Making a Call CISCO SX-10 TeleCart Touch the touch-Screen to awake from sleep. If it’s completely off, hold down the main power switch until unit starts up Touch the dial-pad icon to bring up the dialling pad Type the meeting number from the email/invite, usually an “03xxxxxxxx” number. (Ignore the @ and everything after it, enter only the number) Press the “Call” button Once the call is connected, enter the pin number from the invite, followed by the # Hash key If no one else has joined the Video Conference, you should see a message “You are the only call in this conference”, otherwise you should see the far-end participants Camera Monitor Touch-Screen Height Adjust Wheel Lock Power-switch behind monitor Problems? Please call the CAAC Helpdesk on: (08) 8958 4500 or email it.helpdesk@caac.org.au

During a Call / Ending the Call During the call you can control the camera movement and zoom level Touch the Camera Icon to bring up the move/zoom panel Use the arrows to move the camera and the + and – to Zoom Tick the “Selfview” box to see how you and your patient is centred in the picture. (Use this to ensure the far-side clinician can see the patient clearly) Touch the “End” button to hang-up the call when finished The cart will go into “Sleep Mode” on it’s own after some time Use the Speaker volume up/down keys and the “Microphone Mute” on the touch-screen as required Problems? Please call the CAAC Helpdesk on: (08) 8958 4500 or email it.helpdesk@caac.org.au An editable version of this doc is available to all at: www.amsant.org.au/whatwedo/ehealth/telehealth/ This file “