B. H. GARDI COLLEGE OF ENGG. & TECH. ANALOG ELECTRONICS

Slides:

Advertisements

Similar presentations

555 Timer 555 Timer Digital Electronics TM 1.2 Introduction to Analog

Advertisements

Welcome To All The Teacher’s of SMIT.

Multivibrators and the 555 Timer

Multivibrators and the 555 Timer

555 Timer ©Paul Godin Updated February Oscillators ◊We have looked at simple oscillator designs using an inverter, and had a brief look at crystal.

Chapter 6 (Oscillators)

Section 24.4 The 555 Timer. 2 Rectangular Waves - Reminder: Duty Cycle – ratio of pulse width to cycle time where PW = the pulse width of the circuit.

EE311: Junior EE Lab 555 Timer J. Carroll 8/26/03.

Part A: Controlling Oscillation Frequency with Capacitors and Resistors Part B: Diodes and Light Experiment Timer.

Electronic Instrumentation 1 Experiment 7 Digital Logic Devices and the 555 Timer Part A: Basic Logic Gates Part B: Flip Flops Part C: Counters Part D:

Astable multivibrators I

The All IC’s are usually set up in a DIL (Dual In Line) configuration, this is where there are two sets of parallel connections (the pins). As you can.

WATER LEVEL CONTROLLER USING 555 TIMER

As an Astable Multivibrator 1. 2  An integrated chip that is used in a wide variety of circuits to generate square wave and triangular shaped single.

Clock Generation 1/16/12.

EET 1131 Unit 13 Multivibrators and the 555 Timer

M.S.P.V.L. Polytechnic College, Pavoorchatram

As an Astable Multivibrator.  An integrated chip that is used in a wide variety of circuits to generate square wave and triangular shaped single and.

Lecture 4: Timing circuits Creating Signals & Controls.

Electronic Metronome Using a 555 Timer.

555 Timer ©Paul Godin Updated February Oscillators ◊We have looked at simple oscillator designs using an inverter, and had a brief look at crystal.

The 555 as an Astable Multivibrator. Inside look at a 555 Integrated Circuit Timer.

Astable Multivibrator

PHY 202 (Blum)1 Analog-to-Digital Converter and Multi-vibrators.

PHY 202 (Blum)1 Analog-to-Digital Converter and Multi-vibrators.

Electronic Components. Battery A portable power source that has a positive and negative. Electronics works on Direct Current (DC) where electrons flow.

PWM Circuit Based on the 555 Timer. Introduction In applications LED Brightness Control we may want to vary voltage given to it. Most often we use a variable.

Basic Operation of a 555 Timer Threshold Control Voltage Trigger Discharge Reset Output.

1 13. Pulsed waveforms and Timing Circuit Design 13.1Op. Amp. Pulse GeneratorsOp. Amp. Pulse Generators timer IC Oscillator555 timer IC Oscillator.

Students should be able to :

Monostable Multivibrator

Electronic Piano G H Patel College of Engineering & Technology G H Patel College of Engineering & Technology Prepared by Sanjay Hadiyal ( )

GROUP MEMBERS:- PRITAM,BHAVESH,VRAJ SUBMITTED TO:- HITENDRA JOSHI.

NON LINEAR IC APPLICATION USING OP AMP NAME:- ROLL NO. ROHAN V. KHRISTI 14ELEE310 AFJAL A. RATHOD 14ELEE311 NIKUNJ K. PARMAR 14ELEE312 SUB :- ANALOG ELECTRONIC.

HIGH VOLTAGE DC BY MARX GENERATOR PRINCIPLES

TITLE: 555 Timer OM INSTITUTE OF TECHNOLOGY Subject: Analog Electronics ( ) Semester: 03 Prepared By:

Electronics Technology Fundamentals Chapter 24 Switching Circuits.

1 Transistor. 2 Transistors are used to turn components on and off They come in all different shapes and sizes.

7/20/2016 Subject Name: LINEAR IC’s AND APPLICATIONS Subject Code:10EC46 Prepared By: Aparna.P Department: Electronics and Communication Date:

It is an electronic switch that enables us to control a circuit by simply touching, and the switch automatically turns off a short time later.As.

RELAX AND ENJOY THE PRESENTATION TOGETHER OBJECTIVES Students should be able to draw the circuit of a monostable multivibrator using IC 555 explain the.

Center tap Full-Wave Rectifier.

DR. S. & S. S. GANDHY COLLEGE OF ENGINEERING AND TECHNOLOGY

Clock Signals: 555 Timer 555 Timer Digital Electronics TM

Key Stage ic Using a (555 IC) as a Monostable / Astable Circuit 555 IC Live Wire / PCB Wizard - (555 IC) Circuit RA Moffatt.

TOPIC:PWM LED DIMMER/BRIGHTNESS CONTROL BY 555 TIMER

MARX GENERATOR BASED HIGH VOLTAGE USING MOSFETs

Visit for more Learning Resources

TV OPERATION JAMMING SYSTEM

To Design and Implement Astable Multivibrator Circuit Using IC555

To Design and Implement Monostable Multivibrator Circuit Using IC555

UNIT-IV Application of Special I.C’s.

(EVENING ON TO MORNING OFF)

555 Timer EEE DEPARTMENT KUMPAVAT HARPAL( )

Integrated Circuits.

SNS COLLEGE OF TECHNOLOGY COIMBATORE -35

SUN SET TO SUN RISE LIGHTING SWITCH (EVENING ON TO MORNING OFF)

Project: security lock system

Principles & Applications

555 Timer Integrated Circuit.

Unit IV 555 Timer.

555 Timer 555 Timer Digital Electronics TM 1.2 Introduction to Analog

EET 1131 Unit 13 Multivibrators and the 555 Timer

ELEC207 Linear Integrated Circuits

Engineering Electronics I

555 Timer 555 Timer Digital Electronics TM 1.2 Introduction to Analog

Multi-vibrators

Mark Bristow CENBD 452 Fall 2002

Presentation transcript:

B. H. GARDI COLLEGE OF ENGG. & TECH. ANALOG ELECTRONICS DIGITAL CONTROLLED DC MOTOR GUIDED BY: PREPARED BY: PROF. SHVETAL PANDYA PARTH VAGHELA PROF. JAYDEV JADEJA (13EE042) PROF. RAKESH OZA DHAVAL JOSHI (13EE024)

we need two Ics to make this type of circuit , which is, 555 timer IC MOSFET

555 TIMER IC One of the most versatile linear integrated circuits is 555 timer. Signetics corporation first introduced this device as SE/NE 555 in early 1970. A sample of these applications includes monostable and astable multivibrator.

PIN DIAGRAM OF 555 TIMER

ASTABLE OPERATION 555 timer as astable multivibrator

OPERATION : As shown in figure 555 timer connected as astable multivibrator. Initially when the output is high,capacitor C starts charging towards Vcc through Ra and Rb . However as soon as voltage across the capacitor equals 2/3 Vcc, comparator 1 triggers the flip-flop,and output switches low.

Now capacitor C starts discharging through Rb and transistor Q1. When voltage across C equals 1/3 Vcc,comparator 2’s triggers the flip-flop,and the output goes high. Then cycle repeats.

The output voltage and capacitor voltage waveforms are shown in figure ,

As shown in this figure, the capacitor is periodically charged and discharged between 2/3 Vcc and 1/3 Vcc,respectively. The time during which capacitor charges from 1/3 Vcc to 2/3 Vcc is equal to the time the output is high and is given by Tc=0.69(Ra+Rb) ……(1)

Where Ra and Rb are in ohms and C is in farads Where Ra and Rb are in ohms and C is in farads. Similarly,the time during which the capacitor dischrged from 2/3 Vcc and 1/3 Vcc is eqal to the time the output is low and is given by Td=0.69(Rb)C ……(2) Where Rb is in ohms and C in farads. Thus total period of the output waveform is T=Tc +Td =0.69(Ra+2Rb)C ……(3)

The duty cycle of square wave is 50% The duty cycle of square wave is 50%. This means that,acording to eqation (5) the astable multivibrator will not produce sqare-wave output unless the resistance Ra=0Ω. However, there is a danger in shorting resistance Ra to zero. With Ra=0Ω, terminal 7 is connected directly to +Vcc.

When the capacitor discharges through Rb and Q1 (pin 7),an extra current is supplied to Q1 by Vcc through ashort between terminal 7 and +Vcc,which may damage Q1 and hence the timer.

ASTABLE MULTIVIBRATOR

ASTABLE MULTIVIBRATOR OUTPUT

MOSFET In this circuit it works as motor driver. We connect it’s three terminal as below, Output of astable multivibrator connected to GATE terminal of MOSFET. Also one resistor of 1kΩ is connected between GATE terminal and ground.

SOURCE terminal of MOSFET is connected to ground SOURCE terminal of MOSFET is connected to ground. Motor is conected between DRAIN terminal of MOSFET and 12V supply.

Digital Controlled DC Motor

We have connected Rb as 1M potentiometer ,so by changing value of resistor we can control the speed of motor . We can also use potentiometer in place of Ra. So by changing value of potentiometer we can control the dc motoer.

Thank you