Vidhyadeep institute of management and technology Electrical : B 27/11/2014

Electrical Measuring and Measurement Instruments PATEL NILAY (1409430109013) PATEL NISHA (1409430109014) PATEL PRIYA (1409430109015) PATEL VARISH (1409430109016) PATEL VATSAL (1409430109017) 27/11/2014

THERMOCOUPLE Most frequently used method to measure temperatures with an electrical output signal.

What are thermocouples? Thermocouples operate under the principle that a circuit made by connecting two dissimilar metals produces a measurable voltage (emf-electromotive force) when a temperature gradient is imposed between one end and the other. They are inexpensive, small, rugged and accurate when used with an understanding of their peculiarities.

Thermocouples Principle of Operation In, 1821 T. J. Seebeck observed the existence of an electromotive force (EMF) at the junction formed between two dissimilar metals (Seebeck effect). Seebeck effect is actually the combined result of two other phenomena, Thomson and Peltier effects. Thomson observed the existence of an EMF due to the contact of two dissimilar metals at the junction temperature. Peltier discovered that temperature gradients along conductors in a circuit generate an EMF. The Thomson effect is normally much smaller than the Peltier effect.

Let’s take a look at this circuit

How thermocouples work It is generally reasonable to assume that the emf is generated in the wires, not in the junction. The signal is generated when dT/dx is not zero. When the materials are homogeneous, e, the thermoelectric power, is a function of temperature only. Two wires begin and end at the same two temperatures. How thermocouples work Generally, a second order Eqn. is used.

Material EMF versus Temperature With reference to the characteristics of pure Platinum Chromel Iron emf Copper Platinum-Rhodium Alumel Constantan Temperature

Thermocouple Effect Any time a pair of dissimilar wires is joined to make a circuit and a thermal gradient is imposed, an emf voltage will be generated. Twisted, soldered or welded junctions are acceptable. Welding is most common. Keep weld bead or solder bead diameter within 10-15% of wire diameter Welding is generally quicker than soldering but both are equally acceptable Voltage or EMF produced depends on: Types of materials used Temperature difference between the measuring junction and the reference junction

Thermocouple Tables (EMF-Temperature) Thermocouple tables correlate temperature to emf voltage. Need to keep in mind that the thermocouple tables provide a voltage value with respect to a reference temperature. Usually the reference temperature is 0°C. If your reference junction is not at 0°C, a correction must be applied using the law of intermediate temperatures.

Reference Temperature Systems and Zone Boxes Ice Baths Accurate and inexpensive Electronically Controlled References Require periodic calibration and are generally not as stable as ice baths, but are more convenient.

Zone boxes A zone of uniform temperature that insures all connections made within the zone are at the same temperature.

What thermocouple materials should be used? Depends on requirements: Temperature range? Required accuracy Chemical resistance issues Abrasion or vibration resistance Installation requirements (size of wire) Thermal conduction requirements

Thermocouple Material Vs EMF Types T, J, and K are most commonly used thermocouples (see Table 16.8 of the “Handbook”).

Thank you….