Basic Training Tile Laying System MUREXIN AG / Michael Maier

Slides:

Advertisements

Similar presentations

DECORATIVE SINGLE COAT PLASTER FOR MARBLE CHIPS CLADDING SYSTEM ( PEBBLEDASH )

Advertisements

Arma-Chek R Covering Systems STANDARD FEF PRODUCTS.

Flexographic Tapes 3M Industrial Business 3 3M™ Cushion-Mount™ Plus Tapes with Easy Mount Adhesive.

Solar Bake Off. PROCEDURE 1.1 st person traces a flap in the top of the box. Use the ruler and marker to measure a 1½” border around the lid, on the.

Cutting Edge Solutions Using Advanced Self Leveling Materials ICRI National Convention April 14, 2010.

Method to fix wall tiles. Preparation All wall tiles to be immersed in water for 3-4 hours for better results. Some gap in between the rows to allow the.

Grouting Ceramic Tile This step comes after the tile is installed and has had time to cure. It is very important to either follow the instructions listed.

Industrial Flooring Systems

Industrial Floor Systems

Example of a successful lining Description: Tuff Stuff is sprayed as a protective lining onto a boat hull. The lining with TS provides a high level of.

Corrosion Control. ™ Drylar™ * Daclar™ * Vezlar™ * Zavlar™ * Voxlar™ * Nular ™

COATINGS FOR STEEL & CONCRETE

Construction 1Sika.pot Seal and Coating Innovative Systems with Sika ® Liquid Plastics.

Protactinium 台灣拓鏷化工 PD-660.  Oriental Star insulation paints are compounded of polymeric resins and inorganic insulating powders, which features.

Product Range  Epoxy Flooring & Coatings Epoxy Flooring & Coatings  Waterproofing Compounds Waterproofing Compounds  Grouts Grouts  Admixtures Admixtures.

BondChem TECHNICAL DATA Roll-a-crete ( Three Component Cementitious Waterproof Coating ) Page 1 / 2. DESCRIPTION BondChem’s Roll-a-crete is a three component.

TEAM: FIBREX Waterproofing Coating. Introduction  The ASTM Standard defines it is a treatment of a surface to prevent the passage of water under hydrostatic.

LiquiGard ™ Firestone Building Products. LiquiGard ™ About Firestone LiquiGard™ is a tough, liquid applied, two-part polyurethane adhesive. It forms a.

Water Proof for Coaxial Cable Termination 1/2 Shield packing for cable fixing ( effectively depend with cable size ) Shield packing for cable fixing. The.

Training begins in… 15:00 minutes Training begins in… 14:00 minutes.

RENAISSANC E CARPET TILES_.  INTRODUCTION_  BENEFITS_  SUGGESTED SPECIFICATION_  INSTALLATION INSTRUCTIONS_  MAINTENANCE PROCEDURES_  TECHNICAL.

Cortec Snow Plow Preservation Program. End Of Season Rust Removal VPCI 422/423 Citrus based rust remover  Environmentally friendly rust remover available.

appseal ® STP Acrylic based elastomeric strip Areas of application: (A) Over Construction joints. (B) Over Expansion joints. 1.

1 RPM/Belgium N.V. - Version MONOPUR GB MONOPUR ® INDUSTRY The heavy duty polyurethane concrete floor system for extreme service conditions.

IIlmod Trioplex Self-expanding installation seal.

Basic Slide Show Under Tile Spooled Heating Installation Guide.

It is known to everyone that development of motor road network in any country reflects the potential of the country's general economic development. In.

Mirror Manufacturing Production from glass to mirror.

NATURAL TOUCH 2014 PROJECT Industrial II. Ceramic –Anticorrosive Coating BBN NATURAL TOUCH.

Er. Hiralal Agrawal EXECUTIVE ENGINEER.. Apparatus:  Concrete cube moulds of 15 cm size in required numbers.  Standard tamping bar (steel) of 16mm diameter.

HOMOGENEOUS VINYL TILES FLOORFLEX. INTRODUCTION  Homogeneous vinyl flooring has a uniform structure and composition from the top to the bottom as there.

1 Day Product Training Course. How to choose a Tile Adhesive or Grout Type of tile Substrate Service Condition.

2010 Product Awareness Floor Tiling. Weber.set rapid plus Uses: For fixing ceramic, porcelain and natural stone tiles Walls and floors Interior and exterior.

Substrate Identification Floors. Principal Substrates T & G floorboards Flooring grade boards Concrete Screeded concrete Tile Backer Boards Under Floor/Under.

2010 Product Awareness Wall Tiling. Weber.fix Uses Interior walls Suitable for use in dry and lightly wet areas Features and benefits Non slip Low colour.

Substrate Identification Wall Tiling. Principal Wall Substrates Cement/sand rendering Gypsum plaster Plasterboard Existing tiling Timber based boards.

UniBond™ ST Polyester-Faced Adhesive Tape

Roof Insulation Adhesives: Garland’s Insul-Lock® II, Insul-Lock HR & Insul-Lock E HR Systems

ANTICORROSION COATINGS

Weber Tile Fixing.

Beyem Fir White Enhanced cement based tile adhesive for interior use

Performance of insulation foams over time

SUPERFLEX HOMOGENEOUS VINYL TILES & SHEETING.

High Density Polyethylene (HDPE) Panels or Sheets

NANOSILICATES AND POLYMER COMPOUNDS BASED ON THEM

INDUSTRIAL FLOOR HOMOGENEOUS VINYL SHEETING.

VINYL TILES & SHEETING_

Liquid Flashing: Garland’s Tuff-Flash™ System

Corrosion Control.

FLOORWORX SD STATIC CONTROL TILES & SHEETING.

Fiberglass-Reinforced Sheet Flooring Installation System

MORTER-PRIMER (Bituminous Primer).

DAMP-PROOFING AND WATER-PROOFING COURSE

FLOOR COATINGS TRAINING GUIDE

Asbestos and Hazardous Material Abatement Procurements

Acczent Unik Installation Instructions

Installation Instructions Acczent Classic 40, Meteor 70,

Fiberglass-Reinforced Sheet Flooring Installation System

ProtectWALL: 1,5 mm & 2 CR Installation Instructions

Tapiflex Self-adhesive

Introduction to Weber Tile Fixing Products.

MSS03/025 Aluminiumbutyl Sandwich, self-adhesive 1.6

Product Model Foil Tape

Direct Bond – Dry Lining to Masonry Backgrounds

Application Issues & Solutions

PLASTERBOARD CATEGORY

BARRY ESPOSITO GREENVILLE SC

Presentation transcript:

Basic Training Tile Laying System MUREXIN AG / Michael Maier Version: Oktober 2007

Tile Laying System Preparation

TLS - Preparation Penetrating Primer LF for absorbent substrates ready-to-use one component solvent free Consumption: appr. 0,15 kg/m² Delivery units: 1 and 5 kg Drying time: approx 30 minutes Application: with brush, roller

TLS - Preparation Penetrating Primer LF 1 – Application:

TLS - Preparation Penetrating Primer LF 1 – Application:

TLS - Preparation Penetrating Primer LF 1 – Pull off strength: without Penetrating Primer LF 0,45 N/mm² with Penetrating Primer LF 1,15 N/mm²

TLS - Preparation Sealing Compounds for indoor and outdoor use for indoor use Liquid Sealing Compound 1KS Liquid Sealing Compound 2 KS Sealing Compound DF 2K Profi Sealing Compound PD1K

TLS - Preparation Liquid Sealing Compound 1 KS seam- and jointless sealing compound protect against pressureless water Solvent free one component only for indoor use Consumption: appr. 1,5 kg/m²/mm Delivery units: 7, 14 u. 25 kg Application: roller, trowel, Drying time between 1st and 2nd layer: 1 hour Drying time between 2nd layer and tiling: appr. 3 hours

TLS - Preparation Sealing Compounds – System components Sealing Collars DZ 35 / DZ 70 Sealing Tape DB 70 10 and 50 lfm per roll Sealing Corners

Tile Laying System Application

Application Liquid Sealing Compound – Application: Penetrating Primer LF 1 (drying time approx 30 minutes)

Application Liquid Sealing Compound – Application: 1st step Fix the Sealing Ribbon DB 70 in the corners Apply liquid sealing compound 1 KS with roller or trowel only in the corner (with approx 10 cm) and fix the sealing tape into the fresh insulation. Same process with the sealing collars

Application Liquid Sealing Compound – Application: Liquid Sealing Compound 1 KS Application with roller

Application Liquid Sealing Compound – Application: Liquid Sealing Compound 1 KS

Application Liquid Sealing Compound – Application:

Application Liquid Sealing Compound – Application:

Application Liquid Sealing Compound – Application:

Timetable Product applying with Penetrating primer LF 1 roller, prush Drying time approx 30 minutes 1st layer liquid sealing compound 1 KS roller, trowel, Drying time approx 1 hour 2nd layer liquid sealing compound 1 KS roller, trowel, Drying time approx 3 hours Tiling with Flex Tile Adhesive f. e. Murexin Flex tile adhesive KGF 65, C2 TE, s1