Table 2. Physical properties of Portland cement

Slides:

Advertisements

Similar presentations

and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1

Advertisements

Table 4. Mechanical properties of repair and substrate concrete

Percentage of Polyethylene

Properties Test results

© The Author(s) Published by Science and Education Publishing.

Biological (Effect on Pulp)

Research, 2015, Vol. 3, No. 6, doi: /education

© The Author(s) Published by Science and Education Publishing.

Table 5. Properties of The Tested Soil

Tensile strength (MPa) Length (m) of fibers/kg

Tensile Strength (MPa)

SON Nurse Practitioner Blackboard Community

Tensile Test after Firing

Rigidity Modulus (Gpa)

© The Author(s) Published by Science and Education Publishing.

Marshall characteristics

© The Author(s) Published by Science and Education Publishing.

Table 3. Descriptive Statistics – All Banks

Table 1. Chemical composition of materials

© The Author(s) Published by Science and Education Publishing.

Acrylic Type SOV SS df MS F–value p–value

Table 2. Student's t–test (Tensile Strength)

Table 4. Percentage of post-harvest waste reported by the farmers

© The Author(s) Published by Science and Education Publishing.

Table 6. Control sample industry distribution

Total CO2 Emissions (Electricity + Fossil Fuel)

© The Author(s) Published by Science and Education Publishing.

Table 2. Waste characterization in Port Harcourt, Source [1]

Rating of Water Quality

Inscribed circle diameter

© The Author(s) Published by Science and Education Publishing.

Table 3. The needed requirements of the Concrete Sustainability

Number of categories that are mentioned (0% < categories < 5%)

Table 1. Geometric properties of steel tubes used

Table 1. Characteristics (age, height, and weight) of the participants

Table 2. Modal parameters estimated by Pulse Reflex®

Table 1. The most important aspect applied in MIVES

No. Of units of single building Rated power (W) of unit load

Table 5. Pvalues of ttests for direction a

Entrapment Efficiency (%) ± S.D.

Interpass temperature

Table 1. Population by University

Table 3. Main properties of the thin brass electrode

Table 5. Maximum stress, strain and deformation values

Insulation, kWh/m²/day

© The Author(s) Published by Science and Education Publishing.

Order cycle in which item n has to be sent

Simulation Frequency(Hz)

Financial Development

Number of questionnaires sent out

© The Author(s) Published by Science and Education Publishing.

Table 6. Pvalues of ttests for direction b

Table 1. Descriptive Statistics

Table 2. Regression statistics for direction a

Table 3. Regression statistics for direction b

Average Hardness value (HRC)

Table 3. List of PT specimens

Table 6. Percentages of Indicators

Table 4. Surface roughness (outer faces)

Table 3. Correlation of PC, MC, RC & IC at the Supervisory level

Much more than it should

Table 1. Project Control Factors and their hierarchy

Category Quantity Secondary school 3 Student participant

Cashew juice stored for 30 days

© The Author(s) Published by Science and Education Publishing.

Table 3. Surface roughness (inner faces)

Compressive Strength difference at 1 week (MPa)

© The Author(s) Published by Science and Education Publishing.

Sum of Square df Mean Square F Sig Health Between Groups

Power per unit land or water area

Presentation transcript:

Table 2. Physical properties of Portland cement Test result Specific surface area (Blain) cm2/g 290 Initial setting (Vicat Method) min. 92 Final setting (Vicat Method) hr. 3:30 Compressive strength (MPa) 3-days 16.5 7-days 25.7 Sarmed Fadhil et al. The Production of Economical Precast Concrete Panels Reinforced by Waste Plastic Fibers. American Journal of Civil Engineering and Architecture, 2015, Vol. 3, No. 3, 80-85. doi:10.12691/ajcea-3-3-4 © The Author(s) 2015. Published by Science and Education Publishing.