Electronic Eye Controlled Security System

Slides:



Advertisements
Similar presentations
Measurment project Seven Segment Counter Display Circuit
Advertisements

Indian Institute of Technology Hyderabad Anti sleep Alarm for Students M. Rohit Reddy- cs12b1022 Soumith Raju K – cs12b1037 T Rohit Reddy – ee12b1035.
ELECTRONIC STICK FOR BLIND PEOPLE
Resistor Circuit Symbol
TRANSISTORS Past Paper Questions and Answers EP01– Q11(b) The circuit below is a monostable timing circuit, When activated component C turns on.
GCSE Electronic Products
The All IC’s are usually set up in a DIL (Dual In Line) configuration, this is where there are two sets of parallel connections (the pins). As you can.
Chapter 1 Quick review over Electronics and Electric Components Prepared By : Elec Solv.
Interactive Voice Response System (IVRS) Presented by Sateesh Kuna Srinivasrao Dhavanam Prudhvi Bolli Nirup Charan K Ashok Kumar M Under the guidance of.
A Seminar on ELECTRONIC EYE
Systems Approach Burglar Alarm Project PROBLEM SITUATION DESIGN
gradually rises from 0 to 9V immediately drops from 9V to 0V
1 Applied Control Systems Technology. 2 Pin configuration Applied Control Systems.
Twenty Questions Electronics. Twenty Questions
S e c u r i t y L i g h t E a s t e r E l e c t r o n i c s P r o j e c t Dark Sensor Comparator Monostable Counter Light Brief Design a system that turns.
SECURITY ALARM Done by RINKESH KURKURE.  This project serves as a detecting mechanism to indicate the presence of an object or person in undetected cases.
Modular Electronics Use the systems approach.
Which of the signals below is a digital signal?
Beath High School - Int 1 Physics1 Intermediate 1 Physics Electronics Glossary AND gate to device digital signals to inverter LDR to logic circuit logic.
Automatic accident avoiding system PROJECT MEMBERS MUTHUKUMAR.K (05ME33) SAKTHIDHASAN.S (05ME39) SAKTHIVEL.N (05ME40) VINOTH.S (05ME56) PROJECT GUIDE:
Electronic. Analog Vs. Digital Analog –Continuous –Can take on any values in a given range –Very susceptible to noise Digital –Discrete –Can only take.
CONTENTS: 1.Abstract. 2.Objective. 3.Block diagram. 4.Methodology. 5.Advantages and Disadvantages. 6.Applications. 7.Conclusion.
SUBMITTED BY LENIN C INTRODUCTION Railways - cheapest mode of transportation. Aims to avoid accidents. Using simple electronic components- automate.
18240 Element two - Components INPUTS OUTPUTS PURPOSE TYPICAL USE.
BLDC Motor Speed Control with RPM Display. Introduction BLDC Motor Speed Control with RPM Display  The main objective of this.
PROJECT ON FAULT ANALYSIS AND DETECTION GUIDED BY:: SUBMITTED BY:- MS. SHUBRA GOEL.
MICROCONTROLLER BASE FIRE ALARM MADE BY: *Priya Rabadia *Rajdeep Rupapara.
Controlling Home Appliances Using Voice. Controlling Home Appliances Using Voice Introductio n  Home automation has an important.
Wireless Rash Driving Detection. Introduction Wireless Rash Driving Detection  To detect rash driving on highways and to alert.
Chapter 6: Voltage Regulator
COIN BASED CELL PHONE CHARGER by sarin krishna k.r
CALLBELL WITH WELCOME DISPLAY Submitted b y SHAIK KHADEER 09QQ1A0434 SYED AMEER SOHEL 09QQ1A0437.
RASH DRIVING WARNING SYSTEM FOR HIGHWAY POLICE
HIDDEN ACTIVE CELL PHONE DETECTOR
Mini Project Onkar Deshmukh Sarang Gadhave Sheshanarayan Dhakane
SECURITY ALARM SYSTEM BY PHOTO ELECTRIC SENSOR
A project report on CHRISTMAS DECORATION LIGHT
ELECTRONIC EYE CONTROLLED SECURITY SYSTEM
Connect 4 Change the terms in the following template to customize Connect 4 for any topic. You will need to copy one copy of one of the two templates.
Arduino Based Industrial appliances control system by decoding dual tone multi frequency signals on GSM / CDMA network. Submitted by:
OVER VOLTAGE OR UNDER VOLTAGE
Home automation using Arduino & ‘PIR sensor’
LOAD CUTOFF SWITCH UPON OVER VOLTAGE OR UNDER VOLTAGE
REMOTE JAMMING DEVICE.
AUTOMATIC STREET LIGHT CONTROL USING LDR
LAPTOP THEFT IDENTIFIER.
(EVENING ON TO MORNING OFF)
SCADA for Remote Industrial Plant
3 PHASE SEQUENCE CHECKER BY LED INDICATION
Project of Linear Circuit Analysis
INDUCTION MOTOR PROTECTION FOR SINGLE PHASING, OVERVOLTAGE AND OVER TEMPERATURE Submitted by:
ARDUINO LINE FOLLOWER ROBOT
LASER SECURITY ALARM[140] DIRECTOR OF MGM’s COE,NANDED
FASTEST FINGER PRESS QUIZ BUZZER
QUIZ COMPETITION SENSOR FOR FASTEST FINGER PRESS
Potential Divider Aims What is a potential divider
Basic Electronics.
GOVT WOMEN ENGINEERING COLLEGE AJMER
AUTOMATIC STREETLIGHT CONTROL USING
AQA GCSE 6 Systems approach to designing Design and Technology 8552
Twenty Questions Electronics.
Electronics – Learning Outcomes
Churchmead Design Technology
ELEC207 Linear Integrated Circuits
Designing Electric Circuits
ELECTRONIC SYSTEMS Note: There is no compulsory question set on Section 25 of the syllabus. Questions set on topics within Section 25 are always set as.
Electricity and Circuits
Describe the action of thermistors and light- dependent resistors and show understanding of their use as input transducers Thermistor A transducer is an.
Photoelectric Switch Department Of Physics Prof.Kurkute.P.V.
Electronic systems 7.
Presentation transcript:

Electronic Eye Controlled Security System ssss Electronic Eye Controlled Security System

Electronic Eye Controlled Security System Introduction The main aim of this project is used to provide security system for cash boxes, lockers in malls, jeweler shops, homes and banks and also to watch continuously if any person is visiting your home. Nowadays, automation is a developing technology. For instance, a doorbell that continuously generates ringtones when an unauthorized person visit your home. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Block Diagram http://www.edgefxkits.com/

Electronic Eye Controlled Security System Hardware Components Battery Slide switch LDR Ripple Counter IC Transistor Buzzer Relay Bulb Diode Transformer Capacitor Resistor http://www.edgefxkits.com/

Electronic Eye Controlled Security System Resistor Resistor is a passive two - terminal electrical component that implements electrical resistance as a circuit element. The ratio of the voltage applied across a resistor's terminals to the intensity of current through the circuit is called RESISTANCE. The relation is represented by Ohm's Law : V=IR http://www.edgefxkits.com/

Electronic Eye Controlled Security System IC- CD4060 IC- CD4060 is a ripple binary counter/divider. It consists of an oscillator section and 14 ripple carry binary counter stages. The oscillator configuration allows design of either RC or crystal oscillator circuits. A RESET input is provided which resets the counter to the all O's state and disables the oscillator. http://www.edgefxkits.com/

Electronic Eye Controlled Security System IC- CD4060 Features High Voltage Type (20V) Common Reset 12MHz Clock Rate at 15V Fully Static Operation Buffered Inputs and Outputs Schmitt Trigger Input Pulse Line Standardized, Symmetrical Output Characteristics 100% Tested for Quiescent Current at 20V 5V, 10V and 15V Parametric Ratings http://www.edgefxkits.com/

Electronic Eye Controlled Security System Description About Project This project is to design an Electronic Eye Security Controlled System for homes and public places like banks, malls, etc. It uses a LDR sensor to sense the intensity of light and produces an alarm for representing thefts, and also switches ON the lights. This electronic security system is placed inside lockers and cash boxes. When an unauthorized person tries to open the locker door and uses a torch light to find the valuable things, the torch light falls on the electronic eye giving a signal to the buzzer. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Description About Project It uses a 14 stage ripple binary counter to detect the intensity of light through the light dependent resistor(LDR). The relay driver is connected with the binary counter to control the different loads. The buzzer is attached to the circuit using a transistor to give an indication to the users. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Description About Project Whenever an intensity of light falls on the LDR then the resistance of this LDR will decrease. Thus, the ripple counter triggers the transistors. Also, these transistors trigger the buzzer and load connected to the relay to indicate a theft. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Working LDR senses the light intensity and generates an alarm for indicating thefts and also turns ON the light. If the cash box is in closed condition, the interior will be dark. Hence in the dark, LDR resets CD4060 and it stops oscillating and counting. So neither the buzzer sounds, nor the relay energizes, indicating that the cash box is closed. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Working If someone tries to open the door of the cash box and uses a torch light to find the valuables. Then the light most probably from the burglar's touch falls on LDR fitted into the cash box. As a result, LDR conducts and goes low. Hence pin 14 of IC1 goes high for two seconds after the door is opened and goes low for another 2 seconds. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Working So the buzzer sounds for two seconds and then falls silent for the following two seconds. This cycle repeats until the cash box is closed. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Circuit Operation Initially, connect the circuit as shown in the circuit diagram on the bread board. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Circuit Operation Now connect the supply voltage of 9v using battery. Place the LDR in light. You can observe no sound is produced from the buzzer. Place the LDR in dark, buzzer starts ringing. LED connected to the buzzer also starts blinking. As the intensity falling on the LDR increases, sound produced by the buzzer increases. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Applications Mainly used in security applications. Door bell circuits. Garage door opening circuits. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Advantages Used to provide Security. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Disadvantages Light is required in front of door bell. If any person come in & out then the bell will ring. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Future Scope The future scope of this project can be augmented by implementing it by using a GSM modem and a microcontroller. The GSM modem can be interfaced to the microcontroller to send and receive SMS to the user in case of burglary. http://www.edgefxkits.com/

Electronic Eye Controlled Security System Conclusion Electronic Eye controlled Security System, device utilizes binary counter as input. It has been successfully demonstrated that, this will serve as a device for providing security. It provides the user with efficient and reliable security system for houses, malls etc; that supports the use of a binary counter which sense the intensity of light through LDR and activating the buzzer indicating a theft. http://www.edgefxkits.com/

http://www.edgefxkits.com/