WIRELESS POWER TRANSFER

Slides:

Advertisements

Similar presentations

AUTO SELECTION OF ANY AVAILABLE PHASE,

Advertisements

WIRELESS POWER TRANSMISSION FOR MOBILE AND WHEELCHAIR CHARGING OF PHYSICALLY CHALLENGED PEOPLE PROJECT BY : REBECCA ROY.

SUN TRACKING SOLAR PANEL. Introduction The main objective of this project is to track the sun and rotate the solar panel accordingly, to receive sunlight.

9/29/2004EE 42 fall 2004 lecture 131 Lecture #13 Power supplies, dependent sources, summary of ideal components Reading: Malvino chapter 3, Next:

Electronics II Lab. Two Weeks. power connections Solderless Prototyping Board jacks for power connections.

How Coils Work A basic introduction into Coil technology.

Overview of RFID System Characteristics Operating Frequency Method of Coupling Transmission Range Data Storage Capacity Power Supply (Active, Passive)

Schematic Symbols The Key to Understanding Wiring Diagrams.

General Licensing Class G7A – G7C Practical Circuits Your organization and dates here.

POWER SUPPLIES. The Power Supply A station’s power supply (sometimes known as a power supply unit or PSU) is a device or system that supplies electrical.

Schematics 201 Lecture Topic: Electrical Symbols

Frequently Unasked Questions Loyola Blakefield Introduction to Engineering March 8, 2012 Bob Rassa, Raytheon Space & Airborne Systems

Supervisor: Falah Mahmmoud. Brief History about WPT. * The first existence was in 1990 by Nickola Tesla. *Wireless power transmission with microwaves.

Electronic Parts.

Introduction to Power Supplies

SUBMITTED BY LENIN C INTRODUCTION Railways - cheapest mode of transportation. Aims to avoid accidents. Using simple electronic components- automate.

18240 Element two - Components INPUTS OUTPUTS PURPOSE TYPICAL USE.

Self Switching Power Supply. Introduction Self Switching Power Supply  Embedded system requires a regulated power supply.

BLDC Motor Speed Control with RPM Display. Introduction BLDC Motor Speed Control with RPM Display  The main objective of this.

Switch Mode Power Supply(SMPS) BY: Arijit Acharya NETAJI SUBHASH ENGINEERING COLLEGE M.tech(P.S.) Roll No - 1.

Wireless Power Transmission Using SPS and Rectenna

AUTOMATIC EMERGENCY LED LIGHT SUBMITTED BY. ABSTRACT This automatic emergency led light used in night at emergency time when the power cut or off by some.

Chapter 6: Voltage Regulator

COIN BASED CELL PHONE CHARGER by sarin krishna k.r

Wireless power transfer by High frequency resonating coils.

Presented by Under the esteemed guidance of D.GANGADHAR REDDY, M. Tech. Asst. Prof., EEE Department UNIVERSAL COLLEGE OF ENGINEERING & TECHNOLOGY AUTO.

ARDUINO BASED UNDERGROUND CABLE FAULT DETECTION

TELEPHONE RING SENSED FLASHER IN INDUSTRIAL AREA

AUTOMATIC EMERGENCY LIGHT WITH LED

Electronic Eye Controlled Security System

HIDDEN ACTIVE CELL PHONE DETECTOR

Wireless Power Driven Car or Train

WIRELESS POWER TRANSFER

AC Power Transfer Wirelessly by HF

WIRELESS TV HEADPHONE CIRCUIT

Connect 4 Change the terms in the following template to customize Connect 4 for any topic. You will need to copy one copy of one of the two templates.

CHAPTER 6 SPECIAL TRANSFORMERS Electrical Machines.

THREE PHASE FAULT ANALYSIS WITH AUTO RESET ON TEMPORARY FAULT AND PERMANENT TRIP OTHERWISE Submitted by:

Wireless power transfer by High frequency resonating coils

WIRELESS POWER TRANSFER

Arduino Based Industrial appliances control system by decoding dual tone multi frequency signals on GSM / CDMA network. Submitted by:

PROPELLER DISPLAY OF MESSAGE BY VIRTUAL LEDS

High Voltage Engineering High Voltage Direct current (HVDC)

Arduino BASED RFID Device Access

Project Title EVM IN 8051 Under the Guidance of Submitted by.

Resistance Impedance Energy Storage Resistor R Ohms Reactance Z Ohms

Textbook Detection System With Radio-Frequency Identification

FM TRANSMITTER 2 KM RANGE FOR YAGI ANTENNA

3 PHASE SEQUENCE CHECKER BY LED INDICATION

PC Mouse operated Electrical Load Control Using VB Application

WIRELESS NETWORKING OF

INDUCTION MOTOR PROTECTION FOR SINGLE PHASING, OVERVOLTAGE AND OVER TEMPERATURE Submitted by:

Project Title ARDUINO BASED WIRELESS ELECTRICAL APPARATUS CONTROL SYSTEM USING IR COMMUNICATION Under the Guidance of Submitted by.

INCOMING PHONE RING LIGHT FLASHER

FASTEST FINGER PRESS QUIZ BUZZER

QUIZ COMPETITION SENSOR FOR FASTEST FINGER PRESS

Infrared Transmitter and Receiver

POWER SAVING LED LIGHT REPLACING CONVENTIONAL LAMPS

The Key to Understanding Wiring Diagrams

CHAPTER 10 Power Supplies.

General Licensing Class

Cell Phone Charger Project

IOT based Home Automation Over the Cloud

Reading: Malvino chapter 3, Next: 4.10, 5.1, 5.8

The Transfer Function.

PHASE SEQUENCE CHECKER

The Key to Understanding Wiring Diagrams

Which of the following devices or circuits changes an alternating current into a varying direct current signal? A. Transformer B. Rectifier C. Amplifier.

A. Bill of materials B. Connector pinout C. Schematic D. Flow chart

Photoelectric Switch Department Of Physics Prof.Kurkute.P.V.

Presentation transcript:

WIRELESS POWER TRANSFER IN 3D SPACE Submitted By

Introduction The main objective of this project is to develop a system of wireless power transfer for medical applications. Many people use pace makers implanted in their body that runs on a battery.

FUTURE SCOPE The project can be enhanced in future up to 1 meter distance in space using resonators with a Q factor of 1,000 enabling it to send power over a distance 9 times the radius of the coil of 11 CMs .

Contents Introduction Block diagram Hardware requirements Power supply Schematic diagram Working of the project Advantages Applications Conclusion

Block diagram

Hardware requirements HIGH FREQUENCY TRANSFORMER RECTIFIER FILTER VOLTAGE REGULATOR TRANSISTOR COIL LED 1N4007 RESISTOR CAPACITOR

Hardware Components description 1.Design of HF transformers

Hardware Components description 2. Using In4007 as Bridge rectifier 3. Capacitors Filter(470µf) 4. 5v Regulator 5. Relay

7. LED 6.COIL 8. RESISTOR

DESCRIPTION AND WORKING Please refer CD

11. Capacitor

Description of HF transformers Electric power transmission over long distances. High-voltage direct-current HVDC power transmission systems Large, specially constructed power transformers are used for electric arc furnaces used in steelmaking. Rotating transformers are designed so that one winding turns while the other remains stationary. A common use was the video head system as used in VHS and Beta video tape players. These can pass power or radio signals from a stationary mounting to a rotating mechanism, or radar antenna.