HENRY ANDRES ROMAN BOLIVAR HOW TO CLEAN THE KEYBOARD?

Method April 1: clean 1. Turn off the computer and disconnect the keyboard before any cleaning procedure. Do not remove or connect a keyboard while the computer is on. If you do, you could damage the machine if your keyboard has no USB connection. If your keyboard has USB connection, then it is safe to disconnect while the computer is on.

2. For a quick clean with the keyboard upside down and use a can of compressed air to remove any foreign matter. Be sure to do this in a place where they can clean up the trash that falls easily. Put the keyboard upside down and check air several times, you should see how it falls a little dirt. Change the angle and give a pat to make out most dirt.

3. Clean the sides of the keys with a cotton swab soaked in isopropyl alcohol.

4. For a more thorough cleaning, remove all keys 4. For a more thorough cleaning, remove all keys. Do this by prying up each key with a small screwdriver or something similar. When the keys have been removed, blow any dirt with compressed air. With a damp (but not wet), gently clean all surfaces. Do not let any kind of fluid in contact with the keyboard.

5. Clean the individual keys and place them back on the keyboard.

second method

1. Turn off the computer and disconnect the keyboard.

2. Turn the keyboard it and remove all screws.

4. Lift the top of the keyboard (the one with the keys) and place the bottom half aside. You may have some clips, also checks for hidden screws under the labels.

4. Flip the top of the keyboard so you can see the back of the keys, press the tab of each key to remove the space bar will have a metal bar, which can be very tedious to reassemble, but not impossible.

5. Fill a bowl with hot water and soap (liquid dish detergent works well).

6. Put the keys in the bowl and rub with a brush.

7. Remove the keys and let them dry or scales with a hairdryer.

8. Place the empty side of the keyboard into the bowl and rub until clean.

9. Once everything is dry, gun again the keyboard.

10. Board the two halves of the keyboard and pressing firmly wings, if you forget to put the screws in between the keys will not reach the circuits and will not work ..

11. Connect your keyboard, turn on your computer and enjoy!