Unit 1 Vocabulary The easiest thing to do is to plug in 1 and -1 (or 2 and -2) if you get the same y, then it’s Even. If you get the opposite y, then it’s.

Slides:

Advertisements

Similar presentations

Session 55 Draw six segments that pass through every dot in the figure without taking your pencil off the paper.

Advertisements

Transformations Vocabulary.

Vocabulary:  Transformation – a one-to-one correspondence between two sets of points  Pre-image – the original figure  Image – figure after transformation.

HW #17 pg. 194 #5-7, 15-17, 21, 26, 29.  Theorem 3.8  If two lines intersect to form two congruent angles that are a linear pair, then the lines must.

Reagan’s unit 5 math vocab

Introduction Geometric figures can be graphed in the coordinate plane, as well as manipulated. However, before sliding and reflecting figures, the definitions.

Unit 5 Vocab By: Mika Hamady. Acute Angle Definition: An acute angle is an angle that is less then 90 degrees. Examples: 1.A 43 degree angle is acute.

Unit 4 Math Vocabulary By Noah Morisi. Acute Angle An acute angle is an angle that measures out less than 90 degrees.

Unit 5 Vocab By: Gus Koza. Acute angle An angle that is less than 90 degrees.

9.1 Translations -Transformation: a change in the position, shape, or size of a geometric figure -Preimage: the original figure -Image: the resulting figure.

Warm Up Add five more straight lines to make 10.

Vocabulary Sheets Why??? Do I have to?? Code. Angle [definition] Formed by two rays with the same endpoint [picture or example of term] [symbol]

9.1 – Translate Figures and Use Vectors

Welcome Back! September 8, Refresher:  Be courteous of others  Pay Attention  If you miss a day it is YOUR responsibility to make anything up.

Lesson 14.5 Pre-AP Geometry

1.4 Rigid Motion in a plane Warm Up

2 pt 3 pt 4 pt 5pt 1 pt 2 pt 3 pt 4 pt 5 pt 1 pt 2pt 3 pt 4pt 5 pt 1pt 2pt 3 pt 4 pt 5 pt 1 pt 2 pt 3 pt 4pt 5 pt 1pt Vocab 1 Vocab 2 Transformations CompositionsMiscellaneous.

Draw six segments that pass through every dot in the figure without taking your pencil off the paper. Session 55.

WAM “Writing About Math”

Draw six segments that pass through every dot in the figure without taking your pencil off the paper. Session 55.

Lines and Angles Ray Congruent Equal in size and shape.

Unit 2 Vocabulary. Angle A shape, formed by two lines or rays diverging from a common point (the vertex). The angle is.

Unit 5 Vocabulary. Angle The area between two connecting lines measuring less than 180° but greater than 0° The angle is.

Opener- What will this unit be about based on this wordle? Try to write a standard with these words..

What is a rigid transformation?  A transformation that does not change the size or shape of a figure.

Unit 1: Transformations in the Coordinate Plane Learning Target: Students can know precise definitions of angle, circle, perpendicular line, parallel line,

plane shape A shape in a plane that is formed by curves, line segments, or both. These are some plane figures 12.1.

Geometry Vocabulary Quiz Study Powerpoint

Day 117 – Unit 5: Transformations in the Coordinate Plane

9.4 : Compositions of Transformations

Session 2 Draw six segments that pass through every dot in the figure without taking your pencil off the paper.

Session 2 Draw six segments that pass through every dot in the figure without taking your pencil off the paper.

Sect. 7.1 Rigid Motion in a Plane

Objectives Draw, identify, and describe transformations in the coordinate plane. Use properties of rigid motions to determine whether figures are congruent.

Transformations.

Warm Up A figure has vertices A, B, and C. After a transformation, the image of the figure has vertices A′, B′, and C′. Draw the pre-image and the image.

Go Math Grade 3 Chapter 12 Two-Dimensional Shapes

Warm Up Add five more straight lines to make 10..

Every segment is congruent to its image.

Every segment is congruent to its image.

Candy Land Geometry 18.1.

Y. Davis Geometry Notes Chapter 9.

~Adapted from Walch Education

Introduction Geometric figures can be graphed in the coordinate plane, as well as manipulated. However, before sliding and reflecting figures, the definitions.

Transformations in the Coordinate Plane

Reflections & Rotations

9.1 Translations -Transformation: a change in the position, shape, or size of a geometric figure -Preimage: the original figure -Image: the resulting figure.

Warm-Up (Do not write questions.)

4.1: Congruence and Transformation

Translations 1 Nomenclature 2 Translations 3 Practice Problems.

9.1: Reflections.

Warm-up: Using the Pythagorean Theorem

Point An exact position or location in a given plane.

Which is heavier?.

Session 55 Draw six segments that pass through every dot in the figure without taking your pencil off the paper.

Unit 5 Vocabulary The easiest thing to do is to plug in 1 and -1 (or 2 and -2) if you get the same y, then it’s Even. If you get the opposite y, then it’s.

Measures and Relationships

Warm-up: Using the Pythagorean Theorem

Unit 1 Vocabulary The easiest thing to do is to plug in 1 and -1 (or 2 and -2) if you get the same y, then it’s Even. If you get the opposite y, then it’s.

Objectives Draw, identify, and describe transformations in the coordinate plane. Use properties of rigid motions to determine whether figures are congruent.

Warm-Up 2. What type of symmetry does the figure to the right have? How do you know?

Warm-UP 3/13/14 Read and Think about the following statistics. Then, answer the questions below: 10% of students in low-income communities who decide.

Transformations and Congruence

Point An exact position or location in a given plane.

Unit 5 Vocabulary The easiest thing to do is to plug in 1 and -1 (or 2 and -2) if you get the same y, then it’s Even. If you get the opposite y, then it’s.

Day 47 – Fixed points and invertibility in rigid motion

Unit 5 Vocabulary The easiest thing to do is to plug in 1 and -1 (or 2 and -2) if you get the same y, then it’s Even. If you get the opposite y, then it’s.

Unit 5 Vocabulary The easiest thing to do is to plug in 1 and -1 (or 2 and -2) if you get the same y, then it’s Even. If you get the opposite y, then it’s.

Unit 1 Vocabulary The easiest thing to do is to plug in 1 and -1 (or 2 and -2) if you get the same y, then it’s Even. If you get the opposite y, then it’s.

Presentation transcript:

Unit 1 Vocabulary The easiest thing to do is to plug in 1 and -1 (or 2 and -2) if you get the same y, then it’s Even. If you get the opposite y, then it’s Odd. If you get different y’s, then it’s Neither.

Angle An angle measuring less than 90° but greater than 0° The angle is

Circle The set of points on a plane at a certain distance, or radius, from a single point, the center

Perpendicular Line Two lines that intersect at a right angle (90°). Written as

Parallel Line Lines in a plane that either do not share any points and never intersect, or share all points. Written as

Line Segment A line with two endpoints. Written as

Point An exact position or location in a given plane. Point A or Point B

Line The set of points between points P and Q in a plane and the infinite number of points that continue beyond the points. Written as

Distance along a line The linear distance between two points on a given line.

Right Angle An angle that measures 90°.

Acute Angle An angle measuring less than 90° but greater than 0°.

Obtuse Angle An angle measuring greater than 90° but less than 180°.

One-to-One A relationship wherein each point in a set of points is mapped to exactly one other point.

Pre-image The original figure before undergoing a transformation.

Image The new, resulting figure after a transformation

Isometry A transformation in which the preimage and image are congruent.

Every segment is congruent to its image. Transformations are called RIGID if every image is congruent to its preimage. Rigid transformations can also be referred to as an ISOMETRY. Every segment is congruent to its image.

Which of the following are rigid transformations? (Isometry)

Isometries not only preserve lengths, but they preserve angle measures parallel lines, and betweenness of points

Find the value of each variable, given that the transformation is an isometry.

Congruent Figures are congruent if they have the same shape, size, lines, and angles.

Similar Triangles Triangles are similar if they have the same shape but have different sizes.