The Hardware keep away from water! Holding the Vernier interface upright, the sensor interface ports are on top, a few USB ports are on one side, and the to-computer port is on the bottom. Don’t force a plug into the wrong port! Connect the interface cord to the computer, and a temp sensor to the interface. to sensor to computer
The Software Go to: Finder -> Applications -> Logger Lite -> application On the top menu bar ‘Experiment’ is where you can set the measurement parameters (trial time, intervals), start a trial run, & save & clear data Run a short trial and alternate between measuring room air temperature and your skin temp. When the trial is complete, test out the features under the ‘Analyze’ tab on the menu bar. More features under the other tabs, check ‘em out.