Date of download: 10/17/2017 Copyright © ASME. All rights reserved. From: In Vitro Quantification of Guidewire Flow-Obstruction Effect in Model Coronary Stenoses for Interventional Diagnostic Procedure J. Med. Devices. 2007;1(3):185-196. doi:10.1115/1.2776336 Figure Legend: Experimental setup showing the flow loop, data acquisition system, and stenotic test section

Date of download: 10/17/2017 Copyright © ASME. All rights reserved. From: In Vitro Quantification of Guidewire Flow-Obstruction Effect in Model Coronary Stenoses for Interventional Diagnostic Procedure J. Med. Devices. 2007;1(3):185-196. doi:10.1115/1.2776336 Figure Legend: Hyperemic and basal pulsatile flow versus time generated in the flow loop and applied to the test section. S, start of systole; D, start of diastole. The flow wave form obtained in the in vitro experiment is based on the flow wave form obtained by in vitro calibration (Cho ).

Date of download: 10/17/2017 Copyright © ASME. All rights reserved. From: In Vitro Quantification of Guidewire Flow-Obstruction Effect in Model Coronary Stenoses for Interventional Diagnostic Procedure J. Med. Devices. 2007;1(3):185-196. doi:10.1115/1.2776336 Figure Legend: CFR-prh line for mean pressure and flow data for pulsatile flow experiment. Hemodynamic hyperemic end points, as shown in Table , are represented by red donuts in the figure. The line connecting these three end points is used to limit the experimental data to calculate the hyperemic flows.