTGU pages 9-14, 27
LANDING GEAR SYSTEMS THIS TRAINING MANUAL HAS BEEN PREPARED FOR MAINTENANCE TECHNICIANS AND DOES NOT SUPERSEEDED INFORMATION CONTAINED IN APPLICABLE AIRCRAFT.
Landing gear.
MULTI-SPEED GENERAL BRAKING OTHER FUNCTIONS
Suspension Systems Prepared by Vaibhav . S. Sutrave.
Two-Gear Gear Trains Using different size gear allows change in speed
The Airplane Chapter 4 Airframe.
Theory of Flight 6.05 Lift and Drag References:
DANGER DANGER DANGER INTAKE DANGER INTAKE DANGER DANGER DANGER R R E E
KIRBY AEROSPACE Mrs. Gallenberger
Shuttle X-Y Axis Plane Timing based on Integ. Time Line Team Data:
NİŞANTAŞI ÜNİVERSİTESİ
Office 365.
Programming a Servo By Joshua Shaw.
Operating panel instruction
Click on this box and edit text to add pilot or teacher name
Landing Gear and Brakes

Theory of Flight 6.05 Lift and Drag References:
7.1 Area of a Region Between Two Curves.
Shuttle X-Y Axis Plane Timing based on Integ. Time Line Team Data:
Created: 15 Aug 2015 Updated: 20 Sep 2015
Presentation transcript:

Shuttle Loss of Sensors Timing based on Integ. Time Line Team Data: 2/1/2003; 9:15AM EST

Launch Debris Impact Point on bottom of wing Systems appear Nominal 8:52:00 EST Launch Debris Impact Point on bottom of wing View Top Down

Left Main Gear Brake Line Temp D showing high temp 8:52:20 EST

Left Main Gear Brake Line Temp A showing high temp 8:52:39 EST

Left Main Gear Brake Line Temp C showing high temp 8:52:48 EST

Left Inboard Elevon Lower Skin Temp goes off line 8:52:59 EST

Hydraulic Sys 3 Left Outboard Elevon Actuator Return Line Temp goes off line 8:53:10 EST

Hydraulic Sys 1 Left Inboard Elevon Actuator Return Line Temp goes off line 8:53:11 EST

Hydraulic Sys 1 Left Outboard Elevon Actuator Return Line Temp goes off line 8:53:31 EST

Hydraulic Sys 2 Left Inboard Elevon Actuator Return Line Temp goes off line 8:53:36 EST

Left Main Gear Brake Line Temp B showing high temp 8:54:13 EST

Mid Fuselage Left Body Line Temp at x1215 showing high temp 8:54:22 EST

Left Main Gear Strut Actuator Temp showing high temp 8:54:27 EST

LMG Up lock Actuator Unlock Line Temp showing high temp 8:54:36 EST

System 3 Left Main Gear Brake Return Line Temp showing high temp 8:55:23 EST

MLG Left Outboard Wheel Temp Goes off line 8:55:35 EST

Left Lower Wing Skin Temp Left Upper Wing Skin Temp Goes off line 8:56:20 EST

Switch Valve Return Temp System 2 Left Hand Brake Switch Valve Return Temp showing high temp 8:57:54 EST

Main Landing Gear Left Hand Inboard Wheel Temp Goes off line 8:58:35 EST