INTRODUCING ICUBE™

Part Numbers DDFM Distribution Models G37-394 - DDFM = ICUBE™ for DTAV40 retrofit G36-635 - DDT40 = ALL-IN-ONE ICUBE™ + DTAV40, assembled together with 1-sensor accessory and cover plate G37-395 - 178GR10K-1 = Additional Separate Sensor Assembly For Multiple Evaporator Applications: 10'-Thermister Sensor, 6'-Input Wire, 3/8” Tube-Clip, Wire Nuts and Cover Plate DDT40 178GR10K-1

Grässlin Defrost ICUBE™ Module Helps customers achieve higher AWEF Low cost solution Simple integration    AWEF = Annual Walk in Energy Factor (BTU/W-H)

Factory or Field Installable Transforms typical Defrost timer to Adaptive Defrost Tiimer Remove FM Timer from DTAV40 ADD ICUBE™ Sensing Module (sensor included) Use Same DT Relay board Simply install the module underneath the existing DTAV40 timer and run the sensing wire to the evaporator coils

Timer integration ICUBE™ Module simply fits underneath FM timer module Plastic tab isolates sensing wire from PCB

Diagnostics & Sensor(s) LED Indicator for status and fault conditions. BLUE LED = Efficiency Mode Quick connect Temperature Sensor Included: 6'-Input Wire 10'-Thermister Sensor 3/8” Tube-Clip Wire Nuts (Order additional sensor(s), up to 4/module for Multiple Evaporator Applications)

Add Temperature Sensor(s) to Coil Remote condensing unit

Recommended (not required) Thermistor Probe position Recommended (not required) Thermistor Probe position. The Probe should be fastened wherever frost accumulates most quickly. This is generally 1” to 2” from either end, at the bottom ¼, and on the discharge end of the evaporator coil. If there is uncertainty about where frost accumulates the fastest, put the system into a manual Defrost and monitor the last area of the evaporator where frost is present prior to a completely frost free coil.

Expandability Up to 4 Evaporators 40 Sensor Wire Demand Defrost timer

Available NOW! on Intermatic.com Energy Calculator Remote Energy Savings Tool Provides End User with energy savings perspective Compatible with Tablets and Smart phones Available NOW! on Intermatic.com http://www.intermatic.com/en/icubecalculator

PRICING & INITIAL STOCK ORDER Distribution Models 6 - DDFM - ICUBE™ for DTAV40 3 - DDT40 - ICUBE™ + DTAV40 assembled together with 1-sensor accessory and cover plate 3 - 178GR10K-1 = Additional Separate Sensor Assembly For Multiple Evaporator Applications: 10'-Thermister Sensor, 6'-Input Wire, 3/8” Tube-Clip, Wire Nuts and Cover Plate DDFM $ /each $ /each DDT40 178GR10K-1 $ /each

THANK YOU ICUBE™