Principle of the process Design For Manufacturing (DFM) Structure Process modeling Defects Design For Manufacturing (DFM) Process variation Metal forming Rolling Module 8

Rolling Process: Mechanics Analysis Two opposite rolls and a piece of material flows between them. The shape of rolls can be designed in a different form to construct a product with different cross sections. handout 8 b

Objectives of mechanics analysis Physical phenomenon Torque Power Productivity System parameters Operating parameters handout 8 b

Spreading: Volume before rolling = the volume after rolling Physical phenomenon L w t Spreading: Volume before rolling = the volume after rolling Volume flow rate conservation handout 8 b

Work velocity = Roll velocity Vo < Vr < Vf No-slip point Slipping Slipping Work velocity = Roll velocity handout 8 b

k e Y = + 1 n For the rolling process, the true strain is: The average flow stress is the same expression, i.e. k e n Y = f + 1 n handout 8 b

The friction force is developed based on It is the friction between the work and the roll that drives the workflow between two rolls. Greater Friction Force No-slip point Lesser Friction Force The friction force is developed based on coefficient of the friction and compression force of rolls handout 8 b

Friction causes Rolling If Friction=0, then draft=0, means NO ROLLING Condition to roll- Coefficient of the friction draft, d = |tf-t0|: dmax Max. Possible Draft Friction causes Rolling If Friction=0, then draft=0, means NO ROLLING Radius of the roll Friction coefficient handout 8 b

The pressure varies along the contact length Condition to roll- Power to drive the roll and work piece Roll Force (F) Integrating “unit roll pressure” over roll work “contact area” The pressure varies along the contact length handout 8 b

N: rotation speed of the roll, rev / min Contact length Contact force Torque N: rotation speed of the roll, rev / min Power Power is a function of D. Increase of D leads to increase of P handout 8 b

Condition to roll- Power to drive the roll and work piece When the required power (d) is greater than the supplied power, the rolling of a work piece with d is not possible. Therefore, the required power = supplied power will lead to a critical draft d or maximum d. Criterion 1: Criterion 2: required power = supplied power  The actual maximum draft for a rolling system is the smaller one computed from the two criterions above.

Example: A 10-in. –wide, 1.0-in – thick plate is to be reduced in a single pass in a two-high rolling mill to a thickness of 0.8 in. The roll has a radius = 20 in., and its speed = 50 ft/min. The work material has a strength coefficient = 35.000 lb/in.2 and a strain hardening exponent = 0.2. Determine (a) roll force, (b) roll torque, and (c) power required to accomplish this operation. handout 8 b

Given: rolling, t0=1. 0 in. , tf=0. 80 in. , w=10. 0 in. , R=20 in Given: rolling, t0=1.0 in., tf=0.80 in., w=10.0 in., R=20 in., vr=50 ft/min, flow curve n=0.20 and K=35,000 lb/in2. Find: (a) F, (b) T, (c) HP. handout 8 b

N = (50 ft/min)/(2π×20/12) = 4.77 rev/min. Torque T = 0.5(432,149)(2.0) = 432,149 in-lb. N = (50 ft/min)/(2π×20/12) = 4.77 rev/min. Power P=2 π (4.77)(432,149)(2) = 25,929,940 in-lb/min HP = (25,929,940 in-lb/min)/(396,000) = 65.5 hp handout 8 b