Filter Istallation in Cineblaster

The filter paper received looks like below.

Cut the filter into 3 parts as shown in the next slide. One part of size 9 inches X 5 inches for the section below hard disk. Two parts of size each 17 inches X 5 inches for the side panels of the CB.

To glue the filters to the base we have 2 “Self adhesive hook & look fastening tapes”(also called as Velcro) One is of smooth surface and the other is of rough surface. Ensure that if smooth surface is on the filter then the rough surface should be on the base, otherwise the filter won’t get glued to the base.

Cut the filter paper into 3 parts as below 9 inches x 5 inches 17 inches x 5 inches

This is the part below hard disk where filter is to be installed This is the part below hard disk where filter is to be installed . Stick the base with the rough surface of the sticker.

Stick the Filter border with the smooth surface of the sticker Stick the Filter border with the smooth surface of the sticker. Now stick the filter on the base(with rough surface tape), so that the filter is attached properly on the base and it can also be removable.

This is the part at the sides of CB where filter is to be installed This is the part at the sides of CB where filter is to be installed . Stick the base with the rough surface of the sticker.

Stick the Filter border with the smooth surface of the sticker Stick the Filter border with the smooth surface of the sticker. Now stick the filter on the base(with rough surface tape), so that the filter is attached properly on the base and it can also be removable.