Long Racket

Materials

Create a 6 to 7 inch diameter loop at one end of the wire Create a 6 to 7 inch diameter loop at one end of the wire. Use the short twisted end of the hanger to secure the loop.

Bend the remaining wire to create the handle Bend the remaining wire to create the handle. Make a small hook to attach the handle.

Racquet should look similar to this, squeeze wires together to create proper handle width (.5 to .75 inches wide).

Wrap sharp edges with tape.

Place entire racquet into hosiery, pull tight, tie at the end and cut remainder.

Wrap tape around handle, be sure to hold wires apart with thumb, wrapping tightly will cause handle to become too small.

Completed Project