BOABEAM

Operation principle The principle is very simple. Car equipped with Dash cam and Boa Beam Car equipped with Dash cam Operation principle The principle is very simple. After crash LED turns on and starts blinking if the crash repeated within 5 seconds.

Electronical characteristic Specification Section Contents Standard Composition Main product Power supply wire light connector sensitivity control switch Time control switch Light 2 pcs Tape double side tape 4x16x0.8 General CPU 8RISC Specification Shock sensor Acceleration sensor of semiconductor type Brightness 3m distance 57[lux], brightness 2[lux] 5m distance 30[lux], brightness 2[lux] 7.5 distance 15[lux], brightness 2[lux] Electronical characteristic Operating voltage 12~24V Current on stand by 10mA / 12V Current on motion 550mA / 12V (2pcs lights) Size Size(main product) minimum 60x40x21 [mm] maximum 80x40x21[mm] Size(light) minimum 25x78.5 [mm] maximum 32.5x78.5[mm] Weight(main product) 25g (except for cable) Weight(light) 15g (except for cable) Temperature Motion temperature from 10 degrees below zero to 65 degrees characteristic Storage temperature from 20 degrees below zero to 85 degrees

It works when engine off after 3seconds. Please keep in mind *It depends on a car model Lamp Sensitivity control Time set Light 1 BOABEAM light Light 2 Same connection like front light It works when engine off after 3seconds. Please keep in mind

Backlight cover What is backlight cover ? window BOABEAM cover What is backlight cover ? After bumps or shock the Boa Beam flashes out. The light spreads on the wind screen. It causes to blinding the dash camera. To avoid it and get the proper recording the cover is supposed to be used. Thus, the Boa Beam light comes out and dash camera films lighted street