Power Supply Design Industrial Attachment Training-2017 Presented By:

Slides:

Advertisements

Similar presentations

Current Electricity - Symbols

Advertisements

TUTORIAL 3 Q1 Draw and label a block diagram the elements of a DC power supply which receives an input from the 240 V; 50 Hz mains and produces an output.

Regulated Linear Power Supply

Uninterruptible Power Supply (UPS)

Switching-Mode Regulators

POWER SUPPILES LECTURE 20.

Chapter 1 Quick review over Electronics and Electric Components Prepared By : Elec Solv.

BASIC ELECTRONICS.

Chapter 6 Voltage Regulators - Part 2-.

By S K Rai Electronics Engineering Department BKBIET, CEERI Road Pilani (Raj.)

IC Voltage Regulator.

CHAPTER 6 VOLTAGE REGULATOR POWER SUPPLIES (VOLTAGE REGULATORS) Fig. 6.1 Block diagram showing parts of a power supply. Power supply Power supply: a.

CHAPTER 18 Power Supplies. Objectives Describe and Analyze: Power Supply Systems Regulation Buck & Boost Regulators Flyback Regulators Off-Line Power.

Dc regulated power supply SKN. Introduction All electronic circuits need DC power supply either from battery or power pack units. Many electronic equipment.

AN-NAJAH NATIONAL UNIVERSITY DEPARTMENT OF ELECTRICAL ENGINEERING Investigation On a Microcontroller-Triggered Single Phase Thyristor Bridge PREPARED BY:

Measuring the Current and Voltage of a 820 Ω Resistor Setting for Multimeter = 200 mA DC Measure Voltage in 2 V increments up to 20 V.

Half wave rectification By:Engr.Irshad Raheem Memon.

1 ELCT Class performance (Quizzes 1&2 and Midterm)

EMT212 Analog Electronic II

Regulated Power Supplies

Power Supply The basic function of power supply is to convert the AC supplies available at wall socket, that which is unusable by the computer. The SMPS.

1.0 LINEAR DC POWER SUPPLY The importance of DC Power Supply Circuit For electronic circuits made up of transistors and/or ICs, this power source.

Basic Equipment and Schematic Reading. Objectives Learn the basic equipment that will be used in the Lab. Learn some of the basic symbols used on electrical.

Zener Diode Circuits for Power Supply Designs Section 4.4.

1 Electrical Fundamentals We need some understanding of electrical fundamentals to do the lab exercises. Electric Circuit Consists of: –Power Source: Battery,

7. Design of BJT, Op. Amp., IC Regulated Power Supplies

Self Switching Power Supply. Introduction Self Switching Power Supply  Embedded system requires a regulated power supply.

Single Phase Induction Motor Speed Control. Introduction Single Phase Induction Motor Speed Control  Induction motors are.

Chapter 1 Common Diode Applications Basic Power Supply Circuits.

Bridge Rectifier Circuit with Working Operation and Their Types.

PSX-R. What is the PSX-R? PSX-R is a separate high quality power supply PSX-R acts like a giant battery PSX-R supplies regulated smooth DC power to the.

RAIN ALARM WITH AIR FLOW DETECTOR

Chapter 6: Voltage Regulator

Presented by Under the esteemed guidance of D.GANGADHAR REDDY, M. Tech. Asst. Prof., EEE Department UNIVERSAL COLLEGE OF ENGINEERING & TECHNOLOGY AUTO.

Switching-Mode Regulators

SINGLE PHASE INDUCTION MOTOR SOFT START BY STEPPED DELAY OF REDUCING FIRING ANGLE Submitted by:

Single Phase Induction Motor Speed Control

Presentation 3: Detailed Design and DFM considerations

LOW VOLTAGE DC TOHIGHER VOLTAGE DC UP 6 VOLT DC TO 10 VOLT DC USING 555 TIMER SUBMITTED BY.

Uninterruptible Power Supply (UPS)

Dual Power Supply Design Industrial Attachment Training-2017

Eric A Lewis Enstore director

CHAPTER 6 VOLTAGE REGULATOR Tulus Ikhsan Nasution.

Subject Name: LINEAR INTEGRATED CIRCUITS Subject Code: 10EC46

THREE PHASE FAULT ANALYSIS WITH AUTO RESET ON TEMPORARY FAULT AND PERMANENT TRIP OTHERWISE Submitted by:

Circuit Simulation Training

OVER VOLTAGE OR UNDER VOLTAGE

LOAD CUTOFF SWITCH UPON OVER VOLTAGE OR UNDER VOLTAGE

SELF SWITCHING POWER SUPPLY

SELF SWITCHING POWER SUPPLY

Chapter 27 Power Supplies.

SOFT START OF SINGLE PHASE PUMP MOTOR

Visit for more Learning Resources

AC Inlet & AC Input Filter

Fault detection Lecture (3).

PC CONTROL USING TV REMOTE

Dr. Unnikrishnan P.C. Professor, EEE

Power Supplies AIM: To understand the simple power supply in terms of the transformer, rectification, smoothing and regulation. PRIOR KNOWLEDGE: A.C.

Power Electronics Introduction Bipolar Transistor Power Amplifiers

Draw and interpret circuit diagrams containing sources, switches, resistors (fixed and variable), heaters, thermistors, light-dependent resistors, lamps,

Prepared by: Engr. Qurban Ali Memon Incharge of Final project Lab.

Lecture No# 8 Prepared by: Engr. Qurban Ali Memon

Single-Phase Uncontrolled Rectifiers Chp#5

Dr. Unnikrishnan P.C. Professor, EEE

Figure 2.43 Full-wave voltage doubler.

Lecture No# 4 Prepared by: Engr. Qurban Ali Memon

Lecture No# 6 Prepared by: Engr. Qurban Memon

Radhabai Kale mahila mahavidyalaya,ahmednagar Department of Physics

Roanoke Valley Amateur Radio Club

Presentation transcript:

Power Supply Design Industrial Attachment Training-2017 Presented By: Engr. Shah Mim Obydulla B.Sc in EEE (DUET) Director of Rainbow Automation Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Power Supply .. AC Power Supply DC Power Supply Switch Mode Power supply (SMPS) Transformer Based Power Supply 1. Fixed Power Supply 2. Dual Power Supply 3. Variable Power Supply ( 0v, +5v, +12v .etc ) (+12 v, 0v, -12v .etc) ( 0 ~ V ) Rainbow Automation Industrial Attachment Training-2017

Circuit Diagram Of Fixed Power Supply O/P 12V*2 , 3000mA D1 1N4007 I/P 220V AC Pulse sating dc ac + dc Pure dc IC +12 V + 1000 uf 50 V C 1 0 V 17 V V Output 12V _ Transformer D2 1N4007 V rms = V max * 0.7071 =24 x 0.7071=17V 0 V Fig: Circuit Diagram Of Fixed Power Supply Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Necessary Equipment Transformer (12V x2 ,3000mA)------01pcs Soldering Stand-----------------01pcs Diode (IN4007)-------------------------02pcs Soldering Lead (as per requirement) Capacitor (1000µF/50V)-------------01pcs Soldering Rosin (as per requirement) Regulator (IC 7812)-------------------01pcs Safety Goggle ------------------01 pcs DC Load (Fan-12V)--------------------01pcs Connecting Wire (as per requirement) Multimeter ----------------------------- 01pcs Wire Stripper (as per requirement) Soldering Iron---------------------------01pcs Masking Tape (as per requirement) Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Transformer A.C Input 220V A.C O/P 12V A.C Input 220V 0V A.C O/P 12V A.C Output Fig: Transformer Fig: Transformer Symbol Rainbow Automation Industrial Attachment Training-2017

Anode Cathode Diode Industrial Attachment Training-2017 Fig: Diode Fig: Diode Symbol Rainbow Automation Industrial Attachment Training-2017

- - Capacitor + + Industrial Attachment Training-2017 Fig: Capacitor Fig: Capacitor Symbol Rainbow Automation Industrial Attachment Training-2017

Voltage Regulator IC 780XX 1 2 3 Input GND Output Fig: Voltage Regulator IC Fig: Voltage Regulator IC Symbol Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 DC Load Fig: Cooling Fan & Lamp e.t.c Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Soldering Iron Fig: Soldering Iron with Stand Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Soldering Lead & Rosin Fig: Soldering Lead Fig: Soldering Rosin Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Wire Stripper & Wires Fig: Wire Stripper Fig: Wires Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Wiring Diagram Input AC 220 V Fig: Wiring Diagram of Fixed Power Supply Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Rainbow Automation Industrial Attachment Training-2017